New Construction of Village Haryana to Meerpur Road

Construction of Subgrade and earthen shoulders with apporved material obtained from borrow pits with attl ifts and leads transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300.2 with a lead upto 1000 m as per Tecnical Specification Clause 303.1 including all taxes but excluding GST.

Brick masonry work in cement mortar in foundation complete excepting pointing and plastering, as per drawing and technical specification Clauses 600, 1202 & 1203 including all taxes but excluding GST.

Pointing with cement mortar (1:3) on brick work, as per drawing and technical specification Clauses 613.3 and 1204 including all taxes but excluding GST.

Providing & fixing of Km Stone including cost of all material but excluding GST.

Providing & fixing of Hec. Stone including cost of all material but excluding GST.

Supply, Laying and Fixing NP-3 Hume pipe of 350 mm dia meter section but including cost of all material, labour, T&P labour, cess, royalty & all taxes etc but excluding GST.

Supply, Laying and Fixing NP-3 Hume pipe of 600 mm dia meter section but including cost of all material, labour, T&P labour, cess, royalty & all taxes etc but excluding GST.

Construction of granular sub-base by providing well graded material, spreading in uniform layers with motor grader/ tractor mounted appropriate equipment on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with smooth MORD Specifications 401 including all taxes but excluding GST.

Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 kN in stages to proper grade and camber, a MORD Specifications 405.3 including all taxes but excluding GST.

Construction of un-reinforced plain cement concrete pavement, thickness as per design over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M 30 Grade coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side frame work (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including leveling the framework as per drawing), spreading the concrete with shovels, rakes compacted using needle, screed and plate vibrators and finished in continious operation including provision of contraction and expansion, construction joints by providing 12mm thick dura board at the specified spacing, applying debonding strips primer, with MS dowel bar sealant near approaches to bridge/culvert and construction joints admixtures as approved, curing of concrete slabs for 14-days and water finishing to lines and grade as per drawing and Technical Specification Clause 1501 but including cost of polythene sheet including all taxes but excluding GST.