Supply and Installation of LAN and Wifi access points at KHRI, Kariyavattom Thiruvananthapuram

Amount

Supply and installation of L3 Fully managed 24 Port switch having 12x10Gigabit Ethernet 10GBase-T copper port, 12x10GigaBit Ethernet SFP+(Dedicated) Port, 1x Gigabit Ethernet Management port, Configuration of Layer 3 interface on physical port, Support for up to 4,094 active VLANs simultaneously, Standared Rj -45 console port, Type -A USB slot on the front panel, Speed: 1.3 GHz CPU speed, 512 MB memory, Flash memory 256MB, Switcing capacity 480Gbps or better. Configuration of VLAN as per department requirement. Including cables for inter connecting existing core switch for redundancy. Warranty: 3 Year Peferred Make: Cisco, Netgear, Allied Telesis, Juniper, Brocade, HP, or equivalent

Supply and Installation of Layer 2 Manageable 28 port Ethernet Switch which having 24 x 10/100/1000 Mbps + 4 x Gigabit SFP (2 combo) ports, web manageable supporting ipv6 having 256 MB flash memory, switching capacity≥20 Gbps,AC 120/230V. Warranty: 3 Year Preferred Make: Allied Telesis, Brocade, Cisco, HP, Juniper or equivalent

Supply and fixing 24 port Enhanced CAT-6 fully loaded Modular type Patch Panel as per EIA/TIA-TSB 40A specification for interconnecting servers and clients, including termination charges. Preferred Make: Actassi, Belden, R&M, Molex or equivalent

Supply, Installation and Testing of controller managed Access Point with 2.4 GHz (575Mbps max rate) with 2x2 MIMO and 5-GHz (4.8Gbps max rate) radios with 4x4 MIMO, 4 integrated Omni directional down Tilt Antennas. AP type : indoor, dual radio, 5GHz 802.11ax 4x4 MIMO and 2.4GHz 802.11ax 2x2 MIMO, Support for up to 256 associated client devices per radio and up to 16 BSSIDs per radio, Supported radio technologies: 802.11b: Direct-sequence spread-spectrum (DSSS) 802.11a/g/n/ac: Orthogonal frequency-division multiplexing (OFDM), - 802.11ax: Orthogonal frequency-division multiple access, Transmit power: Configurable in increments of 0.5 dBm, RJ-45 port with maximum speed 2.5Gbps, USB 2.0 host interface, Power : Direct DC source: 12 Vdc nominal, +/- 5% or Power over Ethernet (PoE), Suitable mounting bracket /kits for keeping the Access point and including all the other connecting accessories. Three year warranty etc. Preferred Make : HP- ARUBA, CISCO or equivalent.

Supply and Installation of 10/100/1000 PoE+ injector for the above wifi access points. Preferred Make: Cisco,Ubiquiti, Netgear or equivalent

Supply and Installation of IG Single Mode Duplex SFP module. Preferred Make: Cisco, Belden, Brocade, Aruba or equivalent

Supply and Installation of 19" 6 port rack mountable 1U size complete Steel housing fully powder coated Light Interface Unit (LIU) with required number of SC connectors having FR grade Nylon Cable grommets, ABS Splice Trays with fully cushioned splice holder containing grooves for fixing splice protection sleeves, Cable Spools made upof flame retardant plastic, high impact resistance, stackable design for providing sufficient room for storage of excess cables, Blanking plates, etc. Including splicing charges. Preferred make: Commscope, Molex, R&M, Sterlite, AFL Hyperscale or equivalent.

Supply and Installation of 19" 24 port rack mountable 1U size complete Steel housing fully powder coated Light Interface Unit (LIU) with required number of SC connectors having FR grade Nylon Cable grommets, ABS Splice Trays with fully cushioned splice holder containing grooves for fixing splice protection sleeves, Cable Spools made upof flame retardant plastic, high impact resistance, stackable design for providing sufficient room for storage of excess cables, Blanking plates, etc. Including splicing charges. Preferred make: Commscope, Molex, R&M, Sterlite, AFL Hyperscale or equivalent.

Supply & providing SC-LC Duplex patch cord 1 mtr. Preferred Make: Commscope, Molex, R&M or equivalent

Supply and fixing CAT-6 Information Outlet for 1000Mbps with spring shutter / dust cover face plate + Single RJ45 Jack + SMB including termination charges etc. Preferred Make: Actassi, Belden, R&M, Molex or equivalent.

Supply and Installation of CAT-6 Information Outlet for 1000Mbps having spring shutter / dust cover dual face plate + SMB + 2 numbers of RJ45 keystone Jack including termination charges etc. Preferred Make: Actassi, Belden, Molex, R&M or equivalent

Supply and Installation of 6 Core single mode Low Water Peak Outside plant (OSP) OFC having LSZH sheath, conforming to ITU-T G.655, IEC 60794-1 : 2001, IS 13882 (Part 1/Sec 1) : 1999 etc. Preferred Make: Commscope, Molex, R&M, Sterlite or equivalent.

Supply, laying, certification and documentation of CAT-6 UTP cable 23 AWG through the existing conduit and cassing and capping as required. Preferred Make: Actassi, Belden, R&M, Molex or equivalent

Supply and providing 3Mtr CAT-6 Giga UTP patch cord. Preferred Make: Actassi, Belden, R&M, Molex or equivalent

Supply & providing 1Mtr CAT-6 Giga UTP patch cord. Preferred Make: Actassi, Belden, R&M, Molex or equivalent

Supply and fixing of 25mm medium PVC ivory conduit/ oval conduit/ casing-n-caping with special confirming to ISI standard on surface/recess using suitable size fixtures spacing not exceeding 50cm including cutting the wall and making good the same in case of recessed conduit, colour washing etc as required Preferred Make: TOMS, BALCO, Espee or equivalent

Supply and fixing of 20mm medium PVC ivory conduit/ oval conduit/ casing-n-caping with special confirming to ISI standard on surface/recess using suitable size fixtures spacing not exceeding 50cm including cutting the wall and making good the same in case of recessed conduit, colour washing etc as required Preferred Make: TOMS, BALCO, Espee or equivalent

Supply and fixing≥100mm x≥50 mm PVC Cable Management System with base and lid along with the following accessories conforming to IEC 61084/ BS 476 & 4678 on surface / recess including cutting the wall and making good the damages in case of recessed installation as required. Accessories including Cable Divider, External Angle 90°, Flat Angle 90°/TEE, Internal Angle 90°, Internal Coupler, Flat cross, End Cap, Flanged Coupler, Joint cover, Cable Retainer, Wall plate for internal angle etc. Preferred Make: OBO, MK, Legrand or equivalent

Supply and fixing 50 x 50 mm PVC Cable Management System with base and lid along with the following accessories conforming to IEC 61084/ BS 476 & 4678 on surface / recess including cutting the wall and making good the damages in case of recessed installation as required. Accessories including External Angle 90°, Flat Angle 90°/TEE, Internal Angle 90°, Internal Coupler, Flat cross, End Cap, Flanged Coupler, Joint cover, Cable Retainer, Wall plate for internal angle etc. Preferred Make: OBO, MK, Legrand or equivalent

Supply,Installation Testing and Commissioning of 1KVA Line Interactive UPS with 30mnts battery back up on full load suitable for keeping in the rack. Warranty 3 year for UPS and 2 Year for battery. Preferred Make: V Guard, APC, Eaton, Emerson or equivalent

Supply and Installation of Electrical Accessories(Power Plug, Switches, power cables and Coduits) for giving power to th above system

Supply and fixing 19'' 12U Network Rack with ACDB 6 port with 1U Slotted type Rack Mountable Horizontal Cable Manager Duct etc. Preferred Make: D-Link, HCL, Netrack, President, Valrack or equivalent.