Work of installation of street light on newly constructed road behind BIDA office

Amount

providing and fixing of decorative street light pole. The luminaire poles are made of Mild Steel total height of 8 Meter with double arms and predefined pattern with specified Logo (BIDA) in between the top portion of the pole. Pole upper section of length 5mtr is of outer dia 60mm (3.2 mm thick) and 1.5mtr mid-section of outer dia 140 mm(3.8 mm thick) and 1.5mtr bottom section of outer dia 160 mm(4.2 mm thick) with decorative base plate of 350x350x16mm. This base plate shall be fillet welded to the pole shaft at two locations i.e. from inside and outside. The pole in between laser cut pattern is lit by light. Provision for inside termination box with 4way connector & 1nos 10 AMPS MCB for local isolation. All pole section is welded by certified welders using high and MIG welding process. Service door at bottom part of the pole is equipped with a C clamp with sliding nuts to accommodate a built in connection box. The control gear tray is prewired with MCB, terminal connectors for loop in loop out arrangement. The base plate of the pole is design with elongated foundation holes for fine alignment of the pole during installation. Nano Ceramic surface conversion, resistant to corrosive environment. Pole primarily coated with epoxy resin and top coated with UV stabilized MRF PU PAINT and cured. Pole is complete in all aspects with all accessories including foundation bolt (lenght of foundation bolt should be minimum 750 mm and dia should be min 225 mm). OEM Must have its own in house lab setup for testing facilities for poles. Factory Inspection for testing of decorative street light poles must be done in Government approved OEM's authorised Labs/ outsource from government approved any authorised Lab by departmental Engineer. All as per pre approved by enginner in charge. Agency must ensure to make all necessory permission and arrangements for the visit & no extra payment shall be made for all this procedure.

Providing & Fixing of IK08, IP 66 protected LED decorative down Street Light Luminaire in single piece on existing bracket/pole of 120W. Fitting is made of die cast aluminium closed by diffuser with durable proper silicone rubber gasket. Colour tolerance ,3 SCDM to avoid colour deviation. All the LED to be tested LM80 test method. Light fixture body made of aluminium Alloy, composition having less than 0.4% copper, copper free aluminium for maximum corrosion resistance. Luminaire primarily coated with epoxy resin and top coated with UV stabilized MRF PU PAINT and cured. All exterior parts are made of stainless steel. Silicone rubber gasket for weather protection. Light output of source is more than 110lm/ watt, CRI>70, operating voltage 140-270V, Fitting is IP66, wired with Branded OSRAM or equivalent make LED and Fulham or equivalent constant current driver with efficiency>80%, power factor>0.9, THD<=10%. The CCT of led will be 3000k as required by the project. Proper thermal management for longer life of fixture. Led burning of 50,000 hours. Fitting is IP66 complete in all aspects with all accessories. OEM Must have its own in house lab setup for testing facilities for LED luminaire. Factory Inspection for testing of decorative down LED Street Light Luminaire must be done in Government approved OEM's authorised Labs/ outsource from government approved any authorised Lab by departmental Engineer. All as per pre approved by enginner in charge. Agency must ensure to make all necessory permission and arrangements for the visit & no extra payment shall be made for all this procedure.