Repair Maintenance of 2 HP Submersible Pumpset near CPC Canteen under FTR HQ Tripura

Laying and Jointing PVC Pipe. Heading

Supplying and lowering of 25 mm size HDPE pipe and fixing with existing submersible pump by suitable means inside the existing bore well at site as required.

Supplying and laying of 40 mm dia DWC HDPE pipe ISI marked along with all accessories like socket, bend, couplers etc. conforming to IS 14930, Part II complete with fitting and cutting, jointing etc.direct in ground (75 cm below ground level) including excavation and refilling the trench but excluding sand cushioning and protective covering etc., complete as required.

Providing and fixing of pvc insulated flexible copper 3 core flat sheathed submersible cable of Size 2.5 sqmm i/c bindings, connections etc complete as required. Make Havells/finolex/Standard

Supplying & laying of 2X 16 sqmm XLPE insulated and PVC sheathed Armoured power cable of 1.1 KV grade of following size in the existing RCC/ HUME/ METAL pipe/ Open duct as required. Make Havells/finolex/ Standard/ATC

Providing and fixing single phase submersible motor starter suitable for 2 HP Submersible , in exisiting panel with connection testing and commisioning etc as required or equivalent Schneider/ c&s/Legrand / Crompton

Providing and fixing motor runing Capacitor suitable for 2 HP Submersible , in exisiting panel with connection testing and commisioning etc as required or equivalent Schneider/ c&s/Legrand./Crompton

Supplying and lowering of stainless steel / Brass threaded stepped adopter with existing submersible pump with suitable size nuts & bolts with long nuts and mating with HDPE pipe by heat insertion to make it rigid at site etc. as required.

Providing and fixing 20 mtr 8mm PVC Coated GI support wire along with HDPE pipe for protection of motor etc. as required.

Providing and fixing PVC non retrun valve of approved quality (screwed end ) in the existing pipe etc. as required.

Providing, installation of factory assembled floor mounted type totally closed Control pannel/ feeder pillar for S/Pump set having 400 mm bus bars , fabricated from 2 mm (nominal ) thick M S sheet (with tapered drip proof top) having 50 mm x 50 mm x 6 mm MS angle, 300 mm long pedestal and hinged door of same material shall be provided on the front, with necessary handle,seling matrial, , gasket shall be provided on door complete i/c earth studs, gland plate,paintings and installation with cement concrete foundations (1:3:6) 45 cm below ground level 60 cm above the ground level i/c finishing etc as reqd. ( Minimum Size of One feeder pillar is 600mm x450mm x 300mm and size for second panel is 300mmx300mmx300mm)