SITC of IT Networking and CCTV System at Science Center champawat

Amount

NETWORKING:- Supply & Installation of CAT 6 information outlets complying fully or exceeding with category 6 connecting hardware specifications for all pair combinations up to 250 MHz. Outlets shall use lead frame technology, non PCB pyramid type. (Yellow in Colour for Data) complete in all respect as per technical specification attached.

Supply & Installation of CAT 6 information outlets complying fully or exceeding with category 6 connecting hardware specifications for all pair combinations up to 250 MHz. Outlets shall be use lead frame technology, non PCB pyramid type. (Blue in Colour for Voice) complete as required.

Supply & Installation of Quad Face Plates along with clearly printed labels and holders complete as required.

Supply & Installation of Triplex Face Plates along with clearly printed labels and holders complete as required.

Supply & Installation of Dual Face Plates along with clearly printed labels and holders complete as required.

Supply & Installation of Single Face Plates along with clearly printed labels and holders complete as required.

Supply & Installation of Cat 6 Mounting Cords 1 meter length for the User End & Rack End Connectivity to the System, Both end shall be RJ 45 with snagless boots. (Yellow in colour for Data) complete as required.

Supply & Installation of Cat 6 Mounting Cords 2 meter length for the User End & Rack End Connectivity to the System, Both end shall be RJ 45 with snagless boots. (Yellow in colour for Data) complete as required.

Supplying and drawing of UTP 4pair Cat6 LAN cable in the exisiting surface /recessed Steel/PVC conduit as required. 1 run of cable.

Supply & Installation of Cat 6 Patch Panels for accommodating 24 port teMetreination and shall facilitate cross-connection and inter-connection using modular patch cords and shall confoMetre to EIA standard, 19-inch relay rack mounting requirements. Patch Panel shall come with preloaded infoMetreation outlets of non PCB and pyramid type using lead frame technology.Panel shall have label holders and designation labels as part of the standard device.Shall also come with rear cable management metallic tray with velcro ties complete as required.

Supply & Installation of Cat 6 Mounting Cords 1 meter length for the Patch Panel End Connectivity, Both end shall be RJ 45 with snagless boots complete as required.

Supply & Installation of Cat 6 Mounting Cords 2 meter length for the Patch Panel End Connectivity, Both end shall be RJ 45 with snagless boots complete as required.

Supply & Installation of Horizontal Wire Manager front, 1U panel with metal grooves at the back, plastic snap on cover complete as required.

Supply & installation of Cat3 25 Pair Multi Pair cable complete as required. (From Rack to MDF)

Supply & Installation MDF 100 Pair for voice connectivity complete as required.

Supply & Installation MDF 50 Pair for voice connectivity complete as required.

Supply & Installation of Jumper wire Single pair (305m) complete as required. (From MDF to IDF provided by EPABX vendor)

Supply & Installation of 42 U Closed rack with Front Glass door, rear steel door, castors, 2 fans with fan tray, power strips complete as required.

CCTV :- Supply, installation, testing and commissioning of UL Listed 5MP (Megapixel) CMOS Vandal-proof, Network Dome Camera HD, 1/3” Progressive scan CMOS, [email protected], AGC ON. 0 Lux with IR on, IR cut filter with auto switch, IR range up to 30 mtrs, H.265 / MJPEG, Dual stream, motion detection, Bit rate 32 Kbps-16Mbps, 3D DNR, DWDR, 12 VDC ± 10%, PoE (802.3af) with fixed lens 2.8mm/3.6mm/6mm, size of lens shall be as per site requirement & mockup. ONVIF Profile S supported, connectors complete as required in dome shape fixed type for mounting recessed in false ceiling or Surface Mounted on True Ceiling complete as required. The lens chosen for individual location shall be duly reflected in the Engineering Drawings and shall be approved by the consultant prior to delivery on site. There shall be no additioanl cost if the suitable lens is chosen from the above specified sizes . complete in all respect as per technical specification attached.

Supply, installation, testing and commissioning of UL Listed CMOS, Vandal-proof, Network Bullet Camera (outdoor type), 5 MP, HD, 1/3” Progressive scan CMOS, [email protected], AGC ON. 0 Lux with IR on, IR cut filter with auto switch,, H.265 / MPEG4 , Dual stream, Bit rate 32 Kbps-16Mbps, Standard IP66, PoE (802.3af), with fixed lens 8mm/10mm/12mm ,size of lens shall be as per site requirement and mockup ,IR range 30-40 mtr, motion detection, with ONVIF Profile S supported, connectors complete as required IR Bullet fixed type for mounting on wall/Pole/surface mounted with back box and adapter plate complete as required (Outdoor) . (For Main Entry / Exit Gate & Terrace)The lens chosen for individual location shall be duly reflected in the shop drawings and shall be got approved from the Consultant prior to delivery on site.There shall be no additional cost if the suitable lens is chosen for the specified sizes. complete in all respect as per technical specification attached.

Supply, installation, testing and commissioning of Professional Video management and recording software and hardware comprising 16Ch. NVR to record output of all cameras mentioned above in Item no 1 & 2 Third-party network cameras supported, multiple Hard Disk to store minimum 30 days recording of all 32 Cameras @ 1 MP resolution @ H.265 compression considering 24 X 7 recording with minimum 16 Hours of motion with RAID-5 Storage ,10/100/1000 MBps network interface with each NVR, 2 USB2.0, HTTP Networkable, backup by USB/DVDWR, required Client software included, 1 Nos Client licenses and required Camera licenses for each camera complete as per tender specifications and as required. All the components to be of same make as Camera. (Note :- The NVR to be suitable for connection to 2 Nos. Monitors). complete in all respect as per technical specification attached.

Supply installation, testing and commissioning of Desktop Computer comprising CPU, Keyboard and a mouse complete with operating system (OS) and other required software to control NVR in control room including Centralized Video Management Software as per the requirement of the successful operation of the surveillance system. complete as required with following specifications; Processor - Intel Core i-7 OS - Win7 RAM - 4 GB DDR2 SDRAM Memory - 500 GB HDD Dual Monitor Graphic Card - 2GB NVIDIA Quadro 600 Graphics capability: VGA, with at least 32k colors, With 3 Monitor Output Network: 100/1000 Mb Ethernet network card Resolution Support: 1024 by 768; 1280 by 1024; 2048 by 768; 2560 by 1024 complete in all respect as per technical specification attached.

Supply,installation,testing and commissioning of 32” CCTV colour LED screen with resolution 1920x1080, 2HDMI input and Wi Fi connectivity including all accessories complete as required.

Supply, installation, testing and commissioning of Equipment Rack of 24" depth, 19" width 42U APW rack with glass front door, steel rear door, power supply, MCB , cable manager , drawer shelves and wiring channels to accommodate systems equipment and accessories as mentioned in the BOQ above and including all connections and termination as required.

Supply,installation,testing and commissioning of Managed switches - 48 Port PoE 10/100 EB Switch with 2 Fiber uplinks Port (1G) only for LAN base feature set with support to integration with CCTV with all related hardware (Weather Proof 16 gauge box MS powder coated) (L2 Switch)

Supply, installation, testing and commissioning of PU coated 65mm dia MS pole, 3-4 mtrs height along with bracket arrangement for fixing of bullet camera. Cost to include necessary nut-bolts, plates , along with requierd civil work to fix the pole in ground. Height, colour shade of pole shall be as per concerned Architect.

Supplying, laying, marking termination of CAT-6 Un Armoured Data cable in existing conduits/Tray. (For CCTV Camera) 1 run of cable.

Supplying and fixing of following sizes of steel conduit along with accessories in surface/recess including painting in case of surface conduit, or cutting the wall and making good the same in case of recessed conduit as required. 25 mm

XENIUM TELECOM (BID ID -376577)