General Overhauling and other allied repairs to transmission/suspension system including denting / painting of departmental recovery van No JK07 0204 (06 cylinder).

Amount

Complete overhauling of Engine of the vehicle by Way of dismantling of the engine from the chassis, Extraction of old sleeves, valve seats, dismantling of all other spares and complete servicing of the engine block and the spares with diesel/kerosene, providing and fitting of new Sleeves-complete 06 sets, Piston with circlips-complete 06 sets, Gudgeon pins, Head gasket, Inlet and outlet valves with springs-complete set, Valve guide, Valve cotter, Valve seat grinding, Engine overhauling gasket, Timing chain, Timing oil seal, Crank case oil seal, Grinding sticks and paste, crank shaft grinding /finishing to next u/size, P/F of main and big end bearing set and thrust washer and Fuel filter, M-oil filter, Fly wheel ring, all necessary Fuel pipes with banjo bolts and washers, M-oil 20 lit., for engine sump/filters/pump. Including labour charges. Any component not mentioned herein but essential to be p/f, shall be deemed included.

Complete gear box checking and repair/replacement of worn out gears, shafts, pins, gaskets, rings shims, kits, set, bound tube etc and providing of gear oil-07 lit

Denting of the cabin door (both sides), bonnet, steel mud guards’ etc body at localized spots

Complete painting of the vehicle by way of scratching the old and existing paint of the exterior cabin and bonnet by rubbing with sand paper, applying red oxide primer to the body and bonnet and then applying blue enamel of superior quality in two codes to the whole body and bonnet. Also includes writing of the department name on the sides and front top of the vehicle in conspicuous font including labour charges. Complete job and front writings including labour charges.

Complete differential box checking of the vehicle by way of replacing all worn-out spares viz, ring gear, side gear, pinion gear, bearing & seal, yoke, caging, power divider, true shaft, axle shaft, ratio change, vibration troubleshooting and housing of both front and rear differential and provide a differential oil- 2 liters

Complete 4-wheel checking and suspension checking.

Providing and fitting of 16mm steel rope of length of 150 meters.

Replacement of complete alternator assembly

Complete repair of self-starter motor assembly by way of replacing of damaged spare.

Machining/welding where ever required using high quality electrodes for a seamless joints

ZOJILA ENGINEERING WORK