C/O cow shed-cum-fodder shed at Go-shed Sarah.

Amount

Excavation in foundations, trenches etc., in earth work, lift upto 1.50 Metres stacking the eacavated soil not more than 3 metres clear from the edge of the excavation and then returning the stacked soil in 15cm. layers, when required in to plinths sides of foundations etc., consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated earth as directed with in a lead of 20 metres. 07040200 Pick Work.& Jumper Work including carriage of material in all leads and lift and direction of Engineer-in-charge.

Providing and laying cement concrete 1:2:4(1 cement:2 sand :4 graded stone aggregate 40mm nominal size)and curing complete excluding cost of form work in: Foundation and plinth 3169.5 Column including carriage of material in all leads and lift and direction of Engineer-in-charge.

Providing form work with steel plates 3.15mm.thick welded with angle iron in frame 30x30x5mm. so as to give a fair finish including centring, shuutering, strutting and propping etc. with wooden battens and ballies, height of propping and centring below supporting floor to ceiling not exceeding 4 Mtrs. and removal of the same for insitu-reinforced concrete & plain concrete work in: Vertical surfaces such as walls (any thickness) partitions and the like including attached pillasters buttresses, plinth and string courses and the like including carriage of material in all leads and lift and direction of Engineer-in-charge.

Steel work welded in built up sections,trusses and framed work, including cutting ,hoisting ,fixing in position and applying a priming coat of red lead paint. In beams joists channels ,angles , tee ,flats with connecting plates or angle cleats as in main and cross beams,hip and jack rafters,purlins connected to common rafters and the like including carriage of material in all leads and lift and direction of Engineer-in-charge.

Providing and fixing 0.60mm thick prepainted steel sheet in roofing with hot dipped metallic zinc coated sheet with top coat of regular modified polyster (RNP) organic coating of 20 microns over 5 microns primer coating to back coat of polyster of 5 microns over 5 microns primer coating i/c fixing with prepainted iron J or L hooks, bolts and nuts 6mm dia metre with prepainted limpet and rubber washers complete with all accesoriees as required including carriage of material in all leads and lift and direction of Engineer-in-charge.

Karan Sharma

Vinod Kumar

VIKAS

surinder

Ajeev Kumar

ankur mahajan

anuj rana

Rajesh Thakur