Providing LWSS GP Chowk Mahadev Chambi Upper Behli Palahota Jai Devi and Bhalana Tehsil Sundernagar Dsitt Mandi HP

Amount

Excavation in foundation trenches etc. in earth all kinds of soil such as pick work jumper work blasting soft or hard rock or by chiselling soft or hard rock where blasting is prohibited in all leads and lifts including trimming/ chiselling of sides and bed stacking the excavated soil clear from the edge of excavation and returning the excavated soil after completion of work in 15cm layers when required into plinth sides of foundation etc. consolidating each deposited layer by ramming and watering and then disposing of all surplus excavated soil complete in all respect as per the direction and to the entire satisfaction of the Engineer-in-charge.

Providing and laying cement concrete 1:6:12(1cement :6 sand: 12graded crushed stone aggregate 40mm nominal size) and curing complete excluding the cost of form work in foundation and plinth in all leads and lifts.

Providing and laying cement concrete 1:4:8(1cement :4 sand: 8graded crushed stone aggregate 40mm nominal size) and curing complete excluding the cost of form work in foundation and plinth in all leads and lifts.

Randum rubble masonary polygonal rubble masonary (uncoursed brought to courses in walls with hard stone of approved quality in foundation and plinth including leveling up with cement concrete 1:6:12 (1cement: 6 sand: 12 graded stone aggregate 20mm nominal size) in cement mortar 1:6 (1cement: 6 sand) in breast wall and retaining wall including all leads and lifts.

Boulder filling under floor complete in all respect in all leads and lifts.

Providing and laying cement concrete 1:1.5:3 (one cement :one and half sand : three graded crushed stone aggregate 20mm nominal size ) and curing complete excluding cost of form work and reinforcement for reinforced cement concrete work in all leads and lifts in (a) Foundation ,footings bases of columns and the like mass concrete including all leads and lifts

(b) walls any thickness but not less than 0.1 mtrs. thickness attached pillasters , plinths and string courses etc.from top of foundation level upto floor two level in including all leads and lifts .

Brick work using common burnt clay building bricks in super structure above plinth upto floor to level in cement mortar 1:6(1cement:6sand) in all leads and lifts. 2nd class bricks

Providing form work with steel plates 3.15mm thick welded with angles iron in frame 30x30x5mm so as to give a fair finish including certring shuttering strutting and propping etc. with wooden battens and ballies height of propping and centring below supporting floor to ceiling not exceeding 4 mtrs and removal of the same for in-situ reinforced concrete & plain concrete work in all leads and lifts in:-(a) Beams, cantilivers, girders and lintels sides and soffits of beams, beam haunchings, cantilivers, girders, bressumers and lintels not exceeding 1 metre in depth.

(b) Vertical surface such as walls(any thickness) partitions and the like including attached pillasters buttresses, plinth and string courses and the like

(c) Flat surfaces such as soffits of suspended floors,roofs, landings and the like in(a) floor etc. upto 200mm thickness

(d) Edges of slabs and breaks in floors and walls under 20cm wide.

Providing and laying cement concrete 1:2:4(1Cement :2 sand:4 graded crushed stone aggregate 20mm nominal size and curing completre excluding the cost of form work and reinforcement for reinforced concrete work in all leads and lifts in :- a) RCC column, beams, girders etc.

(b)Suspended floors, roofs, landing, shelves and their supports balconies, lintels, beams girders bresmers and cantilevers upto all floor level .

Providing tor steel reinforcement for RCC work including bending, binding and placing in position complete upto floor two level in all leads and lifts.

Providing wood work in frames of doors, windows, clerestory windows and other frames wrought , framed and fixed in position 2nd class deodar wood in all leads and lifts.

Providing 40x3mm iron hold fast 40cm long including fixing to frame with 10cm dia bolts, nuts and wooden plugs and embending in CC block 30x10x15cm 1:3:6(1cement :3sand:6 graded stone aggregate 20mm nominal size)

Providing and fixing panelled glazed or panelled and glazed shutters for doors, windows and clerestory window including black enamelled iron but hinges with necessary screws(40mm thick) 2nd class dedoar wood in all leads and lifts..

Providing and fixing MS grills of required pattern in wooden frame of window etc. with M.S. flats, square or round bars with round headed bolts and nuts by screws plain grills in all leads and lifts.

Cement concrete flooring 1:2:4 (1cement:2sand: 4 graded crushed stone aggregate 20mm nominal size) laid in one layer finished with a floating coat of neat cement in all leads and lifts. (a) 40mm thick

6mm cement plaster to ceiling (a) in cement mortar 1:3( 1cement :3 sand) complete in all respect in all leads and lifts.

20mm cement plaster in single coat on rough side of brick/ concrete/ stone walls for interior plastering upto floor two levels including arrises internal rounded angles chamfers and / or rounded angles not exceeding 80mm in girth and finished even and smooth in cement mortar 1:6 (1cement:6sand) in all leads and lifts.

White washing with lime on undecorated wall surfaces two coats to give an even shade including thoroughly brooming the surface to remove all dirt , dust and other foreign matters.

Distempering with dry distemper of approved brand and manufacture (two coats) on of required shade on decorated wall surfaces to give an even shade after thoroughly brushing the surface clean of grease dust, loose, pices of sealed including preparing the surface even and sane papered smooth and one subsequent coat in all leads and lifts.

Applying priming coat on new wood and wood based surfaces after and including preparing the surface by thoroughly cleaning oil,greese,dirt and other foreign matters,sand papering and knotting.Ready mixed paint brushing wood primer pink.

Applying priming coat on new wood preservative on new wood and wood based surface after and including preparing the surface by thoroughly oil grease dirt and other foreign matter, sand papering and knoting in all leads and lifts.

Painting two coats (excluding priming coat) on new wood and wood based surfaces,with enamel paint to give an even shade including cleaningthe surface of dirt ,dust and other foreign matters sand papering and stopping with enamel paint other than white complete in all respect in all leads and lifts

Providing and fixing anodized MS sliding door bolts with bolts and nuts screws etc. complete.(i) 250 x16 mm

Providing and fixing anodised MS tower bolts ( barrel type) with screws etc. complete.(i) 250 x 10 mm

(ii) 200x10mm

Providing and fixing anodised MS handles with necessary screws etc. complete.(i) 125mm dia

Providing and fixing Oxidized MS hooks and eyes (i) 250mm dia

Providing plinth protection 50 mm thick in cement concrete 1:3:6 ( 1 cement, 3 sand,6 graded stone aggregate 20 mm nominal size ) with in all leads and lifts complete in all respect.

Providing under layer for plinth protection of 75mm thick (unconsolidated )bed dry brick/stone aggregate 40mm nominal size well rammed and consolidated and grouted with fine sand including preparation of ground in all leads and lifts.

Providing and fixing vitreous china wash down water closet (Indian Type, W.C pan) with integral P or S trap including jointing the trap with soil pipe in cement mortar 1 : 1 ( 1 cement 1 sand) ( Seat and cover to be measured and paid for separately) (White colour)

Providing and fixing 100 mm size P or S trap for water closet ( Squatting Pan) including jointing the trap with the pan and soil pipe in cement mortar 1:1 ( 1cement : 1 sand) Sand cast iron

Providing and fixing 12.5/0 ltr. Vitreous China low level flushing cistern with a pair of CI/MS brackets complete with fitting such as lead valve less syphon,15mm nominal size brass ball valve with polygthene float. CP brass handle union and coupling for connection with inlet, Outlet and overflow pipes, 40mm dia CP flush bend including cutting holes in walls and making good the same and connecting the flush bend with cistem and closet ( overflow) pipe to be measured and paid for seperately complete in all respect in all leads and lifts and to the entire satisfaction of Engineer-in-charge .

Providing and fixing cast iron spun spigot and socket soil ventilating pipe ( lead caulked joints to be measured and paid for separately ) 100mm dia in all leads and lifts.

Providing and fixing sand cast iron spun fitting and accessories (a) Bend of required degree any ratious (i) 100mm dia

Fixing of GI pipe light grade for inlet, scour and over flow pipe (Labour rate) of following dias in all leads and lifts.(i)65mm dia

Providing and fixing precast concrete manhole cover & frame confirming to IS: 12593-1988 Part-1 and IS: 12592-1991, part-II, 560mm diameter, medium duty complete in all respect.

Providing and fixing of double flanged cast iron sluice valve Class-PN-1.0 conforming to IS: 780-1984 of Leader/Bhel/Kirloskar /Fources/ Gled/ Pelican/Kartar make of following dias for the pipe line capable to withstanding normal seat pressure including cutting, welding,providing and fixing rubber/asbestos sheet of maximum thickness 3mm as per IS 2712-1979 and providing and fixing MS flange as per Table-17 with required number of nuts and bolts including carriage of material in all leads and lifts.(i) 65mm dia

Wiring for light point/ Fan point/ Exhaust fan/ Call bell point with 1.5 sqmm PVC insulated heat resistant flame retardant (HRFR) and low smoke single core (flexible) copper conductor cable in surface/recessed PVC conduit and earthing the light point with 1.5sq.mm HRFRLS/PVC insulated single core copper conductor cable as required (i) Group "C"

Wiring 3 pin 5/6 Amp plug point with 15 sqmm PVC insulated copper conductor cable providing and fixing 3 pin 5 Amp. Switch socket earthing pin etc. as required

Supplying and fixing wooden board size 180mm*100mm*60mm deep size including providing and fixing 3 pin 15 Amp. Socket as required complete in all respect.

Wiring for circuit with 2*1.5 sqmm PVC insulated copper conductor cable in surface PVC earthing or PVC pipe as requred complete in all respect.

Wiring for power plug with 2x4sq.mm PVC insulated head resistant flame retardant (HRFR) and low smoke single core (flexible) copper conductor cable in surface/recessed PVC conduit alongwith 1 to 4 Sq.mm HRFRLS/PVC insulated single core copper conductor cable for earthing as required within all leads and lifts as per directioin by the Engineer-in-charge.

Wiring for sub main wiring with 2x6sqmm of PVC insulated copper conductor single core cable in surface/ recessed PVC conduit within all leads and lifts as directed by the Engineer-in-charge.

Supplying and fixing plain pendent/batten holder including connector etc. as required.

Providing, installation, testing and commissioning of ceiling fan with regulator, including wiring the down rods of standard length(upto 30 cm) with 1.5 sq.mm PVC insulated copper conductor single core cable etc. as required ceiling fan 1200mm sweep category A of Bajaj, Usha and Khetan make

Providing, installating, testing and commissioning of pre-wired flourescent tube fitting complete with ballast, starter and capacitors but excluding flourescent tube rod, suitable to operate on 230 volts. Single phase AC supply directly on surface with copper wiring as required 1x40 wa.. category "B"

Providing and fixing tube rod 1*40 watt on the exiting tube fixture complete in all respect of Bajaj make

Providing and fixing of street light tube fixture 1x40 watt box Acalylic type cover but without pole as required complete in all respect.

Supplying and erection of bulk head fitting of all size and slopes containing one GLS lamp holder wire guard and lock complete in all respect in all leads and lifts.Cat "B"

Supply and fixing 40 Amp rating double pole 240 Volts. Insulator in the existing MCB DB complete with connection testing and commissioning etc. within all leads and lifts as directed by the Engineer-in-charge.

S/F 5 Amps to 32 Amps rating 240 volts of G series miniature circuit breaker single pole in the existing MCB DB complete with connection testing and commissioning etc. as required category B.

Supplying and fixing 5 Amp to 32 Amps rating 240 voltsG series miniature circuit breaker of following poles in the existing MCBDB complete with connections, testing and commissioning etc. as required complete in all respect 16 Amp. Single pole MCB

Supplying and fixing of following way single pole and neutral sheet steel MCB distribution board 240 Volts on surface/ recess complete with tinned copper busher neutral link earth bar din bar detachable gland plate interconnection including painting earthing etc. as required busbar (i) 8 way

Supply and fixing following rating double pole 240 volt. ELMCB combination unit having a sensivity current upto 300 Milli Amp in the existing MCB DB complete with connection, testing as required ELMCB 40 Amp. Havells make.

Earthing with GI earth pipe 4.5 meter long and 40mm dia including accessories and providing masonary conductor with copper plate watering pipe etc. as required complete in all respect but with out charcoal and sale complete in all respect.

Providing charcoat and salt for earthing as required complete in all respect.

kesar singh contractor

Anshul Walia

ASHEESH DEV