Modification / Reinforcement by way of weld fixing / patching of M.S / G.P sheet to flooring / body sides and Dallas for the rear load body and other allied works of newly purchased departmental truck No LA01G-0107 of Mechanical Division Kargil

Amount

Providing, cutting, sizing, and welding of 3mm thick Mild Steel (MS) sheet (mass density: 7850 kg/m³) or Galvanized Plain (GP) sheets of 24 SWG for patching the floor and three side panels of the truck body using electric welding. The job includes providing, adjusting, cutting, leveling, fixing, electric welding of MS / GP sheets to ensure a uniform and durable surface finish. The work also includes welt fixing of MS / GP sheet with all necessary fasteners, welding rods, and finishing materials. All materials used should be of standard quality suitable for the job, apart from high quality of workmanship as per job requirement Complete job including labour charges etc. Material Details: 1. 4mm MS Sheet of 400 Sqft: 37.18 SqM x 0.004m = 0.1487m³ =1167 kg (say 1200KG) 2. 30mm x 30mm x 3mm MS Angle iron (approx. 200 rft): ≈ 90 kg 3. Wrought Iron Pegs for sheet fastening: ≈ 10 kg

Fabrication of heavy duty roof top tool box of required size with a partition of wooden planks as per the direction of engineer incharge by using nuts/bolts etc on the top front of the truck cabin using 3mm–4mm thick MS sheets. The box shall include hinges, locks, internal partitions as required, and a small side-mounted ladder for access. The job includes complete welding, surface finishing, red oxide priming, and final weather - resistant painting. The job includes fabrication and fitting of a front protective bumper/mesh for safety, along with necessary modification of cabin seat (LP type) by way of p/f of angle iron for structural reinforcement and additional support, gas/electric welding, wood ply, cushion and seat cover etc covered with superior quality of Rexene cloth inside the cabin as per the instructions of the engineer-in-charge. The job also includes "Providing and painting of department name 'MECHANICAL DIVISION KARGIL' on the front and both sides of the vehicle using synthetic enamel paint of approved quality and colour as directed including surface cleaning, lettering by skilled painter, and finishing. The lettering shall be neat, uniform in font and size (minimum 6-8 inch height). Complete job including labour charges etc.

Modification and height extension of the existing truck daala by cutting, resizing, realignment, and welding of the existing frame. Providing and fixing of MS angles/channels as structural supports, and fabrication of new wooden planks (Kikar) of size 8’x1’x35mm x 5 Nos) The wooden plank / fatta shall be made from seasoned hardwood and secured using brackets/clamps to the MS frame. The job also includes surface treatment works such as rust cleaning, red oxide priming, and final protective painting/weatherproof coating. Since the vehicles have to be repaired at any reputed workshop in Srinagar, the contractor will be responsible for the fuel charges of vehicle Kargil to Srinagar and back to MED Kargil after completion of the necessary repairs / replacement. Complete job including labour charges etc.

m/s mohd ali (BID ID -162011)

M/S MEHBOOB AUTOMOBILE (BID ID -161952)