Specification No.15/2020-21

Amount

Providing of 35mm thick factory made design pre-laminated ABS (Acrolynitrile Butadiene sytrene) Door shutter moulded in different designs , consisting of all round frame made out of water proof solid foam PVS bar of size 20 x 32 mm, reinforced by 32 x 32mm - 2 Nos., for vertical made out of LVL ( Laminated Veneer Lumber ) , core material of 32mm thick high density craft craft paper honey comb board, sandwiched on both sides with pre-laminated ABS sheet thickness of 1.5mm PVC edge banding of size .45mm on the vertical sides. Hardware made out of steel coated butterfly hinges - 3 Nos., for each shutter and ISI make SS round lock complete for finished item of work , complete complying with the standard specification. The door shutter and frame should be got approved from the Executive Engineer before use on work.

Fabricating Supplying and fixing in position of Aluminium anodised single leaf door with half panelled with 12mm thick both side laminated particle board at bottom and half glazed using 5.50mm thick Plain glass at top.The outer frame shall be with aluminium box section and necessary accessories such as aluminium clips, rubber beading, PVC felt, handle for a length of shutter (both sides), locking arrangements, furniture fittings average anatic film thickness of 15 microns etc., complete. (With automatic door closure and hinges).

M & F in position of anodized aluminium glazed sliding window of size 1.20 x 1.35m as per ISS 1038-1958 (1245 ISS) using aluminium sections window frame bottom two track sliding 61.85 x 31.75 x 1.50mm @ 0.909 Kg / m, top & side 61.85 x 31.75 x 1.50mm @ 0.784 Kg / m shutter plain out side 40 x 18 x 1.55mm @ 0.547 Kg /m shutter inner lock 40 x 18 x 1.45 mm @ 0.607 Kg /m shutter runner top & bottom 40 x 18 x 1.55mm @ 0.547 Kg / m with glazing clips rubber gaskets sliding wheel & 5mm thick sun cool glass panelling including cost of all materials, locking arrangements labour, lead, lift, etc., complete.

Fabricating Supplying and fixing in position of Aluminium anodised of natural colour matt finish 1/3rd fixed glazing 2/3 rd prelaminated board of Aluminium partition of size 2.70m x2.10 m with required rubber beading etc, including necessary dismantling holes in RCC column, masonry wherever in necessary as directed by the departmental officers. All the aluminium sections should be anodised not less than 15 microns etc., complete.

Supplying, fabricating and fixing inposition Aluminium anodised natural colour matt finish fixed ventilator of size 1.80mx0.60m in all floors with Aluminium section of Outer frame: 24x33x3mm @0.546kg/m,Centre mullion :[email protected] kg/m,Alu. Clips: 17.27x17.15x1.40mm @0.175kg/m and with necessary accessaries such as rubber beading and fixing 4mm thick plain glass including cost of all materials, labours, power consumptions required for fabrication, drilling holes in RCC column, slab, masonry walls wherever necessary with power drills to the required extent and work good to be original condition after fixing and also as directed.All the Aluminium section are to be anodised with matt finish under electrically controlled conditions in accordance with IS 1868/1962 for an average anodic film thickness of 15 microns etc. complete.