Installation of High Mast Soler Light at Shantipara 100 under Fulbari-I G.P. within Rajganj Block. Activity code- 127585793 (SL.NO-05)

Supplying of Octagonal GI Pole (Hot Dip Galvanized) of 3 mm thickness min 360 mm base dia, 150 mm tip dia, for 10.5 mtr length High Mast Pole with base plate 500 mm x 500 mm x 16 mm with foundation Bolt 24 mm dia x 600 mm length x 4 nos along with arrangement of winch with hand pulley system with suitable metallic rope / Metallic Ladder for maintenance purpose of Luminaries and PV system

Foundation Construction of RCC shallow foundation with base footing for erection of high mast Tower by earthwork in excavation of foundation trench approx 1.2mx1.2mx1.5m reinforces steel used in foundation 10mm tor both ways as per direction of EIC including removing spoils and necessary trimming the site of tranch leveling dressing abd bottom after that picked jhama bricks soling and dressing bed leveling and filling joints after that distribution rods proper size stirrups, binder etc and vertically MS rods 12mm dia foundation of 8 nos and with two way strips, 8mm dia tor @150mm C/c spacing including binding with 16SWG black annels wire steel shutting and placement of not less than 5 nos (53mm dia x1200 mm along) foundation bolt with anchor plate of stregth and ready mix concrete of M25 grade with graded stone chips 20mm as per IS 1062 and IS 456 (Proportion 1:1:2) complete and water rigidity next 7 days considering the safe soil bearing Capacity of 10T/sqm

Supplying of 200Wp Mono PERC PV module with IEC 61215, IEC 6173- 1, 2 compliance with any IS MNRE approved

Supplying of SOW Luminaries comprise of a) SOW LED with minimum colour temperature (CCT) 5500-6500K minimum luminous lux 150Lm/W i.e 3600Lm (Philips/Osram/equivalent reputed make with BIS certification) b) Charge controller with MF'PT and efficiency > 92% and it should have over charge protection, deep discharge protection, Battery reverse polarity protection, load short circuit protection, open circuit protection, panel reverse polarity protection, over temperature protection c) Automatic dusk to drawn controlling system to monitor LED operation d) With / Without Dimmer arrangement

Supplying of 12.8V, 100Ah, LITHIUM FERO PHOSPHATE (LiFePO4) Batteries having BIS certificate) the batteries should have battery management system (BMS) with high life expectancy, longer circle life, low discharge rate and fast charging facilities Battery should provide 12 Hrs battery backup the battery must be provide with GI out door type battery box / Inbuilt in Luminaries

Earthing with 50 mm dia GP Pipe 3.64 mm thick x 3.04 Mtr Long and 1 x 4 SWG GI (Hot Dip) wire (4Mtr Long) 13mm dia x80mm (Long GI Bolts, double nuts, double washers incl. S&F 15mm GI Pipe protection (1 Mtr Long) to be fitted with bitumen party under the ground level & party above ground level driven to an average depth of 3.65 Mtr below ground level & restoring surface duly rammed.

Cable and wires a) DC cable 4 sqmm- 40M b) Control Cable LS

Installation and Commissioning

Trapsortation

Comprehensive maintenance for 05 years (Minimum 1 (one) visit Quarterly)

Supply and installation of Display Board including cost of Photographs as per requirement.

Adding GST @ 18%

Adding Cess @ 1%