Loading
Loading…
Loading…
| # | Company | Quoted % | Amount | Rank | Status |
|---|---|---|---|---|---|
| 1 | L1₹4.9 LAdmitted-Finance 46 2 OLD POLICE LINE ROAD BERHAMPORE MURSHIDABAD | KOLKATA | WEST BENGAL | 700023 | +30.00% | ₹4.9 L | L1 | Admitted-Finance |
| 2 | L2₹5.0 LAdmitted-Finance BHAKURI CHALTIA BERHAMPORE MURSHIDABAD | BERHAMPORE | MURSHIDABAD | WEST BENGAL | 742101 | +32.00% | ₹5.0 L | L2 | Admitted-Finance |
| 3 | L3₹5.0 LAdmitted-Finance CHUANPUR COLONYPARA P O BERHAMPORE DIST MURSHIDABAD WB PIN 742101 | BERHAMPORE | MURSHIDABAD | WB | 742101 | +33.00% | ₹5.0 L | L3 | Admitted-Finance |
Tender Value
₹3.8 L
EMD Value
₹8,000
Closing Date
15 Jun 2026, 5:00 pmClosed
Executive Engineer (A-I) BER-I(A-I) Division
24 Kalikapur Road Near air strip Maidan, Berhampore, Murshidabad
Rewinding and Repairing of 17.5 H.P. A.C. 3 phase, 2800-2900 R.P.M., 50 Hz submersible motor of different make with repairing of submersible pump bowl assembly under Jalangi (A-I) Sub-Division under Berhampore-I(A-I) Division under Non-Plan.
2026_WRDD_1025369_2
WRDD/EE/(A-I)/Ber-I/ eNIT- 03 of 2026-27
Open Tender
ELECTRICAL WORKS M/R
Percentage
60 days
Jalangi
Please refer Tender documents.
4 documents required · 4 mandatory
₹8,000
17 Jul 2026
26 May 2026
18 Jun 2026
26 May 2026
15 Jun 2026
26 May 2026
This is a percentage-rate BOQ. The schedule below shows estimated quantities and rates. Bidders quote a single percentage above or below the total estimated cost.
| Sl No | Description | Qty | Unit | Est. Rate | Est. Amount |
|---|---|---|---|---|---|
| 1 | Dismantling of different H.P. 2800/2900/3000 RPM for submersible motor, removing old burnt out coil from the solts carefully, segregation all the parts, washing and cleaning the same throughly for verification of serviceable and unserviceable parts as per direction of E.I.C. 17.5 H.P Submersible Motor | 10 | Each | 442 | ₹4,420 |
| 2 | Rewinding of 3 phase 410-440 volt 2800/2900 RPM 3 pole 50 cycle AC supply submersible motor of different make with PVC insulated copper winding-wire (Incable / Finolex make) as per I.S. 8783 ,1995(Part-4/Sec1 ) and as per size provided by the manufacturer of the motor on slots including supplying fitting and fixing fire proof fiber chips on slots for keeping winding wires in position, coil , joints souldered properly, taped by using the waterproof tape 660 volt grade(as per approved of the Engineer-in-Charge) with main cable and fitted with water tight compound by using steel grip tape and volcanised rubber tape by method of heating effect including supplying fitting, fixing rings, circlips for thrust plate water seal ring and complete reassembling the motor with repaired spares or new spares (to be supplied departmentally) as per direction of the (E.I.C). 17.5 H.P., 3phase, 410-440 volts, 50 Hz, 2 pole, 26 amps-30 amps submersible Motor. Supply of PVC insulated copper winding wire conforming IS 8783,1995,part 4/ sec 1. Length of copper winding wire Maximum-450.00Mtr 1.5 mm nom. Dia for 17.5 H.P | 4,250 | Mtr. | 27.08 | ₹1,15,090 |
| 3 | Labour Charges for rewinding , water proofing, fitting & fixing fire proof fibre chips on slots for keeping winding wires in position, taped by using water proof tape of 660 volt grade with main cable and fitted with water tight compound by using steel grip tape and vulcanized rubber tape by heating as per direction of E.I.C. | 10 | Each | 2,341 | ₹23,410 |
| 4 | Repairing of damaged motor shaft by metaling with electric welding and turning properly to house in the bearing space and coupling side teeth and also rectifying the dynamic balance of the rotor to its original alignment to a void any vibration all complete as per direction of E.I.C. | 10 | Each | 350 | ₹3,500 |
| 5 | Supplying fitting & fixing the winding protector on both sides (Top & bottom) | 20 | Each | 85 | ₹1,700 |
| 6Supplying, fitting, & fixing the bush bearing for motor in place of damaged as per approval and direction of E.I.C. | |||||
| 6.01 | a) Top | 20 | Each | 850 | ₹17,000 |
| 6.02 | b) Bottom | 10 | Each | 850 | ₹8,500 |
| 7 | Supplying, fitting & fixing drain plug made from brass metal with gasket and washer (one for drain plug, one for water filling plug and one for venting plug) | 10 | Each | 145 | ₹1,450 |
| 8 | Supplying , fitting, & fixing stud bolt with nuts for top and bottom cover | 80 | Each | 125 | ₹10,000 |
stage.html
html • 0.03 MB
tech_bid_open.pdf
tech_eval.pdf
fin_bid_open.pdf
boq_comp_chart.xlsx
xlsx
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Tendernotice_1.pdf
PDF • 1.13 MB
Tendernotice_2.pdf
PDF • 0.46 MB
BOQ_2519692.xls
BOQ • 0.31 MB
Corrigendum.pdf
PDF • 0.53 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at [email protected].