Loading…
India Infra Updates on WhatsApp
Join the Tenderkart WhatsApp channel for India Infra Updates
Loading…
Tender ID
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹83.9 LAccepted-AOC AT PAREJ PO BANJI RAMGARH 825314 | RAMGARH | RAMGARH | JHARKHAND | 825314 | L1 | Accepted-AOC L1 Bidder | |
| 2 | L2₹87.8 L+₹3.8 L (4.58%)Rejected-Finance | L2 | Rejected-Finance L2 bidder | |
| 3 | L3₹89.3 L+₹5.4 L (6.43%)Rejected-Finance AT TELIYATU BARKAKANA RAMGARH JHARKHAND 829102 | RAMGARH | RAMGARH | JHARKHAND | 829102 | L3 | Rejected-Finance L3 bidder |
Tender Value
₹1.1 Cr
EMD Value
₹1.3 L
Closing Date
27 Jan 2024, 5:00 pmClosed
Eligibility, documents, scope and key termsEligibility, required documents, scope of work and key terms of this tender, in one click.
General Manager, Bastacolla Area
Civil Engineering Department, Office of the General Manager Bastacolla Area
Construction of PQC Road including Mechanized Wheel Washing Arrangement from Rajapur office to Deco Camp at Rajapur colliery under Bastacolla Area
2024_BCCL_298885_1
BCCL/BA/ACE/NIT/2023-24/09 Date 17.01.2024
Open Tender
Civil Works - Roads
Item Rate
120 days
Bastacolla Area
Refer to NIT
5 documents required · 5 mandatory
₹1.3 L
3 Jun 2025
17 Jan 2024
29 Jan 2024
17 Jan 2024
27 Jan 2024
17 Jan 2024
17 Jan 2024 - 22 Jan 2024
Amount
Mechanised Wheel Washing Arrangement A. Civil construction related works: 1. Supply of design drawing for construction of all civil related works including concrete water tank of minimum 40cum. Construction of wheel wash foundation and recycle tank of at least 40 cum consisting of screen chamber, grit chamber, oil & grease chamber, sedimentation tank and equalisation tank along with pump house 2. Supply of all construction material with workmanship[ and completion of all civil related works. 3. Erection and commissioning of the mechanical system in synchronisation with civil system. 4. Scope of BCCL for civil construction - SIte for system B. Mechanical and Electrical works related to Wheel wash system. The system unit will be consisting the following: 1. Hot Dip Galvanised wash pads - minimum of two hot dip galvanised wash elements (left/right) each having minimum 4200 mm (L) x 1000 mm (W) with side cladding / panels of adequate height to avoid spraying of washed effluent in the LHS and RHS. 2. Side spray panels (2 nos, 1 in LHS and RHS each) with openable nozzles assebly. The nozzles of minimum 5mm orifice/ diameter and minimum 120 nos of nozzles including side and bottom nozzles to cover length of the wash platform of minimum 4200 mm drive through length and track width of minimum 10300 mm x 3360 mm. The wash elements should have angled profile construction for better cleaning effect embedded with the nozzles. 3. Wash water pumps control panels: A minimum of 2 submersibles sludge quality pumps with integrated screen assembelies, water well piping, pump deliver individually maximum of 1000 litres per 30 second wash cycle. The submersible pumps should able to reuse the water in the wheel washing system for recycle tank. 4. Automatic vehicle entry sensing - 1 set, at least Automatic vehicle entry sensor should be capable to activate wheel washing unit and related water recycling operations automatically as soon as vehicle approaches the system. The related sensor should be placed in a self-supporting powder coated stand. The sensor stand should have an integrated rotation plate to provide directional changes for sensor focus on the field. 5. Side railing along with entry/exit gate in and around the water tank for safety concern. At least 1.2 mtrs height by chain link fencing with angle iron support. 6. Control panel - at least 1 set with IP 54 or more protection. 7. Flocculent Dosing Pump/system - Minimum 1 set of adequate capacity. 8. Oil skimmer - Minimum 1 set of adequate capacity 9. Miscellaneous : In addition to the above, if some essential equipment(s) required for proper functioning of the whole system will be in vendor scope only. Vendor have to ensure system's working performance from trial run to warranty period of 12 months at peak loads.
Construction of Subgrade : Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2 : By vibratory roller
Granular Sub-Base with Close Graded Material (Table:- 400-1)By Mix in Place Method Construction of granular sub-base by providing close graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401 for grading- I Material
Dry Lean Cement Concrete Sub- base (Construction of dry lean cement concrete Sub- base over a prepared sub-grade with coarse and fine aggregate conforming to IS: 383, the size of coarse aggregate not exceeding 25 mm, aggregate cement ratio not to exceed 15:1, aggregate gradation after blending to be as per table 600-1, cement content not to be less than 150 kg/ cum, optimum moisture content to be determined during trial length construction, concrete strength not to be less than 10 Mpa at 7 days, mixed in a batching plant, transported to site, laid with a paver with electronic sensor, compacting with 8-10 tonnes vibratory roller, finishing and curing.)
Construction of un-reinforced, dowel jointed, plain cement concrete pavement over a prepared sub base with 43 grade cement @ 400 kg per cum, coarse and fine aggregate conforming to IS 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a batching and mixing plant as per approved mix design, transported to site, laid with a fixed form or slip form paver, spread, compacted and finished in a continuous operation including provision of contraction, expansion, construction and longitudinal joints, joint filler, separation membrane, sealant primer, joint sealant, debonding strip, dowel bar, tie rod, admixtures as approved, curing compound, finishing to lines and grades as per drawing
Construction of Subgrade and Earthen Shoulders (Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2
Surface Drains in Soil Construction of unlined surface drains of average cross sectional area 0.40 sqm in soil to specified lines, grades, levels and dimensions to the requirement of clause 301 and 309. Excavated material to be used in embankment within a lead of 50 metres (average lead 25 metres).
Demolishing cement concrete manually/ by mechanical means including disposal of material within 50 metres lead as per direction of Engineer - in - charge. Nominal concrete 1:3:6 or richer mix (i/c equivalent design mix)
Total impact of GST for the purpose of CTC
SRI VENKATESHWARA ENTERPRISES
BINOD KUMAR SINGH
tech_eval.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
aoc.pdf
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .