E Tender No 64/EDC(K)/2025-26

Supply Item

E-CLAMP FOR 33kV 75X10mm WITH N&B (As per Specification of RESPO & UPCL)

Earth wire clamp with N&B (As per Specification of RESPO & UPCL)

Bracing Clamp Top SP-55 with N/B (As per Specification of RESPO & UPCL)

Bracing Clamp Bottom SP-55 with N/B (As per Specification of RESPO & UPCL)

Bracing Clamp SP-72 (As per Specification of RESPO & UPCL)

EARTH WIRE CLAMP FOR SP-55 WITH N/B (As per Specification of RESPO & UPCL)

PP & CLAMP WITH N&B ST POLE SP-55 (As per Specification of RESPO & UPCL)

Stay Clamp for SP-55 With Nut & Bolt (As per Specification of RESPO & UPCL)

PP & CLAMP WITH N&B ST POLE SP-72 (As per Specification of RESPO & UPCL)

STAY INSULATOR (As per Specification of RESPO & UPCL)

DANGER BOARD (As per Specification of RESPO & UPCL)

33 KV Mid Span Jointing Kit (As per GTP & Specification of UPCL)

33 KV Tension clamp with Bail & IPC (As per GTP & Specification of UPCL)

33 KV Cable ties for Pin insulator (As per GTP & Specification of UPCL)

33 KV IPC for covered to covered conduct (As per GTP & Specification of UPCL)

33 KV IPC for covered to Bare conductor (As per GTP & Specification of UPCL)

IPC with aluminium bail for earthing (As per Specification of RESPO & UPCL)

11 KV CABLE TIES FOR PIN INSULATOR (As per Specification of RESPO & UPCL)

33KV AAAC COVERED COND. AL-59,241 SQ.MM. (As per GTP & Specification of UPCL)

Line Erection Work

Earthing of support with M.S. Earth rod of 2.5 meter long by hammaring of M.S. Rod to proper depth and connecting the earth electrode with the helpof G.I. wire as per construction manual.

Fabrication of M.S. Channel Angle iron after cutting in required sizes with drilling of holes upto good finish for top channel, bracing and special type bracket etc. as per RESSPO sehedule and local approved drawing.

Excavation of earth for Stay pit of size 0.6x0.6x1.2mtr in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

Fixing , tightening and nozzaling of 11 KV Stay with pole and stay rod on required tension as per drawing / RESSPO manual.

Fixing , tightening and nozzaling of 33 KV Stay with pole and stay rod on required tension as per drawing / RESSPO manual.

Grouting of Stay in size 0.6x0.6x0.3 in CC ratio 1:4:8 (1 cement : 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cement,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESSPO Manual.

Excavation of earth for pole pit of size 0.9x0.6x1/6 of full length of pole for erection of pole in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

Erection of Single SP-55 pole in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESSPO construction Manual.

Erection of Double SP-55 pole in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESSPO construction Manual.

Erection of Four pole SP-72 in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESSPO construction Manual.

Grouting of pole in size 0.45x0.45x1/9 of the support in CC ratio 1:4:8 (1 cement : 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cement,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESSPO construction Manual.

Muffing of poles size 0.45 cm x 0.60 cm radious with cc 1:3:6 (1 cement : 3 coarse sand : 6 graded stone 10mm nominal size) block size 45cm height from ground level including cost of cement, stone and sand etc.

Painting of SP 55 poles with angle and channel and all steel part by one coat of Rod Oxide Primer and two coats of aluminium Paint and two strip of fluorescent altemate Red and White paint 30 Cm wide upto 1.5 Mtrs. From ground level.

Painting of SP 72 poles with angle and channel and all steel part by one coat of Rod Oxide Primer and two coats of aluminium Paint and two strip of fluorescent altemate Red and White paint 30 Cm wide upto 1.5 Mtrs. From ground level.

GUARDING OF 33 KV LINE

CONST.,INST.OF DANGER BOARD/ NUMBER PLATE

MAKING OF SECTION POLE

CARTAGE SP-55 POLE, 0-20 KM from store centre to construction site with loading, unloading at both points. (loading, unloading pluse carriage per pole) and proper stacking.

CARTAGE SP-72 POLE, 0-20 KM from store centre to construction site with loading, unloading at both points. (loading, unloading pluse carriage per pole) and proper stacking.

CARTAGE OF PETTY MATERIAL,0-20 KM by vehicle fro Store Center to nearest construction site Store including loading and unloading at both ends.

HEADLOAD CARTAGE SP-55 POLE(0-1KM) from road to site (Rates are per pole / KM

HEADLOAD CARTAGE SP-72 POLE(0-1KM) from road to site (Rates are per pole / KM

HEADLOAD CARTAGE OF MATERIAL(0-1 KM) from road to site (Rates are per pole / KM

TIGHTENING OF STAY SET

fixing of Danger Board and number plate complete by providing clamps of M.S. Flat 50x6 mm and Nuts & Bolts, danger Boards of M.S. Sheet 2 mm Thick 11''x7'' size (Including cost of all material)

BACK CARTAGE OF PETTY MATERIAL,0-20 KM

FIXING OF 33 KV TENSION CLAMP WITH IPC

FIXING OF 33 KV IPC FOR CC TO CC COND

FIXING OF 33 KV IPC FOR CC TO BARE COND

FIXING OF 33 KV MID SPAN JOINTING KIT

FIXING OF IPC WITH AL. BAIL FOR EARTHING

STRAIGHTNING OF TILTED X-ARM

BACK HEAD LOAD CART. OF PETTY MAT. 0-1KM

FIXING OF 33KV CABLE TIES

RENOZZELING OF EXISTING STAY SET

SUPPLY & FIXING OF PP & CLAMP FOR SP-55

DIGGING OF PIT AND STRAIGHT OF TILT POLE

SUPPLY & FIXING EARTH WIRE CLAMP

LAYING SPREADING,STRINGING AAAC CONDUCT.

REMOVING OLD CONDUCTOR BY OPENING JUMPER including disc fitting, Insulator, clamps, Nut & Bolts and consumer connections and Street light connections etc. including rolling of conductor and cartage back from site to JE store

ERECTION OF ANTICLIMB DEVICE BARBED(N&B)

Route cleareance by cutting of tree branches / proning, loping and chopping of trees for L.T., 11 & 33 KV line.