R/R Damages on Haylog to Pehad Road km 0/0 to 10/800

Amount

Earthwork in excavation in all kinds classification of soil in foundation of structures upto all depth/ height as per drawing and technical specification Clause 305.1 includding setting out, construction of shoring and bracing, removal of stumps and other deleterious material and disposal upto all lead and lifts dressing of sides and bottom and back filling with approved material and disposal of all surplus excavated earth in specified site and as per direction of Engineer-in-charge complete.

Construction of granular sub base by providing well graded materials grading -1 spreading in uniforms layers with tractor motor grader on prepared surface, mixing by mix in place method with rotvator at OMC, and compacting with smooth wheel roller to achieve the desired denisty, complete as per technical specification Clause 401 including hauling of material in all leads, lifts as per the entire satisfaction and direction of Engineer-in-charge.

Providing and laying cement concrete plain/ reinforced concrete in 1:3:6 (one cement : three sand : Six graded stone aggregate 20 mm nominal size ) open foundation complete as per drawing and technical specification cluse 802,803,1202 and 1203 including form work for plain/ reinforced concrete work as per drawing and HP,PWDD technical specification including carriage of materials with in all leads and lifts and direction of Engineer in Charge.

Providing and laying cement concrete 1:5:10 ( One cement: Five sand: Ten graded crushed stone aggregate 40mm (Forty milimeters) Nominal size as per PWD specification in all heights and curing complete including cost of form work in retaining wall/ breast walls including entire carriage of materials with in all leads and lifts complete.

Providing weep holes in brick masonry /stone masonry/plain reinforced concrete abutment,wing wall and return wall with 100mm ( One Hundred milimetres ) dia PVC pipe extending through the full width of structure with slope of 1:20 ( One vertical twenty horizontal ) towords drawing face complete as per drawing and technical specification clause 614.709,1204.3.7 including carriage of materials with all leads and lifts as per direction of Engineer in Charge.

Back filling with granular material behind abutment, wing wall & return wall complete as per drawing & technical specification clause 1204.3 in all leads and lifts and carriage of material by all modes of transportation as per the direction of Engineer- in-Chrage .

Construction of un-reinforced, construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, , wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days, using curing compound ( where specified ) and wa ter finishing to lines and grade as per drawing and Technical specification clause 1501 including hauling of material within all leads and lifts and other incidental charges and as per direction of Engineer-In-Charge.

Construction of embankment with approved material obtained from borrow pits with all lifts andleads,transporting to site, spreading,grading to required slope and compacted to meet requirement of Table 300.1 and 300.2 with all leads and lifts as per Technical Specification Clause 301.5 as per direction of Engineer -in- Charge.

Rup Singh