General

Supplying of hot applied thermoplastic road marking compound 2.5mm thick including reflector rising glass beads 250gms with reflector rising glass beads on bituminous surface at 250gms per sq. area, thickness of 2.5mm is exclusive of surface applied glass bead as per IRC: 35, the material should be of BERGER company/ BERGER equivalent and must comply with the following a) white index for the product should be in the range of 60-70 when measured against standard reference. The applied panel 7/8 number must be submitted for checking up the white index in the department lab. In case the department approves the white index of any vendor, the department B2engineer may carry out random checking of the applied products as site against the approved panel, In case of any major deviation, beyond acceptance limit, department reserve 1 the right to cancel or reject the total supplied consignment of the said material and with compel the vendor has to replace the full consignment by the desired material as per approved panel at his own cost and additional demurrages may be claimed due to loss of man days (as per the rules of the department) b) luminance factor of the material should be in the range of 80-85% as 45 degree centigrade as per AASTHOM 249 c) Crack resistance: the applied panel cured for 7 days under ambient condition and then should be tested as per BS3262 Part-1 1989 and should pass at the range of '0' degree centigrade to '-10' degree centigrade d) Adhesion: strong e) softening point: 102 degree centigrade f) Dried film finish: smooth and uniform g) Night vision: High as directed by the Engineer-in-charge and confirming to IS:164-1961 (1st revision reaffirmed in 1986) and clause confirming to IRC 35-1997.

Provision for Seignorage charges

Provision Towards merit 2%

Provision Towards DMF 30%

Provision for NAC @ 0.10%

Provision for GST @ 18%

Provision for TPQA @ 0.739 %

Unforeseen item