Extension of HT/LT line by Underground power cable including Installation of 1X63KVA distribution transformer for providing 3-phase service connection to newly Sunk DTW under AMRUT Scheme at Shyamapalli under AMC Word No- 47 scheme within the juri

Amount

(Supply & Erection)

Erection of 9.0 mtr. Length of Steel Tubuler Pole atany kind of soil upto a depth of 1/6th of pole height,i/c excavation of of earth, refilling the pit with soil up to the ground level,ramming and making complete in all respect

Erection of stay set complete direct in earth with 19 mm.x 1800 mm long stay rod, anchor plate of size 300 X 300 X 8 mm thimble, turn buckle, 7/3.15 mm dia G.I stranded stay wire and strain insulator etc with supply of MS Clamp, Nuts &bolts etc as required. and making complete in all respect

Erection of MS Channel cross arm, 1.2 mtr. Long 75x40x40x6mm e(excluding the cost of back Clamp, Nuts & bolts)

Erection of MS Channel cross arm, 2.8 mtr. Long 75x40x40x6mm e(xcluding the cost of back Clamp, Nuts & bolts)

Erection of MS Channel cross arm, 2.8 mtr. Long 100x50x50x6mm e(xcluding the cost of back Clamp, Nuts & bolts)

Erection of MS Channel cross arm, 0.8 mtr. Long 100x50x50x6mm e(xcluding the cost of back Clamp, Nuts & bolts)

Erection of 11KV Pin Insulator along with pin

Erection of 11KV Single Disc Insulator set along with necessary fittings

Erection of 9KA,5KA Single pole metal oxide gapless type LA including necessary connection complete as per Technical specification.

Erection of 11KV, DOF unit set of Three nos including necessary connection complete as per Technical specification.(excluding the cost of back clamp, Nuts & Bolts)

Erection of 11KV, 200 Amp GOS unit set of Two nos including necessary connection complete as per Technical specification.(excluding the cost of back clamp, Nuts & Bolts)

Installation /positioning of 11/0.430KV, 3-Phase 63 KVA Distribution transformer on pole with necessary connection & fittings fixing of all allied accessories component as required for making complete in all respect for energizing

Carriage of 9.0mtrs length of steel tubular pole by mechanical transport from the electrical site store to working site vis-a Vis including loading, unloading andstacking etc required. A)upto the lead range 25KM, i)For maximum 8(eight)pole (4 Nos Pole)

Carriage of GOS, DOF, LA etc by mechanical transport from the electrical sub-division site store to working site vis-a Vis including loading, unloading andstacking etc required. upto the lead range 0-25KM

Carriage of 11/.430, 3-phase 63KVA by mechanical transport from the SITE/STORE/WORKSHOP TO WORKING SITE vis-a Vis including loading, unloading and placing on base as required. upto the lead range 25KM

Laying of one number PVC Insulated and PVC sheathed /XLPE Power Cable of 11KV Graded of all size in the GI Pipe /HDPE for riser including tieup of Pipe with pole by the help MS Flat Clamp(excluding costof clamp and Nuts& bolts) as required

Supply Outdoor cable end termination with heat shrinkable jointing kit complete with all accessories including lugs suitable for 70sq.mm, 3 core XLPE aluminium conductor cable of 11kv Graded.

HDD digging / drilling horizontally or diagonally direction for road crossing / water supply line / Telecomminication line/ Gas pipe line etc. in Laying of 64-200mm dia HDPE pipe direct in ground at a depth of minmum 1200mm below the graund surface without effecting the existing road inluding excavation of earth for entry pit as per site condition and direction of Engineer-In-Charge.

Earthing with GI Pipe 2.5 mtr. Long nd 40 mm. dia with holes including excavation , Refilling with alternate layer of Salt and Charcoal as per drawing(Excluding supply of G.I pipe, Salt &charcoal, GI wire, Nuts &bolts, etc as required.

Providing of Pre-cast cement concretable identification route marker (1 cement: 2 coarse sand: 4 graded stone aggregate 6mm nominal Size) reinforced with 1.6 mm dia mild steel wire incliding centring, and Shuttering, roughening, cleaning, fixing and finishing in cement morter 1:3 (1cement:3 Fine sand) etc complete, excluding the plasteringof jambs, sills and soffits as per design , drawing and specification of TSECL. the marker shall be embossed " DANGERS TSECL, ELECTRIC POWER CABLE" with back coloure letter (both Side), the visible part shall be painted with yellow colour Japan Paint

Providing and executing cement concrete work 1:2:4 ( 1=cement, 2=river sand, 4= jhama bricks aggregate 20mm nominal Size) for grouting of steel pole/ supporting pillars excluding the cost of centering, shuttering inc. centering, shuttering and excavation in foundation trench not exceeding1.4mtr width in 10sq.mm on plan i/c dressing of side and ramming of bottom lift up to1.5mtr. width i/c getting the excavated soil and direct with in alead of 50mtr(0.273x4nos- )

Jointing of Outdoor cable end termination with heat shrinkable jointing kit complete with all accessories including lugs suitable for 70 sq.mm ,3 core XLPE aluminium conductor cable of 11kv Graded.

Supply of XLPE Power cable 11KV Grade 3core, 70sqmm

Supply of non-flame propagating type 110 mm dia HDPE Pipe, wall thickness: minimum 7.4mm, maximum- 8.2mm (medium class) as per PE-100 Grade, PN-8 (SDR17) of standard make suitable for laying 3-core XLPE insulated power cable and shall be ISI marked and complying to technical requirement of IS; 4984/Is; 14333.

Erection of fabricated MS Channel cross arm, 1.2 mtr. Long 75x40x40x6mm e(excluding the cost of back Clamp, Nuts & bolts) with double coat of red oxide primer coating

Erection of fabricated MS Channel cross arm, 2.8 mtr. Long 75x40x40x6mm e(xcluding the cost of back Clamp, Nuts & bolts) with double coat of red oxide primer coating

Erection of fabricated MS Channel cross arm, 2.8 mtr. Long 100x50x50x6mm e(xcluding the cost of back Clamp, Nuts & bolts) with double coat of red oxide primer coating

Erection of fabricated MS Channel cross arm, 0.8 mtr. Long 100x50x50x6mm e(xcluding the cost of back Clamp, Nuts & bolts) with double coat of red oxide primer coating

Supply of 1/2 " dia Polythine Pipe

Supply of Wooden Plank (24"X10'X1.5"size)

Supply of fabricated MS bracket & stay Clamp (made by 50X6mm flat) with double coat of red oxide primer coating

TAPAN CHOUDHURY