CONSTRUCTION OF NEW UTILITY OFFICE BUILDING

Amount

Earth work Excavation

Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.All kinds of soil

Soling

Soling with rough stone of size 200 mm, well packed and filling voids with stone chips and required profile with hammer dressed stones having no side less than 15 cm, with minimum depth of 20 cm including preparing the bedding surface etc. all complete.

Shoring

Close timbering in trenches including strutting, shoring and packing cavities (wherever required) complete (Measurements to be taken of the face area timbered).Depth not exceeding 1.5m

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 nominal size).Cement supplied by KMML.

Centering and shuttering For footings, bases of columns

Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete

RCC up to Plinth level

Providing and laying in position specified grade of reinforced cement concrete(precast), excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level:1:1:5:3 (1 cement 1.5 coarse sand :3 graded stone aggregate 20 mm nominal size(Excluding cost of cement)

Steel reinforcement work upto plinth level

Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete upto plinth level Thermo - Mechanically Treated bars of grade Fe-500D or more. TMT bars supplied by KMML

Filling available excavated earth

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m.Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundation etc. in layers not exceeding 20 cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift up to 1.5 m.

Plastering below ground level

Plastering with 12 mm cement plaster of mix 1:4 ( 1 cement : 4 fine sand)(The required cement shall be supplied by KMML at our store)

Bituminous coating

Painting with black bituminous paint of approved brand and manufacture on wet or patchy portion of plastered surfaces:One coat

Centering and shuttering or: Lintels, roof beams, plinth beams

Centering and shuttering including strutting, etc. and removal of form for:Lintels, beams, plinth beams, girders bressumers and cantilevers

Reinforced cement concrete work

Reinforced cement concrete work in beams, slabs, suspended floors, roofs, having slope up to 15 landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases up to floor five level excluding the cost of centering, shuttering, finishing and reinforcement, with1:1.5:3 (1 cement : 1.5 coarse sand (Zone III) : 3 graded stone aggregate 20 mm nominal size).Cement and TMT bars supplied by KMML

Red Earth filling

Supplying and filling in plinth with red earth under floors, including watering, ramming consolidating and dressing complete.

Random Rubble Masonry

Random rubble masonry with hard stone in foundation and plinth including levelling up with cement concrete 1:6:12 (1 cement : 6 coarse sand : 12 graded stone aggregate 20 mm nominal size) up to plinth level with Cement mortar 1:6 (1 cement : 6 coarse sand). Cement shall be supplied by KMML.

Solid Block Masonry up to plinth level

Solid block masonry using pre cast solid blocks (Factory made) of size 30x20x15 cm or nearest available size confirming to IS 2185 part I of 1979 for foundation and plinth with thickness 30 cm in: CM 1:6 ( 1 cement :6 coarse sand) etc complete(Required cement shall be supplied by KMML)

Steel reinforcement above plinth level

Steel reinforcement for R.C.C work including straightening, cutting, bending, placing in position and binding all complete above plinth level.Thermo - Mechanically Treated bars of grade Fe-500D or more (TMT steel bars shall be supplied by company)

Centering and Shuttering for Column

Centering and shuttering including strutting, etc. and removal of form for:Columns, Pillars, Piers, Abutments, Posts and Struts

RCC Column

Reinforced cement concrete work in walls (any thickness), including attached pilasters, buttresses, plinth and string courses, fillets, columns, pillars, piers, abutments, posts and struts etc. up to floor five level excluding cost of centering, shuttering, finishing and reinforcement. Required cement shall be supplied by KMML 1:1.5:3( 1 cement : 1.5 coarse sand : 3 graded stone aggregate 20 mm nominal size)

Centering and shuttering for Roof Slab

Centering and shuttering including strutting, etc. and removal of form for:Suspended floors, roofs, landings, balconies and access platform

Solid block masonry 20cm

Solid block masonry using pre cast solid blocks ( Factory made) of size 30x20x20cm or nearest available size confirming to IS 2185 Part I of 1979 for super structure up to floor two level thickness 20cm and above in: CM 1:6 ( 1 cement : 6 coarse sand) etc complete.(Cement supplied by KMML)

Solid block masonry 10 cm

Solid block masonry using pre cast solid blocks (Factory made) of size 40x20x10 cm or nearest available size confirming to IS 2185 part I of 1979 for super structure up to floor two level for 10 cm thick wall in : CM 1:6 ( 1 cement : 6 coarse sand) including cost of scaffolding complete(The required opc cement for masonry work shall be supplied by kmml at our store)

Centering and shuttering for Sunshade

Centering and shuttering including strutting, etc. and removal of form for:Weather shade, Chajjas, corbels etc., including edges

12 MM Plastering above Ground level

Plastering with 12 mm cement plaster of mix 1:4 ( 1 cement : 4 fine sand)(The required cement shall be supplied by KMML at our store)

Ceiling Plastering 6 mm

6 mm cement plaster of mix 1:3 ( 1 cement : 3 fine sand) The required cement will be supplied by the company

Glass Partition

Providing and fixing 12 mm thick frameless toughened glass partition of approved brand and manufacture, including providing and fixing top and bottom support with fixing arrangement and making necessary holes, SS 304 connect patch etc. for fixing required, required fittings are of Godrej or any approved brand, all complete as per direction of Engineer-in-charge .

Glass Door

Providing and fixing 12 mm thick frameless toughened glass door shutter of approved brand and manufacture, including providing and fixing top & bottom pivot & spring type fixing arrangement, SS 304 H type pull handle of size 325X25 mm with SS 304 side lock patch and SS 304 adaptor of Godrej or any other approved brand and making necessary holes etc. for fixing required door fittings, all complete as per direction of Engineer-in-charge

Dewatering

Bailing out water Using 5HP Pump- Bailing out water with 5HP engine and pump set including conveyance to site and erection,cost of fuel, lubrication oil and other stores, pay of staff etc complete

PRAJITH. P

Bidder Name

M ABDULSHUKKOOR

PRAJITH. P