Bifurcation of ITBP feeder by laying 11 KV underground cable from 33/11 KV S/s Vasant Vihar to Seemadwar ITBP gate under EDSD Vasant Vihar.

Material

11 KV 3X240 SQMM CABLE END TERMINATION J/KIT FOR (O/D)

11 KV 3X240 SQMM CABLE END TERMINATION J/KIT FOR (I/D)

11KV 3X240 SQMM STRAIGHT THROUGH JOINT KIT

CLAMP FOR STP POLE WITH N&B

STAY CLAMP FOR STP POLE WITH N&B

GI STRIP SIZE 40X5 MM

AL LUGS 240 SQMM AS PER SITE REQUIREMENT

11 KV VERTICAL TYPE ISOLATOR

CLAMP SUITABLE 11 KV ISOLATOR

Labour Work

CARTAGE OF ST POLE AND PCC POLE FROM STORE CENTRE TO CONSTRUCTION SITE WITH LOADING,UNLOADING AT BOTH POINTS AND PROPER STACKING

STP POLE SP-55

CARTAGE OF OTHER STOCK MATERIAL (OTHER THEN POLES) BY VEHICLE FROM STORE CENTER TO NEAREST CONSTRUCTION SITE STORE INCLUDING LOADING AND UNLOADING AT BOTH ENDS.

STOCK MATERIAL

HEAD CARTAGE OF FOLLOWING POLES FROM ROAD TO EXECUTION SITE

STP POLE SP-55

MANNUAL CARTAGE OF MATERIAL UNLOADING POINT TO WORK SITE ( 0 TO 0.5 KM)

STOCK MATERIAL

EXCAVATION OF EARTH FOR POLE PIT OF SIZE 0.9X0.6X1/6 OF FULL LENGTH OF POLE FOR ERECTION OF POLE IN ALL TYPE OF SOIL INCLUDING PROPER DRESSING OF SIDES AND RAMMING OF BOTTOM INCLUDING GETTING OUT THE EXCAVATED SOIL AND DISPOSAL OF SURPLUS EXCAVATED SOIL AS DIRECTED COMPLETE WORK

ERECTION OF FOLLOWING DOUBLE SUPPORT POLE IN PROPER LEVEL AND ALIGNMENT ALONG WITH FIXING OF ALL ACCESSORIES,LIKE TOP CHANNEL & CLAMP AS PER RESPO CONSTRUCTION MANUAL.

STP POLE SP-55

ERECTION OF FOLLOWING SINGLE SUPPORT POLE IN PROPER LEVEL AND ALIGNMENT ALONG WITH FIXING OF ALL ACCESSORIES,LIKE TOP CHANNEL & CLAMP AS PER RESPO CONSTRUCTION MANUAL.

STP POLE SP-55

GROUTING OF POLE IN SIZE 0.45X0.45X1/9 OF THE SUPPORT IN CC RATIO 1:4:8(1 CEMENT:4 GRADED STONE 20MM NOMINAL SIZE : 8 COARSE SAND) BLOCK INCLUDING COSTOF CEMENT,SAND ALIGNMENT,LEVELING AS PER RESPOCONSTRUCTION MANUAL.

MUFFING OF POLES SIZE 0.45 CMX0.60 CM RADIOUS WITH CC 1:3:6 (1 CEMENT : 3 COARSE SAND : 6 GRADED STONE 10 MM NOMINAL SIZE) BLOCK SIZE 45 CM HEIGHT FROM GROUND LEVEL INCLUDING COST OF CEMENT, STONE AND SAND ETC.

PAINTING OF NEW/EXISTING POLES WITH CHANNEL INCLUDING ONE COAT PRIMER AND TWO COAT SILVER PAINT AND RED ASIAN PAINT OF SUPERIOR QUALITY ON UPPER SIDE OF POLE

FIXING OF MS EARTH ROD INCLUDING EXCAVATION, INSERTING OF EARTH ROD IN SOIL AND CONNECTION OF EARTH WIRE

FABRICATION OF MS CHANNEL / ANGLE IRON AFTER CUTTING IN REQUIRED SIZES WITH DRILLING OF HOLES UPTO GOOD FINISH

FIXING AND GROUTING OF STAY SET INCLUDING DIGGING OF PIT IN SIZE OF CC 1:4:8 (0.3X0.6X0.6) MTR INCLUDING NOZZELING, FIXING, TENSIONING AND TIGHTENING COMPLETE.

MAKING TRENCH WITH TRENCHLESS TECHNOLOGY FOR 11KV CABLE LAYING INCLUDING LAYING OF 11 KV CABLE AND COST OF HDPE PIPE WITH SUITABLE OUTER DIA WITH MATERIAL GRADE PE100/PN6

MAKING OPEN TRENCH AFTER BREAKING CC SURFACE IN HARD ROCKY SOIL AT A DEPTH OF 1.5 MTRS BELOW GROUND FOR 11 KV CABLE LAYING.

LAYING OF HDPE PIPE INCLUDING COST OF HDPE PIPE WITH SUITABLE OUTER DIA MATERIAL GRADE PE100/PN6

LAYING OF 33 KV CABLE IN LOOP, RISER AND HDPE PIPE ETC

SUPPLY AND FIXING OF EARTHING FOR CABLE AT DIFFERENT POLE STRUCTURE BY 450X450X10MM G.I. PLATE VERTICALLY 3M BELOW THE GROUND LEVEL WITH ALTERNATE LAYERS OF CHARCOAL & SALT ATLEAST 200MM THICK AROUND CONNECTED WITH G.I STRIP RUNNING TILL TOP OF POLE COMPLETE.

FIXING OF MS CHANNEL, ANGLE AND ALL ACCESSORIES ON EXISTING / NEW DOUBLE POLE

FIXING OF MS CHANNEL, ANGLE AND ALL ACCESSORIES ON EXISTING / NEW SINGLE POLE

FILLING & FIXING OF 11KV END TERMINATION CABLE JOINTING KIT (O/D & I/D)

FILLING & FIXING OF 11KV STRAIGHT THROUGH CABLE JOINTING KIT

MAKING PITOF SIZE 5X2X1.2 MTR FOR FILLING AND FIXING OF 11 KV STRAIGHT THROUGH JOINT KIT WITH BACK FILLING, RAMMING COMPACTION UPTO COMPLETE RESTORATION

SUPPLY AND FIXING OF 11 KV RCC ROUTE MARKER

FIXING OF DANGER/NUMBER/NAME PLATE

MAKING 11 KV SECTION POLE

MAKING OF BUS BAR CONNECTION

MAKING AND INSTALLATION OF FUSE SET

INSTALLATION OF VERTICAL TYPE ISOLATOR ON EXISTING OR NEWLY ERECTED DP

LAYING & SAGGING & COMPLETE JUMPERING OF 11 KV LINE WITH ACSR DOG CONDUCTOR

FIXING OF TRIANGULAR TYPE BRACKET IN 11 KV LINE

SUPPLY AND INSTALLATION OF RELAY FOR 11 KV OUTGOING FEEDER PANEL

FINAL TESTING of CABLE AND PANEL BEFORE ENERGIZING THE CABLE

DISMENTAL OF ST POLE SP-55 (SINGLE)

DISMENTAL OF ST POLE SP-55 (DP)

DISMENTAL OF EXISTING HT LINE INCLUDING DISC FITTING, INSULATOR, CLAMP, NUT BOLTS

DISMENTAL OF 11 KV 3 WIRE ACSR CONDUCTOR

BACK CARRTIGE OF FOLLOWING FROM SITE TO JE STORE CENTER

STP POLES SCRAP

ACSR CONDUCTOR

OTHERS STOCK MATERIALS MS SCRAP, INSULATORS

P M ELECTRICAL COMPANY

Modern Electric Company