Design, manufacture, supply and commissioning of HDPE floating Jetties/decks for River Jhelum at specified spots from Pantha Chowk to Chattabal Weir Srinagar. (Fresh of E-NIT No. (23) of 2019-20

Amount

1. Providing / Procurement and Installaation /Mooring of floating jetty with the following technical Specifications :- • The Boat Parking Module should be made of High Grade High Density Polyethylene whose melt flow rate should be less than 3 g / 10 min @190˚ C & 21.6 kg • Boat Parking Module should be of L:50 cm, B: 50 cm, H; 40 cm • Weight of the Boat Parking Module should be 8-9 Kgs • Load Carrying Capacity should be Minimum 350 Kgs/Sqm • The shape of the Boat Parking Module should be 3 dimensional such that the Boat parking Module can interlock by themselves. • Each Boat Parking Module should have a Anti-Skid Top Surface as an Integral part of it. • The top surface should be fitted inside the side walls of the Boat Parking Module and it should be bolted in such a way that there is no leakage of water from the point in which bolt is fixed between top & below surface thus making the surface the best Anti Skid Surface available worldwide. • There should be one more Surface below the top surface with a gap in between top surface & surface below to enable expansion contraction of Boat Parking Module which can also be used for Passing of electric cables & water houses if required. • The lug thickness of the Boat parking Module should be 21 -22 mm to ensure sufficient strength to the structure. • For step formation on Floating dock for ease of berthing 5 Square meter of HDPE Boat Parking Module of dimensions 0.5x 0.5 x 0.25 , weight 5.5 kg (+/-5%) male female interlocking modules should be provided.( as per requirement at site.) • For Boat Parking U Modules (HDPE) of dimension 1.0m x 0.5m x 0.28 9(±5%) of Min weight 11.5 kg.should be used (( as per requirement at site.) Note : 1) Test certificate of Melt Flow rate of raw Material should be submitted along with Technical Bid from CIPET India or any reputed research centers which are acceptable internationally. 2 ) Proof of Purchase of raw Material from the Manufacturer needs to be submitted along with Technical Bid whose Melt Flow Rate Certificate is submitted. 3) Sample of all types of Modules should be submitted along with Technical Bid for Physical Technical Verification.

Litmus Marine Innovation P Ltd