SUPPLY, INSTALLATION AND COMMISSIONING OF DEVICES, MACHINERIES, EQUIPMENT AND TOOLS, ETC. IN LABORATORIES AND WORKSHOP OF JANGIPUR GOVERNMENT POLYTECHNIC

Profometer Rebar Diameter Cover Meter and Corrosion analysis

Electrically operated Analog Compression Testing Machine 2000 kN capacity

Cannon Manning cum Cannon Fenske Viscometer bath with Vacuum Pump

Hand Operated Soil Sample Extruder

Standard Penetration Test Apparatus

Turbidity Meter

Multiparameter pH/ORP/EC/TDS/Salinity/DO/Pressure/ Temperature Waterproof Meter, 10m cable

COD Digestor compatiable for Multiparameter photometer moel no HI83399(Hanna)

Bacteriological Incubator

Laminar air flow with UV Lamp

Universal Water bath

Gutzeit Apparatus (Glass)

Desiccator

Thin Layer Chromatography Kit

Arsenic Kit

DO Meter

Digital Thermometer

Set up to determine and verify the time period of oscillation of a cantilever

Set up to convert a galvanometer into an ammeter.

Kit to verify Kirchhoff’s law using electrical circuits

Instrument set up to Test the performance of speaker

Instrument set up to study the internal layout of black and white TV receiver.

Instrument set up to: - a)Study the internal layout of colour television, b)Fault finding in given Colour TV :i) No colour ii) Red b)Colour only iii) Blue colour only iv) Green colour only v)Magenta colour only vi)Cyan colour only vii)Yellow only viii)No raster, No Sound. c) Measure voltage level to sketch composite video signal at different stages of TV receiver.

Instrument set up to find the maximum range of a RADAR (using simulation software)

Instrument set up to Built-in LED state control by push button sketch implementation (Arduino) 5 Built-in LED blinking sketch implementation (Arduino) 6 Built-in LED blinking by toggling states based on binary operation (Arduino) 7 Controlling multiple LEDs with a loop and an array (Arduino) 8 Use a potentiometer to control the blinking of an LED (Arduino) 9 Temperature monitor using LCD display and LM35 (using Adrino )

Instrument set up to study drain and transfer characteristics of FET

Instrument set up to study drain and transfer characteristics of JFET

Instrument set up to study the input and output characteristics and to determine the h-parameters of a BJT for : — (a) C-E configuration, (b) C-B configuration, (c) C-C configuration

Instrument set up to determine frequency response characteristics of RC coupled amplifier circuit and calculation of bandwidth, midband gain, input impedance and output impedance for : (a) Single-stage amplifier, (b) Double-stage amplifier

Instrument set up to study the rectifier with and without capacitor filter for : — (a) Half-wave rectifier, (b) Full-wave rectifier

Instrument set up to study the operation of Oscillators (any two) using OPAMP - a) Hartley, b) Colpitt, c) Wein-bridge, d) Phase Shift, e) Crystal

Instrument set up to study the operation of Voltage to Frequency converter

Instrument set up to study the operation of low-pass, high-pass and band-pass Butterworth filters

Instrument set up to study the applications of op amp IC 741 as a) clipper b)clamper c)Schmitt trigger d)voltage follower

Instrument set up for Measurement of strain/force with the help of strain gauge load cell

Instrument set up for Measurement of displacement with the help of LVDT.

Speed Control of DC Shunt motor(both Armature voltage & flux control included)

3phase Delta manufactored Variable voltage & variable Frequency Drive(VFD)

Dynamic braking of three phase squirrel cage induction motor using contactor control.

Analog tachometer

Use dual trace oscilloscope to determine AC voltage & current response in given R,L,C circuit

Use variable frequency supply to create resonance in given series and parallel R-L-C circuit or by using variable reactor or variable capacitor

Perform experiment to measure thermal performance of a solar water heating system

Allen Bradley Micrologix 1400 PLC with software

Storage Water Cooler with in-built RO+UV Purifier

ABC Type Dry Powder Portable Fire Extinguisher -6kg

ABC Type Dry Powder Portable Fire Extinguisher -4kg

ELECTRO-SYS (BID ID -6078411)