WBPWD/SE/SEC/NIT-24/19-20 3rd call

Amount

1. SITC of Automatic Lift ( as per manufacturer design & as per detailed specification below conforming to IS ) and putting into operation after final testing in the existing lift shaft complete with all accessories and repairing the damage wall / floor if any etc to complete as reqd. 1.01 Make : OTIS / KONE / SCHINDLER , 1.02 Type: Passanger Lift . 1.03 Load : 10 Passenger / 680 Kg . 1.04 Control: Microprocessor based with AC variable voltage & variable frequency ( VVVF), 1.05 Machine:- Energy efficient machine, Geared, with Machine Room. 1.06 Position of Machine Room: Directly above the lift shaft. 1.07 Speed: 1.0 Mtrs./ Sec , 1.08 Floor served: G + 4. ,1.09 Landing:5 Stop/5 Opening,, all on same side. 1.10 Travel : About 17 Mtrs (Gr. Floor to 4th Floor). 1.11 Operation: Microprocessor based simplex full collective with or without attendant. 1.12 Signals: Digital car position indicator,car travels direction indicator in car & at all landing with call registration indicator. 1.13 Leveling accuracy: ± 5 mm(Micro levelling arrangement ).CAR2 Car inside : 1300 mm ( W ) x 1350 mm ( D ) , 2.01 Car Entrance: Clear Opening 800 mm (W) x 2000 mm (H) protected with car door. , 2.02 Car Enclosure: Stainless Steel sheet (20 SWG) with Hairline finish with hand rail. 2.03 Car Ceiling & Lighting: Stainless Steel with hairline finish with LED lighting and Fan, 2.04 Car Ventilation: Pressure fan with anodised aluminium grill. 2.05 Car Flooring : Car flooring : Decorative granite flooring (As per direcion of EIC and according to this Department's Order). 2.06 Car Door: Stainless Steel centre opening automatic door provided with V3F controlled door drive system , 2.07 Landing Door: Stainless steel centre opening automatic door provided with V3F controlled door drive system 2.08 Door Opening: Automatic power oprated door with full length Photocell assembly light curtain sensor. PROTECTIVE DEVICES & OTHER ACESSORIES3.00 ARD: Automatic rescue device complete with dry maintenance free batteries as required.for automatic evacuation to the nearest floor in case of power failure / single phasing/others. 3.01 Overload Protection: Fully loaded with overload protection. On overloading the lift car will not start with door remaining open and give audio display indication.3.02 Emergency lighting in car: Battery operated emergency lighting in the lift car. 3.03 Intercom system: Battery operated intercom system in Lift Car, Machine Room & Control Room. 3.04 Emergency Alarm: Battery operated alarm bell system in lift car and control room. 3.05 Fireman switch: Fireman switch at main landing terminal. 3.06 Voice Synthesizer: Voice announcement system (Voice Synthesizer) in the car to announce the position of the elevator in the hoist way as the car passes or stops at a floor served by the elevator. 3.07 Main rope / Belt - As per manufacturer's standard conforming to IS DIMENSION OF SHAFT & POWER SUPPLY 4.00 Available Shaft Dimension: 1900 mm (W) x 2150 mm (D) 4.01 Pit Depth :1500 mm . 4.02 Overhead : 4400 mm. 4.03 Electric power supply: AC 415 Volt 3phase, 50 Hz, terminated in machine room as per IS N.B. : Rates should be quoted with minor civil works, wall cutting and mending good the damages to the original finish. The bidder shall confirm to give product warranty for a period of 3 years after handover the installation