Reconductoring of LT lines UNDER NARAYANKULAM TRANSFORMER AREA under Electrical Section Pappinisseri

Labour charges for loading LT PSC pole from the stacking place and unloading the same at work site (transportation by any vehicle).

Dismantling one damaged LT PSC/RCC pole after disconnecting stays, strut etc. attached thereon and stacking the same.

Providing Strut using LT PSC pole including digging and back filling pit in ordinary soil.

Fitting one LT 2 line cross arm on HT or LT existing poles including fitting insulators and binding the same with LT Line.

Fitting one LT 4 line cross arm on HT or LT existing poles including fitting insulators and binding the same with LT Line.

Transporting one LT PSC pole by Head load - for an average distance of one km where transportation by hand cart is not possible. (normally limited to 0.3km).

Additional rate for excavation of one Pit for LT Pole/LT Stay in Laterite.

Providing WP support with PSC pole including digging & back filling pit in ordinary soil. excluding transportation of poles.

Transporting poles by hired vehicle to a distance upto 5km and carrying upto 4 numbers of poles excluding loading& unloading charges.

Dismantling (without damage) one km LT three phase 4 wire OH line conductor by dismantling cross arms, insulators and stacking the conductors in rolls properly.

Dismantling (without damage) one km LT additional conductor line by dismantling cross arms, insulators and stacking the conductors in rolls properly.

Dismantling (without damage) one km LT single phase 2 wire OH line conductor by dismantling cross arms, insulators and stacking the conductors in rolls properly.

Providing Stay for LT poles including digging & back filling pit in ordinary soil.

Transporting LT ABC by hired vehicle to a distance up to 5 km and carring up to 2 drum including loading and un loading using crane

Stringing of 1.1 kV Aerial bunched cable of size 3 x 70 + 1 x 16+1x 50 sqmm with bare/insulated Messenger through existing poles

Fitting one No. Section fuse on LT line with dropping cables, crimping sockets, connecting with bolt & nut etc.

Disconnecting and lowering down the single phase WP service connection with guy wire from the OH line and reconnecting the same after completing the line work.

Disconnecting and lowering down the three phase WP service connection with guy wire from the OH line and reconnecting the same after completing the line work.

Stringing of 1.1 kV Aerial bunched cable of size 3 x 50 + 1 x 35 + 1 x 16 sqmm with bare/insulated Messenger through existing poles

Erection of Anchor clamp / dead end clamp for LT ABC of any size

Erection of suspension clamp for LT ABC of any size

Installing One No. Insulation piercing connector of size Main :16 to 95 ,Tap:1.5 to 16 Sq.mm

Installation of Insulation piercing connector for main to service line main :16-95 sqmm, Tap 16-95 sqmm

Providing End Caps

Providing Cable Tie

Providing one Earth using GI earth pipe of size 38.1mm dia, 2.5m length including digging separate pit (0.45x0.45x2.5m) at a minimum distance of 1.5m away from the pole/structure and maintaining standard distance between different earth pipes in ordinary soil & backfilling.

Please Enable Macros to View BoQ information