Loading…
Loading…
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹2.7 LAccepted-AOC | L1 | Accepted-AOC Accepted Vide Resolution No.7(2) dtd.24-02-2025 of Kodumbu GP | |
| 2 | L2₹2.8 L+₹5,404.18 (1.97%)Rejected-AOC | L2 | Rejected-AOC Higher rate and hence not admitted | |
| 3 | L3₹2.8 L+₹10,476.80 (3.83%)Rejected-AOC | L3 | Rejected-AOC Higher rate and hence not admitted | |
| 4 | L4₹2.9 L+₹17,999.01 (6.58%)Rejected-AOC | L4 | Rejected-AOC Higher rate and hence not admitted |
Tender Value
₹2.5 L
EMD Value
₹6,342
Closing Date
22 Feb 2025, 5:00 pmClosed
ATHIRA R KUMAR
O/O THE ASSISTANT ENGINEER,LIDEW SECTION
TRUSS WORK TO CHEMBADAM ANGANWADI (P No.74/25)
2025_LSGD_737527_2
ET03/AE/LIDEW/KDB/24-25
Open Tender
Civil Works - Buildings
Item Rate
240 days
KODUMBU GP
Please refer Tender documents.
7 documents required · 7 mandatory
₹560
Yes
₹6,342
Yes
8 Apr 2025
14 Feb 2025
24 Feb 2025
14 Feb 2025
22 Feb 2025
14 Feb 2025
Amount
Anganwadi Renovation
10.16.1:Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished welded type tubes
12.50:Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%), total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling/self tapping screws of size (5.5x55mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.
5.9.1:Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete
4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)
10.25.2:Item Shifted to Sub head 14 as item 14.73 Item Shifted to head 14 as item 14.74 Steel work welded in built up sections/framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required.In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works
50.6.2.2:Solid masonry using pre cast solid blocks (factory made) of size 30x20x15cm or nearest available size confirming to IS 2185 part I of 1979 for super structure up to floor two level with thickness 15cm in : CM 1:6 ( 1 cement : 6 coarse sand) etc complete
13.1.1:12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand)
SUNDARAN K (BID ID -2121357)
P.K.SIVADAS (BID ID -2122059)
ABOOBACKER (BID ID -2121815)
Bidder Name
P.K.SIVADAS
HITECH CONSTRUCTION
SUNDARAN K
ABOOBACKER
tech_eval.pdf
fin_eval.pdf
aoc.pdf
boq_comp_chart.xlsx
xlsx
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .