SPL REPAIR TO ROAD AND RETAINING WALL OF BRIDGE NEAR BIJAPUR FILTRATION PLANT UNDER GE DEHRADUN

Amount

Excavating over areas, n exc 1.5 m deep and getting out soft/loose soil by mechanical plant complete all as specified and directed.

Excavating over areas, exc 1.5 m and n.exc 3.0 deep and getting out hard/dense soil mechanical plant complete all as specified and directed.

M & L for cement concrete (1:4:8), type D-2 as in foundations, filling and mass concrete complete all as specified and directed.

RM&L for repair to pot holes any depth, not exc 1.00 sqm each including sweeping free from dust and mud or water, scoring sunken surfaces in roads, paths etc, cutting around edges to at least 25 mm thick in depth, making good by applying tack coat with paving bitumen @ 5kg per 10 Sqm, putting in premixed bituminous macadam, well rammed and sealed with binder 9.8 kg per 10 sq m, blinded with 0.09 cum of stone chippings, 6.3 mm size and again well rammed (including supply of premixed macadam, binder and chippings) depth of potholes n exc 30 mm complete all as specified and directed.

M&L for preparation of road surfaces and applying thermoplastic reflective paint in marking of minimum 2.5mm thick single coat as in center line and edge line road marking of 150/100 mm width using 'HOT MARK' thermoplastic paint (hot application) white/ yellow by indigenous modern propelled road marking machine as directed including all ingredients such as blinder, glass beads Titanium dioxide calcium carbonate inter fillers, thermoplastic requirement for glass beads shall be the table specification including spraying of glass beads etc all as per manufacture instructions complete all as specified and directed.

S&F mild steel TMT bar 5mm dia and over up to and including 10mm dia in stirrups, spacers and binders cut to length, bent to shape required, including cranking, bending, spirally for hooping for columns, hooking ends and binding with and including MS wire (annealed) not less than 0.9 mm dia complete all as specified and directed.

S&F mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or complete all as specified and directed.

M & L for reinforced cement concrete, M-25, using 20mm graded stone aggregate as in foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete complete all as specified and directed.

M & L for reinforced cement concrete, M-25, using 20mm graded stone aggregate as in walls, retaining walls, basement walls, ballast walls and the like; any thickness; above top of footings; including attached pilasters and buttresses complete all as specified and directed.

M&L for use and waste formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter etc complete all as specified and directed.

M&L for use and waste formwork to faces of walls, retaining walls, abutments parapets and staircase railings and similar work including attached pilasters, buttresses, & fair finished surface etc.; vertical or to batter etc complete all as specified and directed .

M & L for boulder filling dry, hand packed tightly, as in wire crate apron bunds (Wire crate measured separately) etc complete all as specified and directed.

S & F Chain link MS galvanised fencing of mesh size 100mmx100mm and dia of wire 4.00 mm specification as specified in SSR Pt-I complete all as specified and directed.

S & F 110mm dia PVC (SWR) pipes, single socketed, in any length, with rubber rings etc complete all as specified and directed.

M&L for preparation of new concrete surface of wall and applying two coats of cement base paint complete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exc 25 cm etc complete all as specified and directed.

Removing excavated material n exc. 50m and depositing where directed at a level n exc. 1.5 m above the starting point etc complete all as specified and directed.

V S ENTERPRISES

M.K Engineers

M/s Himanshu Tyagi

M/S VIJAY TRADERS

M/S C S AITHANI

Gupta Brothers

M/s RAM RATAN AND SONS