Loading…
Loading…
Tender ID
Tender Value
₹56.4 L
EMD Value
₹1.4 L
Closing Date
6 Feb 2026, 1:00 pmClosed
Secretary
Office Of Kadalundi Gramapanchayath, Chaliyam PO
Retender - MGNREGS Material Supply
2026_DP_831401_1
MGNREGS/73/2026
Open Tender
Civil Works - Others
Supply and Service
Kadalundi
Please refer Tender documents.
2 documents required · 2 mandatory
₹1,534
Yes
₹1.4 L
Yes
28 Jan 2026
28 Jan 2026
9 Feb 2026
28 Jan 2026
6 Feb 2026
30 Jan 2026
28 Jan 2026 - 30 Jan 2026
Stone Aggregate(single size): 06 mm nominal size
Stone Aggregate(single size): 10 mm nominal size
Stone Aggregate(single size): 40 mm nominal size
Stone Aggregate(single size):20 mm nominal size
Stone for masonry work
Portland Cement
Hollow blocks of size 40x20x20cm
Interlocking C.C. paver block (80 mm thick, M-30)
Laterite stone of size 35x20x20cm
Quarry Waste
Royalty for good earth
Twisted steel/deformed bars
Fine sand (zone IV)
Coarse sand (zone III)
PVC pipe 75 mm outer dia 4 kgf/cm2
Structural steel such as tees, angles, channels and R.S. joists
Galvanised wire mesh of average width of aperture 1.4 and nominal dia. of wire 0.63 mm
GI trafford profile sheet 0.35mm thick
M.S. Tube 40 mm dia
Mild steel tubes hot finished welded type
Wire nails
Red oxide Zinc chromate primer
Bitumen washer
welding by electric plant
Corner angle 45x45x5 mm 1.50 m long
Double clip (bridge clip)
Single clip
wall form panel 1250x500 mm
100MMCHANNEL SHOULDER 2.5M LONG EACH
Adjustable span ESO+SI (2.35- 3.40)
Adjustable telescopic prop 3 m (2.02-3.75m)
Water thinnable cement primer for interior wall surface having VOC content less than 50 gms/litre
Stainless steel screw 50 mm
Flats up to 10 mm thickness
Pulley 40 mm dia
Beam clamp 300-380 mm (450-1070 mm)
Second class kail wood in planks
Second class kail wood in scantling
Hollock ballies 125 mm diameter
Water proof ply 12 mm thick
Bolt and nuts up to 300mm in length
Average rate of mild steel round bars for reinforcement
Mild steel round bar 12 mm dia and below
24mm thick factory made shutters with styles,rails and panels of pvc ectruded sections in white , grey or wooden sections
48 mm *40mm*1.5mm thick Factory made door frame of PVC extruded sections in white ,grey or wooden finish
Ceramic glazed tiles 1st quality minimum thickness 5mm in all colur shades and designs except burgundy , bottle green black
Vitrified floor tile 60*60 cm
High polymer modified quickset tile adhesive
White cement based putty
Black plastic seat (solid) with lid c.p brass hinges and rubber buffers
Virteous china pedestal type watecloset
Flushing cistern P.V.C 10lts capacity (low level)(white) (with fittings ,accessories and flush pipe)
Stainless steel kitchen sink - without drain board 470*420 mm bowl depth 178mm
C.I bracket for wash basin and sinks
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Tendernotice_1.pdf
PDF • 0.47 MB
BOQ_1396941.xls
BOQ • 0.35 MB
EPAYMENT.pdf
Tender Documents • 0.24 MB
NIT.pdf
Tender Documents • 0.46 MB
AFFIDAVIT.pdf
Tender Documents • 0.24 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .