General Funds

Providing and laying of Hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35 .The material should be Berger company/Berger equivalent and must comply with the following a) white index for the product should be in the range of 60-70 when measured against standard reference.The applied panel 7/8 number must be submitted for checking up the white index in the department lab.In case the departmnt approves the white index of any vendor,the department engineer may carryout random checking of the applied products at site against the approved panel.In case of any major deviation beyond acceptance limit,department reserve the right to cancel or reject the total supplied consignment of the said material and will compell the vendor to replace the fll consignment by the desired material as per approved panel at his own cost and additional demurrages may be claime due to lossof man days (as per the rules of the dept.)b)Luminance factor of the material should be in the range of 80-85% at 45 degree centigrade as per AASTHOM 249.c) Crack resistance:The applied panel cured for 7 days under ambient conditions and the should be tested as per BS3262 part-1,1989 and should pass at the range of '0' degree centigrade-'10' degree centigrade.D) Adhesion: Strong E) Softening point:102 degree centigrade.F) Dried film finish: Smooth and uniform G) Night vision:High as directed by the Engineer-In-Charge and confirming to IS 164-1961 (1st revision reaffirmed in 1986) and clause confirming to IRC 35-1997.