Pending civil works to be done at the risk and cost of M/S JSL at 400KV S/S Rajpura

Amount

Earth Work in Excavation in foundation trenches etc. in all kinds of soil where pick jumper work is not involved and not exceeding 2.0 metres depth including dressing of bottom and sides of trenches , stacking the excavated soil clear from edge of excavation and subsequent filling around masonary in 15 cm layers with compaction including disposal of all surplus soil as directed with in lead of 30 metres.

Dismantling concrete -Cement concrete plain 1:4:8 or 1:5:10

Dismantling concrete -Cement concrete plain1:2:4 mix

Dismantling concrete -Reinforced cement concrete

Scraping-Cement plaster

Dismantling of brick work in cement sand mortar / lime mortar including T&P scaffolding wherever necessary, sorting the dismantled material, disposal of unserviceable material. & staking the serviceable material with all lifts & lead of 100 metre (By Mechanical Means)

Shuttering for faces of concrete fdns and fdns. Beam & Plinth Beam.

Centering and shuttering for flat surfaces such as suspended floors, roofs, landings, chajjas, shelves etc.

Shuttering for precast and plain or Reinforced concrete blocks, wall plates, bedplates, shelves etc.

Cement Concrete 1:8:16 with stone aggregates 40mm gauge(mixing by mechanical means using Concrete mixer volumetric type.

Cement Concrete 1:6:12 with stone aggregates 40mm gauge(mixing by mechanical means using Concrete mixer volumetric type.

Cement concrete 1:4:8-With stone aggregate 40mm gauge-mixing by mechanical means using concrete mixer volumetric type

Cement Concrete 1:2:4 with stone ballast or shingle(mixing by mechanical means using Concrete mixer volumetric type.

Reinforced cement Concrete M-20 mechanically batch mixed IN Fdn/Plinth using batch type Concrete mixer as per IS:791 and vibrated by needle vibrator but excluding steel reinforcement centering and shuttering in foundation and plinth.

Reinforced cement concrete M-20 mechanically batch mixed using batch typeconcrete mixer as per IS:1791 and vibratedby needle vibrator but excluding steelreinforcement centring and shuttering in superstructure.

Preparing watering and ramming surface for laying concrete-Horizontal

First Class Burnt Brick Work laid in cement sand mortar 1:6 in Foundation and plinth.

First Class Burnt Brick Work laid in cement sand mortar 1:5 in first storey up to 4metres above plinth level.

First Class Burnt Brick Work laid in cement sand mortar 1:4 in fdn

115mm Thick Brick Wall in cement sand mortar 1:4 without reinforcement in Foundation and plinth.

Terracing consiting of tiles 22.86x11.43x3.83cm laid over 25 mm mud plaster 7.5 cm mud filling on another layer of 25mm mud plaster including two coats of bitumen laid hot at 1.65 Kg. /Sqm top of R.C.C. slab including grouting with cement sand mortar 1:4 and top surface to be left clean after wire brushing

Top Khurra 0.6mx0.6m for rain water pipe in 25mm thick cement concrete 1:2:4 over 50.00 thick cement concrete 1:8:16

Cement concrete 1:2:4 gola 10cm x 10cm concave quadrant along junction of roofs with parapet wall finished smooth, where specially specified.

Conglomerate floor 25mm thick cement concrete topping 1:2:4 using mechanical mixer for mixing of material.

Conglomerate floor 50mm thick cement concrete topping 1:2:4 using mechanical mixer for mixing of material.

Providing and laying vitrified floor tiles of different sizes in light colour shades made using Double Charge technology (thickness to be specified by the manufacturer) with water absorption’s less than 0.08% and conforming to IS : 15622 of approved make in all colours and shades, laid on 20mm thick cement mortar 1:4 (1 cement: 4 fine sand), complete.-Size 600x600 mm

Providing and fixing 1st quality ceramic glazedwall tiles Matt/Semi Matt/Glosy/Highly lossfinish/Highlighter/emboss conforming to IS :15622 (thickness to be specified by themanufacture of approved make in all colours, shades except burgundy, bottle green, black ofsize 600 x 300 mm as approved by Engineer-in- Charge in skirting, risers of steps and dados over 12 mm thick bed of cement Mortar 1:4 (1 cement: 4 fine sand) and jointing with grey cement slurry @ 3.3kg per sqm including pointing in white cement mixed with pigment of matching shade complete.

Providing and laying 60 mm thick factory madecement concrete interlocking paver block of M-35grade mahine made rubber moulded smoothfinish with strong vibratory process or with vibrohydraulic compaction machine and of approved size and design / shape laid in Ordinary Grey and pattern over and including 40 mm thick compacted bed of coarse sand, filling the joints with fine sand etc, all complete as per directions of Engineer-in-Charge IS Code 15658 :2006

12.5mm Thick Cement Plaster 1:4

12.5mm Thick Cement Plaster 1:5

12.5mm Thick Cement Plaster 1:6

20 mm Thick Cement Plaster 1:5

Painting two or more coats with synthetic enamel paints in all shades on old wood work or metallic or plastered or concrete surface to give an even shade including rubbing down old paint.

Applying priming coat with cement primer in all shade on newly plastered or concrete exterior surface

Applying priming coat with metal primer on new steel or iron work including preparation of surface.

Painting two or more coats excluding priming coat with ready mixed paint for metallic surfaces in all shades on steel or iron work

Finishing walls with acrylic smooth exterior paint of required shade with two or more coats applied @ 1.67 litre/10Sqm over and including base coat of water proofing Cement Paint applied @ 2.20 Kg/10 Sqm

Wall painting with plastic emulsion paint of approved brand and manufacturer to give an even shade (two or more coats)

Preparation of plastered or concrete surface for painting (including sand papering the surface) using ready mixed cement based wall putty by applying two or more coats to get required finish

Structural steel work in angles, tees, flats, riveted, including cutting, fixing all gusset plates, bolts, nuts, rivets etc. with hoisting and erecting in position.

Structural steel work in girders or Stanchions built up of one joist / or channel section. Riveted including cutting and fixing old gusset plates bolts, Nuts, Rivets etc. complete with flange plates, head, sole plates, angle connections etc. with hoisting & erecting in position

Supplying and fixing rolling shutters, of approved make, made of 0mmx1.25mm, M.S. Laths, interlocked together through their entire length and jointed together, at the end, by end locks, mounted on specially designed pipe shaft, with brackets, side guides, 27.5cm long wire spring grade No. 2 and rrangement for inside and ouside locking with push and pull operation complete, including top cover 0.80mm thick

Cold Twisted deformed BarsFe500 for RCC works where not including in complete rate of RCC including bending ,binding and placing in position Complete.

Supplying and fixing glass panes with glazing clips and special metal sash putty of approved make.-Glass panes 4mm

Providing & fixing T-iron frames for doors, windows and ventilators of mild steel Teesections, joints mitered and welded with 15x3mm lugs, 10cm long embedded in cement concrete blocks 15x10x10 cm of 1:3:6 or with wooden plugs and screws or with dash fastener or rawl plugs and screws or with fixing clips or with bolts and nuts as required including fixing of necessary butt hinges and screws and applying a priming coat of approved steel primer.

Providing, laying, spreading and compacting graded stone ggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant, laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density complete as per technical clause 406 of MORT&H specifications

Providing and laying factory made rubber moulded smooth finish cement concrete Kerb M-20 grade 250mm high with bottom width 165mm and top width 115mm made over strong vibratory table and fixing with cement mortar 1:2 as per MORT&H specifications

Providing and filling joint sealing compound with coarse sand and 6 percent bitumen by weight complete as per drawings and technical clause 2605 of MORT&H specifications

Providing and fixing in position gratings 150mm x 150mm for gully trap.-H.C.I. grating including painting with black bitumastic superior paint of approved manufacture three coats.

Regrading terracing of mud plaster covered with tiles or bricks in cement by dismantling tiles or bricks, removing mud plaster, preparing the surface of mud plaster to proper, slope, relaying mud plaster Gobri leaping and tiles or bricks grouted in cement mortar 1:3 (1 cement and 3 fine sand) including replacing unserviceable tiles, or bricks with new over and disposal of unserviceable material to the dumping ground within 50 m lead (The cost of new tiles or bricks excluded).

Earth work containing Gravel (in loose from in non cohesive binding material) work in excavation with occasional use of picks exclusive of compensation of earth undressed with combined lead upto 15 metres with percentage of gravel or Kankar.-Exceeding 80 % but upto 100 %.

Screening ,Stone ballast, shingle or kankar (Labour only).

Stacking within 15 metres of the nloading points into stacks of specified sizes.-Pitching stones, spalls brick bats building stone ballast, stone metal, sand bajri and shingle

Respreding stone gravels in yard area (Labour rate)

NON SECHDULED RATES

Providing & Fixing Chain linked fencing with 50 mm dia MS pipes, Chainlinked fencing of 10 SWG of 75x75 mm mesh welded on frame of MS flat 50x6 mm, fixed with nut bolts as per drawing

Supplying & spreading of crushed stone ¾” nominal size (20mm)in 4” (100mm) thick layer in the switch Yard Area marked or as per direction of the Engineer-In-Charge i/c levelling & removal of grass at site.

Flooring of Cement Concrete 1:5:10 with crushed stone 20 mm size mechanically mixed laid in 75 mm thickness in blocks of size 3.0mx3.0m using shuttering complete in all respect including preparation of surface for laying concrete.

Providing & Laying of cement Slurry of cement to sand ratio 1:6 using cement content not less than 150kg per 100 Sqm area complete.

Earthfilling in yard area and approach road including watering, rolling & compactions as per specifications and lead upto 5 KM

Adjusted/Landing Rates (i/c the effect of extra carriage and difference of quarry rates wherever applicable)

Cement

Steel

Fine sand

Bricks

Coarse aggregate 13.2/12mm

Coarse aggregate 11.2/10mm

Coarse sand

Stone metal 40mm

Bidder Name

Amount in Words

Mahesh Kohli Goverment Contractor

G.S.Construction Co.

M/s Mukul Kumar Prajapati

Mahesh Kohli Goverment Contractor

M/s Mukul Kumar Prajapati