Providing and fitting fixing of wooden decorative glazed doors, chairs, table along with floor carpet, inside painting of house etc of Tripura Legislative Assembly building under Capital Complex Sub-Division-I, Kunjaban Extension, Agartala during the

Removing dry or oil bound distemper, water proofing cement paint and the like by scrapping, sand papering and preparing the surface smooth including necessary repairs to scratches etc. complete.

Distempering with 1st quality washable acrylic distemper of approved brand and manufacture and of required shade on old work ( one or more coats ), to give an even shade as required complete as per direction of the Engineer in char

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framedand fixed in position : Local Teak Wood

Providing and fixing wooden moulded corner beading of triangular shape to the junction of panelling etc. with iron screws, plugs and priming coat on unexposed surface etc. complete Gamair wood. 50x50 mm (base and height).

Providing and fixing carpet over existing marble floor in assembly well in/c cost of 4mm thick foam backing and adhesive complete in all respect

Polishing in high gloss/matt finish melamine clear polish on wood work in required color/wooden shade texture with following process in the sequence as detailed below : [Payment shall be made after submission of Test Certificate issued by the Manufacturer]. 1. The surface to be polished is rubbed with sand paper 80/120 no. and then with sand paper of 160/180 nos. 2. Applying two coats of sealer with spray gun and allowing sufficient drying time for 1st coat and 2nd coat is allowed to dry for 8 to 12 hrs. 3. On drying of sealer coat, wet rubbing with emery cloth of finer grading with ample water to remove excess sealer layer and make the surface further smooth after this wet rubbing, then surface is applied with special grade melamine fillers to fill all the small and big holes/grooves etc. Filler coat to be allowed to dry for 4 to 6 hrs on which again a light wet rubbing is done this surface is further allowed to dry for 12 hrs. 4. On this, 1st coat of melamine polish is applied with spray gun using melamine clear polish and melamine thinner in required proportion. This 1st coat is allowed to dry for 24 hrs then this dry surface is again fine wet rubbed smooth, which is further allowed to dry for 12 hrs. The final melamine polish is applied with compressor pressure spray gun using melamine clear polish and melamine thinner mixed in required proportion complete as per direction of Engineer-in-Charge. (Final coat to be done in 1 or 2 layers without gap of time.)

Providing and fixing glazed shutters for doors, windows and clerestory windows using 4 mm thick float glass (weight not less than 10ks/Sqm) panes including black enamelled ISI marked MS butt hinges with necessary screws. Gamair Wood 35 mm thick

Extra for providing heavy sheet float glass panes instead of ordinary float glass in glazed doors, window and clereslory window shutters (Area of opening of glass panes excluding portion inside rebate shall be measured) 5.5mm thick instead of 4mm thick.

Varnishing with varnish of approved brand and mamufacturer [Payment shall be made after submission of Test Certificate issued by the Manufacturer]. Two or more coats of glue with spar varnish over an under coat of flatting varnish.