CC and Interlocking Tiles work of both sides on Amroha Kailsa Pakbara Road (SH-78)

Excavation for roadwork in soil with hydraulic excavator including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross sections, and transporting to the embankment location within all lifts and lead upto 1000m including all taxes but excluding cost of GST.

Construction of granular sub-base by providing coarse graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401 including all taxes but excluding cost of GST.

Construction of dry lean cement concrete Sub- base over a prepared sub-grade with coarse and fine aggregate conforming to IS: 383, the size of coarse aggregate not exceeding 25 mm, aggregate cement ratio not to exceed 15:1, aggregate gradation after blending to be as per table 600-1, optimum moisture content to be determined during trial length construction, concrete strength not to be less than 10 Mpa at 7 days, mixed in a batching plant, transported to site, laid with a paver with electronic sensor, compacting with 8-10 tonnes vibratory roller, finishing and curing. MORT&H Specification 6.10(601) including all taxes but excluding cost of GST.

Construction of un-reinforced, dowel jointed, plain cement concrete pavement over a prepared sub base with 43 grade cement @ 400 kg per cum, coarse and fine aggregate conforming to IS 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a batching and mixing plant as per approved mix design, transported to site, laid with a fixed form or slip form paver, spread, compacted and finished in a continuous operation including provision of contraction, expansion, construction and longitudinal joints, joint filler, separation membrane, sealant primer, joint sealant, debonding strip, dowel bar, tie rod, admixtures as approved, curing compound, finishing to lines and grades as per drawing including all taxes but excluding cost of GST.

Providing and laying of cement concrete interlocking Brick (Rubber Moulded) having thickness 80 mm (30mpa) as per drawing and technical specifications Clause 1504 including all taxes but excluding cost of GST.

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 (M-10) including all taxes but excluding cost of GST.

RCC work in Grade M-20 in Open Foundation & Sub Structure with cement approved coarse sand & two cm gauge well graded grit including necessary shuttering placing & binding of reinforcement including its binding with wire but excluding cost of reinforcement & also including supply of all material , labour , T & P etc.required for completion of work. As per Case II MORTH specification 1500, 1700 & 2100. SN.12.80 Rates are including all labour, material, T&P, taxes & labour cess but excluding GST. (M-20) including all taxes but excluding cost of GST.

Supplying, fitting and placing HYSD bar reinforcement in sub-structure and Foundation as per drawing and Technical Specification Section As per Reference to MORT&H Specification1600 & 2200 SN. 13.06 including all taxes but excluding cost of GST.

Supply, Laying and Fixing NP-3 Hume pipe of 350 mm dia meter section but including cost of all material, labour, T&P labour, cess, royalty & all taxes etc including all taxes but excluding cost of GST.

Please Enable Macros to View BoQ information