CA NO GE SOUTH AMB 51 2019 2020 CERTAIN MISC REPAIRS TO DRAINS BOUNDARY PILLARS AND FENCING AND SEWAGE CLEANING ETC IN SOUTHERN ZONE UNDER GE SOUTH AMBALA CANTT

Amount

Cleaning of under ground sewer lines of any type and size exc 100 mm dia and n. exc 200 mm dia including manhole upto 2 m depth and removing sludge upto 200 mtr of any type of blockage of anykind of manhole or lines by means cleaning through manually by using bamboos, rodding, including desludging descaling & clear the chocking where ever flushing the entire stretch complete all as specified and directed.

Cleaning of brick/cement concrete drains of any type and size exc and removing sludge to 50 mtr distance complete all as specified and directed.

Removing blockage from WC's, traps (P-trap/floor trap/nahani trap/gully trap etc) inside the buildings at any floor including cleaning and flushing the pipes upto first man hole as of complaints recieved day to day complete all as specified and directed. NOTE : - This item inculdes cleaning of each & pipes of toilet block/kitchen irrespective of length of pipes involved up to first man hole and altogether shall be taken as one job for payment purpose.

Cleaning of manholes/grease traps upto 1.5 metre depth and removal of sludge/silt etc in foul conditions to outside MOD land including testing of manholes by filling with water complete all as specified and directed.

All as per item No 4.00 above but depth exc 1.50 m and not exc 2.50 metre complete all as specified and directed. NOTES for item No 1.00 to 5.00 above: - (i) Contractor shall provide 01 Safaiwala and 01 helper on daily routine basis on commencement of work and they should attend office of Engineer-in-Charge at 0900 hrs to note down the details of complaint for attending the same and shall report at 1600 hrs i.e. is after completion of complaints. (ii) Attendance register shall be maintained in the office Engineer-in-Charge by the JE (Civil) concerned for maintaining daily attendance duly signed by MES Executive. (iii) In case of failure for not providing sufficient manpower by the contractor, a penalty at the rate of Rs. 1000 per Safaiwala per day and Rs 600 per Helper per day shall be levied upon the contractor and recovery for the same shall be affected from contractor's dues. (iv) Particulars and details of Safaiwala & Helper alongwith supporting documents shall be submitted by the contractor to the Engineer-in-Charge immediately after handing over of site.

Demolition of brick work built in cement mortar incl all quoins, pillars arches etc complete all as specified and directed.

M&L for brick work, with sub class 'B' bricks, straight or curved on plan exc 6 m mean radius built in cement mortar 1:6 using old size bricks complete all as specified and directed.

All as per item No 7.00 above but except bricks, using old bricks retrived from dismantling from item No 6 here-in-before, including cleaning, removing mortar from the bricks complete all as specified and directed.

M&L for brick work with sub-class `B' bricks, straight or curved on plan to any radius in half brick thick walls built in cement mortar 1:4 as in drains including nescessary filling & jointing with cement mortar on other side of drain complete all as specified and directed.

All as per item No 9.00 above but except bricks, using old bricks retrived from dismantling from item No 6 here-in-before, including cleaning, removing mortar from the bricks complete all as specified and directed.

M&L cement plaster 15mm thick on fair faces of brick work in cement mortar (1:4) and finished even and smooth without using extra cement complete all as specified and directed.

M&L PCC 1:3:6, type C2 using 40 mm aggregate as in bed of drains complete all as specified and directed.

M&L Cement concrete 1:2:4 , type B-1 using 20 mm graded mechanically crushed stone aggregate as in benching in manholes, coping plinth courses, bands stops etc including necessary form work complete all as specified.

Excavation in trenches, not exceeding 1.5 M wide and not exceeding 1.5 M depth for foundation, etc., and getting out in soft/ loose soil complete all as specified and directed.

Demolition by breaking up salt glazed stone ware drain pipes of any dia jointed in cement mortar and taking out from trenches and preparing the concrete bed wherever required for laying new pipe and removing the debris from site complete all as specified and directed.

Supply and laying salt glazed stone ware drain pipes 150 mm dia (internal) grade 'A' laid in trenches and jointed in cement mortar 1:1 including testing complete all as specified and directed.

Plain cement concrete (1:4:8), type D-2, using 40 mm graded stone aggregates as in concrete bed to drain pipes of 150 mm bore laid to falls in trenches in any depth including packing under and haunching against the sides of pipes with concrete after the pipes are laid and tested complete all as specified and directed.

M&L PCC (1:4:8) type D-2 (using 40mm graded mechanically crushed stone aggregate) as in foundation of manhole complete all as specified and directed.

M&L RCC (1:2:4) type B-1 using 20mm graded mechanically crushed stone aggregate as in precast slab for covers of manholes including necessary form work and placing of manholes cover in position complete all as specified and directed. (Note - The payment shall be made only after placing of cover on manholes).

Demolition of cement concrete (reinforced) as in precast slabs of covers of manholes and removal the rubbish/demolished material outside defence land, complete all as specified and directed.

M&L TMT bars of 6 to 8mm dia cut to length bent to shape required including cranking bending spirally, hooking ends and binding with mild steel wire not less than 0.9 mm dia(annealed) complete all as specified and directed. (Note - The payment shall be made only after placing of cover on manholes).

Returning filling in including spreading levelling, watering and well remming in layers not exc 25cm thick complete all as specified and directed. (Surplus soil if any shall not be removed & left proud over the trench)

Cutting into existing manholes for connecting internal dia of pipe 150mm in new drain, making good to pipe and rendering cutting out existing benching for channel (1/2 or 3/4section) in cement concrete 1 : 2 : 4 type B-1 by repairing benching as required complete all as specified and directed.

Supply only integral water proofing compount (for mixing in cement mortar or concrete) complete all as specified and directed.

Removing excavated soil n.exc. 50m and deposited where directed at a level n.exc. 1.5m above the starting point complete all as specified and directed.

Demolition cement Concrete (unreinforced) of any description and in any position not otherwise specifically provided for complete all as specified and directed.

Material and labour for plain cement concrete 1:2:4 type B-1 (using 20mm graded mechanically crushed stone aggregate) as in surface channels and drains, complete all as specified and ditected.

Extra for forming fair finished drain or channel 30cm inner girth in cement concrete, using extra cement, including forms, moulds , mitred /stopped ends etc., complete all as specified and directed.

Dismantling of chain link fencing/ barbed wire fencing of any description complete all as specified and directed

Dismantling posts or struts (Wood, Steel, RCC) embedded in any surfaces (natural, concrete, masonary etc.) and of any description, any section, taking out embedded portion and making good to disturbed ground surface , complete all as specified and directed .

M&L for plain Cement Concrete type C2 1:3:6 (using 40 mm graded stone aggregate) in foundations, filling and mass concrete complete all as specified and directed.

Material and labour for steel screw bolts, machine made, dia of neck 11 to 15mm with hexagonal or square head one end and screwed the other or screwed both ends, each screwed end to be fitted with washer and one hexagonal or square nut exceeding 5 cm and not exceeding 10cm long, complete all as specified and directed.

M&L Mild steel round bars 10 mm dia., and over cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with mild steel wire (annealed) not less than 0.9 mm dia., or securing with clips qual complete all as specified and directed.

Supply and fixed mild steel, rolled sections(channel, angle or tee sections) fixed independently cut to ordinary length as in post or struts in fencing,ladder etc. including cutting tops to shape as required , drilling holes, notching for wire etc. including flat iron fillets with nuts and bolts for securing chain link fencing including all necessary drilling, bolting or riveting etc conforming to Fe-410(Gde 250), complete all as specified and directed.

Supply & fixing chain link fencing of 4mm dia mild steel galvanized wire and mesh size 100x100mm, including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wire complete all as specified & directed.

Supply and fixing for galvanized 2 strand, steel barbed wire, 2.24 mm dia barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails, straining bolts, including securing or tying at crossing with & provision of galvanized mild steel wire, staples or steel pins etc (each line of wire to be measured), including dismantling of deterioted barbed wire fencing complete all as specified and directed.

Preparation of new or previously untreated steel surfaces of any description, over 10 cm width or girth, not otherwise described and applying two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer complete all as specified and directed.

Material and labour 75mm thick cement concrete 1:4:8 type D-2 using 20mm graded stone aggregate as in floor, finishing cement concrete surface and even fair with using extra cement, complete all as specified and directed.

Material and labour for laying sand over PCC for cushioning of paver blocks, complete all as specified and directed.

M&L for PVC rubber moulded, dark red coloured with grey cement and red pigment, glossy finished, vibrated machine pressed precast concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 60 mm thickness, M-35 Grade, complete all as specified and directed.

Supply and fixing heavy duty tiles (coloured), good grip series, size 300 mm x 300 mm x 10 mm thick, pattern as approved by Engineer-in-Charge, set, jointed and pointed in neat cement slurry, laid over and including 20 mm thick (average thickness) cement mortor (1:4) bed, complete all as specified and directed. MAKE : - Johnson - Endura, AGI, Grandura or equilavent as specified list of makes as approved bt GE.

Roughening surfaces of old concrete floor by picking, sweeping clean and washing down with water to remove dust etc. including Brushing old cement concrete floor with brushing neat cement slurry with 3.0 kg of cement per sqm complete all as specified and directed.

M&L 100 mm thick Cement concrete type B 2, 1:2:4 (using 20 mm graded stone aggregate) in flooring/ hard standing finishing the surface even and smooth without using extra cement laid in alternate bays complete all as specified and directed.

Dismantling floor, hearth or wall tiling including cement mortar bedding (but not backing), removing serviceable tiles to store and rubbish off the premises complete all as specified and directed.

M&L for premium quality coloured (Dark shed) glazed ceramic tiles in vertical surface 300x 200x 7 mm thick set and jointed in neat cement slurry and pointed in white or colour cement to match over and including 15 mm thick screed bed or bedding layers in CM 1:4 complete all as specified and directed.

S&F Kota stone of size 30cmx20cm including writing building No in numbers/alphabhets with black colour synthetic enamel paint, size of each letter 10cm x 5cm on front face, including taking down cement plaster of wall and jointing the stone to wall with cement mortar 1:3 complete all as specified and directed.

S&F Precast Reinforced Cement concrete Type B0 (Using 12.5 mm graded stone aggregate) in 50 mm thick Jallies or louvers including all mouldings complete and set in Cement Mortar 1:4 complete all as specified and directed.

Taking down cement plaster on brick or stone walls, etc., including raking out joints, hacking for key, scrubbing down with water, etc. complete all as specified and directed.

M&L for rendering 15 mm thick on fair faces of brick work or concrete surfaces in cement mortar 1:4 and finished even and smooth without using extra cement complete all as specified and directed.

M&L for preparing new plastered surfaces and applying Two coats of cement base paint over a coat of primer on surfaces of walls complete all as specified and directed.

M&L for PCC in 1:3:6 type C-1 (using 20mm graded mechanically crushed stone aggregate) 50 mm thick as in plinth protection, path, laid in alternate bays etc.finished even and smooth without using extra cement and joints filled with bitumen and sand mixture applied hot complete all as specified and directed.

Material and Labour for providing factory made Precast Cement Concrete kerb stone, 1:2:4 type B1 (using 20mm graded aggregate) with plain fair faces, including chamfers, weatherings, throating etc. and set in CM 1:4 complete all as specified and directed. NOTE : - The minimum size of Kerb stone shall be 300mmx300mmx100mm and shall be embedded in the ground average 10cm deep. The quoted rates includes embedding kerb stone and temping ground around kerb stone and removal of surplus soil, etc.

Preparation of New or previously untreated concrete or plastered surfaces of any description and girth, not otherwise described and applying Two coats of Synthetic Enamel paint (ordinary tint) over a Priming plaster coat complete all as specified and directed.

VIKAS SHARMA

Ashwani Kumar

PARVEEN KUMAR

Gupta Enterprises