Raising of existing boundary wall including barbed wire swan neck fencing at Old Station HQ office complex Kannur and Reconstruction of damaged boundary wall of staff qtrs Of KV Kannur under AGE (I) Cannanore.

Amount

Demolition of brick or laterite stone masonry built in cement or cement lime mortar, including all quioins, arches, pillars, etc, but excluding ashlar facings, dressed stone work and precast concrete article and removing rubbish out side MD landall as directed.

Demolition of cement concrete (un reinforced) in ground floor and paving not exceeding 15 cm thick below or above ground level and removing debris outside MD land all as directed.

M&L for laterite stone masonry, squared rubble, regular coursed, well bonded and solidly hearted , built in CM (1:6) all as specified and directed.

All as per item No 3 here in above but except laterite stone all as specified and directed.

M & L for cement concrete (1:3:6), type C1 (using 20 mm graded stone aggregate) as in coping etc including form work all as specified and directed.

M&L for rendering 15mm thick in cement mortar (1:4) on stone masonry surfaces, finished even and smooth without using extra cement all as specified and directed .

M&L for preparation of newly plastered or un-plastered surfaces of walls and applying 2 coats of cement base paint over alkali resistant primer all as specified and directed..

Taking down cement or cement lime plaster on brick/stone walls incl racking out joints hacking for key scrubbing down with water etc and removing rubbish outside MD land all as specified and directed.

M&L for providing pre-cast cement concrete block masonry with solid blocks, exc.10cm in width with PCC (1:3:6), type C1, using 20mm graded stone aggregate and set in cement mortar (1:6) complete all as specified and directed.

M&L for rendering 15mm thick in cement mortar (1:4) on concrete surfaces, finished even and smooth without using extra cement all as specified and directed .

M & L for cement concrete (1:2:4), type C1 (using 20 mm graded stone aggregate) as in coping etc including form work all as specified and directed.

M&L for preparation of old treated plastered or un-plastered surfaces of walls and applying 2 coats of cement base paint over alkali resistant primer all as specified and directed..

M&L mild steel works as in post and struts in fencing including cutting tops to shape as directed, welding, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe- 410 or Fe-310 all as specified and directed.

M&L galvanised 2 stand, steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacings and straining and fixing to any type of strandard rails straining bolts, including securing or tying at crossings with and provision of galvanised mild steel wire , staples or steel pins etc as directed (each line wire to be measured) all as specified and directed.

Dismantling wrought iron or mild steel work of any description not otherwise provided for except framed truss all as directed.

S&F mild steel framed work as in doors or gates of angle or other section with gusset plates, rails, braces etc complete drilled for fixing of steel sheeting or other covering doors etc to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings(exclusive of steel sheeting or other covering,) and hanging; also fastening and fixing complete conforming to Gde Fe 410-0 or Fe 310-0 all as specified and directed.

S&F for 1.60mm thick, Mild steel, plain, black sheet in wall cladding, steel gates and similar work, cut to size, holes punched; including round headed screws, clout nails or rivets and fixed to wood or steel framing with plain 40 mm lap joints with riveted or welded seams, including bending or turning up, mitred angles, etc. complete all as specified and directed.

M&L preparing new steel surfaces of any description over 10 cm width or girth and applying two coats of synthetic enamel painting over a coat of red oxide primer all as specified and directed.

Yash enterprises