Replacement of ACSR Conductor by 11 KV AAAC AL-59, 99 sqmm. Covered Conductor of 11 KV Himgiri feeder under EDSD, Ganeshpur under EDD, Mohanpur.

Total amount of the "Rate Schedule" sheet

SCHEDULE OF QUANTITY AND RATE FOR REPLACEMENT OF ACSR CONDUCTOR BY 11 KV AAAC AL-59, 99 SQMM. COVERED CONDUCTOR OF 11 KV HIMGIRI FEEDER UNDER EDSD, GANESHPUR UNDER EDD, MOHANPUR AGAINST E-TENDER SPECIFICATION NO.63/EDCRDDUN/2025-26

Name of The Bidder's Firm:

Part [A] (Supply Portion)

Holding Clamp SP-33 With N&B

Holding Clamp for PCC Pole

11 KV IPC for Covered Conductor to Covered Conductor

11 KV IPC for Covered Conductor to Bare Conductor

11 KV Mid Span Jointing Kit

11 KV IPC With Al. Bail for Earthing

11 KV Suspension Ties/Cable Ties on Pin Insulator

11 KV AAAC Covered Conductor AL-59,99 Sqmm

11 KV Tension Clamp with Bail & IPC

Total - Part [A]

Part [B] (Labour Portion)

Cartage of ST pole and PCC Poles from store centre to construction site with loading, unloading at both points and proper stacking. (0-20 Km.)

Cartage of other material (other than poles) by vehicle fro Store Center to nearest construction site Store including loading and unloading at both ends. (0-20 Km,)

Rs.Per Qtl.

Head load cartage of following Poles from road to site

Upto 0 to 1 Km.

Head load cartage of Small material. Rates are per Km/Quintal including loading and Unloading.

Upto 0 to 1 Km.

Excavation of earth for pole pit of size 0.9x0.6x1/6 of full length of pole for erection of pole in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

Erection of following Single support pole in proper level and alignment alongwith fixing of all accessories, like top channel & clamps as per RESPO construction Manual.

Grouting of pole in size 0.45x0.45x1/5 of the support in CC ratio 1:4:8 (1 cement: 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cement,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESPO construction Manual.

Muffing of poles size 0.45 cm x 0.60 cm radius with cc 1:3:6 (1 cement: 3 coarse sand : 6 graded stone 10mm nominal size) block size 45cm height from ground level including cost of cement, stone and sand etc.

Fabrication of M.S. Channel Angle iron after cutting in required sizes with drilling of holes upto good finish for top channel, bracing and special type bracket etc. as per RESPO sehedule and local approved drawing.

Excavation of earth for Stay pit of size 0.6x0.6x1.2mtr in all type of soil including proper dressing of sides and ramming of bottom including getting out the excavated soil and disposal of surplus excavated soil as directed complete work

Fixing , tightening and nozzaling of Stay with pole and stay rod on required tension as per drawing / RESPO manual.

11 KV line

Grouting of Stay in size 0.6x0.6x0.3 in CC ratio 1:4:8 (1 cement : 4 graded stone 20mm nominal size : 8 coarse sand ) block including cost of Cernent,sand and stone ballast back filling of soil and boulders in pit and ramming and proper alignment, leveling as per RESPO Manual.

Dismantling of 11 KV line Weasel

Dismantling of 11 KV line Rabbit

Fixing of IPC with AL Bail for Earthing

Realignment of tilted Pole

Fixing of 11 KV 90 KN Tension Clamp B & IPC

Fixing of 11 KV Suspension Ties

Fixing of 11KV IPC for Covered Conductor to Covered Conductor

Fixing of 11KV IPC for Covered Conductor to Bare Conductor

Jumpering and connection complete on the D/P conductor to TPMO fuse set & T/F

Painting of ST Pole SP-33

Fixing of 11 KV Mid Span Jointing Kit

Dismentaling & Re-Jumpering of Conductor

Chemical Earthing : Earthing of Distribution transformer including digging of pit of size 2.5 ,tr depth and make hole of size 15mm placing of earthing lectrode ( to be supplied by contractor as per drawing No. A) as drawingB, Connecting the same with G.I strip ( to be supplied by the contractor ) of size 35x6 ,, as per drawing C fotr a minimum length 6m treatment of soil with highly condctive substance as per ID 30343 complete in all respect, reasult of earthing resistance to be recorded in M.B before and after installation of earthing, the earth resistance after earthing should be less 1 Ohm.

Laying spreading, Stringing, AAAC Conductor

Back Cartage of Petty material, 0-20km

Back Head load Cartage of petty material, 0-1 km

Total - Part [B]

TOTAL [Part-(A) + Part (B)]

Place

Please Enable Macros to View BoQ information