Budgeted Work ( 0084-4250-203 )

Name of work: A&A to E.I. ,Ceiling Fan and Indoor Light Fittings in ITI Building at Dhoraji , Taluka:Dhoraji , Dist: Rajkot

Item Quantities estimated Item of work Tendered Rate Total amount

Item Quantities estimated Item of work Tendered Rate Total amount

No. but may be more or according to

Qty. Unit estiamted

Replacing Old & u/s by Point wiring for Light / Bell with 2-

1.5 sq.mm & earth wire of 1.5 sq.mm (Green) both are of ISI

marked 1.1 kV grade FRLS PVC insulated multi strand copper

wires up to 10 mtr length , in below type of pipe erected with

6A Modular type switch / bell push & accessories and earth

continuity of following type, erected on PVC /

Metallic/Wooden box, single mounting base frame covered

with textured/metallic/white front plate modules erected on /

in wall / ceiling as per pipe erected, with necessary Lamp

holder/ceiling rose / H.D.Connector as directed. (a) with

medium class Rigid PVC pipe and accessories erected flushed

on wall/ceiling complete Cat. III

Replacing Old & u/s by Point wiring for FAN with 2-1.5

sq.mm & earth wire of 1.5 sq.mm (Green) both are of .ISI

marked 1.1 kV Grade FRLS PVC insulated multi strand

copper wires up to 10 mtr length, in below type of pipe erected

with 6A Modular type switch and hum free EME step type

electronic fan regulator mounted and accessories with earth

2 73.00 Pt. continuity of following type erected on PVC / 765.58

Metallic/Wooden box, single mounting base frame covered

with textured/metallic/white front plate modules erected on /

in wall / ceiling as per pipe erected. with necessary ceiling rose

/ H.D.Connector as directed.. (a) with medium class Rigid

PVC pipe and accessories erected flushed on wall/ceiling

complete cat-III

Replacing Old & u/s by Point wiring for Individual Plug with

& earth wire of 1.5 sq.mm (Green) both are of ISI marked

kV grade FRLS PVC insulated multi strand copper wires up to

10 mtr length, in below type of pipe erected complete with

Modular type switch & 5 pin Plug erected on PVC /

3 17.00 Pt. Metallic/Wooden box covered with appropriate front plate 853.45

modules erected on / in wall / ceiling as per pipe erected with

following type of accessories.[II] For 16A Plug and 16 amp

switch with 2-2.5 sq.mm Cu. Wire from mcb db board. (a)

with medium class Rigid PVC pipe and accessories erected

flushed on wall/ceiling complete Cat. III

Replacing Old & u/s by Point wiring for on board Looped Plug

with 6A Modular type switch & 5 pin socket erected on PVC /

Metallic/Wooden box, single mounting base frame covered

with textured / metallic/white front plate modules erected on

/ in wall / ceiling with following type accessories Cat. III

Providing & erecting PVC Corrugated Flexible Conduit with

5 100.00 Mtr. required nos. of coupling, PVC bushes, Check-nuts etc. 21.21

complete of following sizes.(2) 25 mm

Replacing Old & u/s by Providing and erecting Mains with

kV grade FRLS PVC insulated ISI marked stranded Copper

conductor wire in following type of pipe to be erected

concealed in /flushed on wall/ceiling, with 1.5 sq. mm copper

conductor FRLS PVC insulated stranded wire of green colour

for earth continuity of following size (A) With medium class

Rigid PVC pipe and accessories (b) 2 wire 2.5 sq. mm

providing and erecting Mains with 1.1 kV grade FRLS PVC

insulated ISI marked stranded Copper conductor wire in

following type of pipe to be erected in / on wall / ceiling with

7 60.00 Mtr. 2.5 sq. mm copper conductor FRLS PVC insulated stranded 184.83

wire of green colour for earth continuity of following size (A)

with medium class Rigid PVC pipe and accessories (b) 2 wire

providing and erecting Mains with ISI marked, 1.5kV grade

electrolyte multi stranded, annealed copper conductor with

heat resistant PVC insulated conforms to IS 694, IEC -

8 34.00 Mtr. erected in existing pipe of following size (Specifically for 115.14

control panel, relays, power switchgears, motor starters &

control wiring) with required size of copper lugs, nuts and

bolts if required.(f) One wire 10.00 sq. mm

Item Quantities estimated Item of work Tendered Rate Total amount

Item Quantities estimated Item of work Tendered Rate Total amount

No. but may be more or according to

Qty. Unit estiamted

Providing & erecting Switch board for Computer or electric

apparatus consisting of following modular type accessories

mounted with PVC / Metallic concealed/open box with single

mounting base frame covered with textured/metallic /white

front plate,modules erected with necessary connections as

1 no. 6A/16A universal plug-switch combined.

3 nos. 6A Switch

3 nos. 6A 5 pin Plug For Modular Type Accessories Cat. III

Replacing Old & u/s by Supplying and erecting LED indoor

fittings with LEDs of wattage 0.2 Watt to 0.5 Watt assembled

on single MCPCB, with housing used as a heat sink shall be

made of thick sheet Steel conforming to IS: 513/CRCA/

aluminium die cast powder coated and high U.V. & corrosion

resistance with diffuser with company mark/name 160V to

270V, Power Factor more than 0.95, THD < 15%,

CCT 3000 K to 6500K,

10 300.00 Ea. Luminaire efficacy> 85 lumens/watt ,LED 535.30

LED driver efficiency > 85 %

( fitting required LM-79 & LM-80 Certificates)(NOTE: Below

description have shown ranges of Wattage capacity of LED

fittings.The Engineer incharge may select any wattage capacity

between the ranges shown.) (A) Tube Light with integral

driver (v) 36-40 Watts, Surge-2 KV, IP-20, conventional 4 feet

Supplying and erecting led lamps with following wattage

capacity of 220 to 240 voltage, minimum 15000 burning hours

life, 500 V in built-surge protection,Polycarbonate diffuser,

11 24.00 Ea mounting suitable for E14 / E27 / B22 lamp holders, pf >= 0.5 188.87

(A) LED Lamps integral type, with PC diffuser suitable LAMP

holder (iii) 10 to 15 watts Cat-III

Supplying and erecting LED street light / Flood light fittings

with High power White LEDs wattage of 3 Watt and above

assembled on single MCPCB, efficiency more than 130 lm/w

and corrosion free High pressure die cast aluminum housing

with smooth finish powder coated and heat sink extruded

aluminium with diffuser and Polycarbonate optics/ lenses, with

toughened glass with company mark/name engraved or

12 embossed 160 to 270 V,Power Factor more than 0.95, THD < 0.00

10 %, CCT 3000 K to 5700K,Uniformity ratio >0.45,

Luminaire efficacy> 100 lumens/watt . LED driver efficiency >

85 %.( fittings required LM-79 & LM-80 certificates)(NOTE:

Below description have shown ranges of Wattage capacity of

LED fittings.The Engineer incharge may select any wattage

capacity between the ranges shown.)

(B) Flood Light (IP-65), Surge protection -4kV integral and

6.00 Ea ,Light must have 440VAC line supply with over-voltage 6177.16

protection. (iv) 90 - 119 watts Cat-lll

Replacing Old & u/s by providing and erecting Miniature

circuit breaker single pole 6A to 25A suitable to operate on

13 170.00 Ea 240 V A.C. system and having breaking capacity 10 KA to be 123.22

erected in existing box. confirming to IS 8828/1996 with ISI

Replacing Old & u/s by Providing & erecting 240 V MCB

double pole switch for lighting Load (B Curve) having 10 KA

breaking capacity & confirms to IS : 8828 in existing box

having following capacity (A) 6 to 32 Amp. Cat.III

17.00 Ea (B) 40 Amp Cat.III 325.22

providing and erecting Approved make RCCBs conforming to

IS: 12640 and having sensitivity of 30 mA and Short Circuit

withstand capacity of 10 KA and suitable for operation on

15 17.00 Ea single phase 240 V,50Hz. having characteristic of quick action 2458.34

& tripping with all advance feature & do not incorporate any

electronic component. for following Max. rating erected as

directed (ii) 40Amps. DP Cat. III

Providing and erecting Approved make RCCBs conforming to

IS: 12640 and having sensitivity of 30 mA and Short Circuit

withstand capacity of 10 KA and suitable for operation on

phase and neutral 415V,50Hz. having characteristic of quick

action & tripping with all advance feature & do not incorporate

any electronic component for following Max. rating erected as

directed. (iii) 63 Amps. FP Cat. III

Item Quantities estimated Item of work Tendered Rate Total amount

Item Quantities estimated Item of work Tendered Rate Total amount

No. but may be more or according to

Qty. Unit estiamted

Providing and erecting FRLS-XLPE (IS:7098)(I)-88 ISI

armoured cable multistrand / Solid Aluminium conductor for

17 95.00 Mtr. 1.1 kV. to be laid on wall with necessary clamps or in existing 151.50

trench / pipe of following size of cables (B) 4 core 6 Sq. mm

Supply, Installation Testing & Commissioning 10 Mtr. HDMI

Interface Cable as per the detailed Specifications supports

transmission of 4K Signals as per the detailed Specifications

Replacing Old & u/s by Providing & erecting Approved make

Power Saving 45 - 50 Watt Ceiling Fan with double ball

bearing ISI mark with Condenser 230 volt A.C. 50 Hz

mm sweep complete having 3blades with aluminium blades

with , canopy & 30 cm. down rod erected with earthing.(Make

shall be approved by Engineer in charge))

Replacing Old & u/s by Supplying and erecting 19 / 20 mm.

nominal bore Medium Class M.S. Pipe down rod erected duly

painted for fan complete with proper insulation without

leakage and earthing.

Providing & erecting water cooler having storage capacity

Ltr. & cooling capacity 150 Ltr.per hour @ an ambient temp of

45˚ C. The outlet temp. of the water should drop by 15˚C

within a hour, The water cooler should be comprising of

21 2.00 Ea hermetically sealed compressor, fan motor, condensing unit, 61482.74

water tank surrounded by evaporating, coil, thermostats, relay

etc.complete with necessary inlet & outlet connection. The

body of water cooler will be made from Stainless Steel and ISI

Item Quantities estimated Item of work Tendered Rate Total amount

Item Quantities estimated Item of work Tendered Rate Total amount

No. but may be more or according to

Qty. Unit estiamted

Supplying & erecting 5 stage single reverse osmosis water

purification system with M.S. powder coated frame, prefilter

housing with 'O' ring presediment filter GAC filter, carbon

filter suitable buster DC pump capacity 80 psi, mention with

psi inline type post carbon filter auto low & high pressure

switches with following size of storage tank & LPH capacity &

erected as directed [C] 50 Ltr / Hr with 150 psi 2 nos booster

Note:- The Credit of dismentalled materials for Rs.27082.00 shall be recovered from the First R.A. bill payable to the contrator

and there after the dismentalled materials shall be the property of the contractor.

I/We am/are willing to carry out the work at__________________% above/below (in

figures)_____________________________________percent Above / below (in words) the estimated rates mentioned above amount of

my\our tender works out as under :-

Estimated amount put to Tender Rs. _________

Deduct________% below Rs. _________

Net Amount Rs. _________

Estimated amount put to Tender Rs. _________

Net Amount Rs. _________

A I/We hereby declare that I/we have visited the site and fully acquainted my self / our selves with the local situation

regarding material,labour and other factors pertaining to the work before submitting this tender.

B I/We hereby declare that I/we carefully studied the conditions of contract, detailed technical specifications and other

tender documents of this work and agree to execute the same accordingly.

C Any Excess in Tender Item/Extra Item if Needs to be Execute. Contractors has to carry out work on the instruction of

Competant Authority on Tender Submitted rate,No Excuse will be Accepted.Hence Contractor are Requested to quote

the rate considering this condition.

D Contractor are requested to quote the Tender by considering that payment will be made after availibility of

grant.Contractor has to start the work immediately after issue of Work Order and as per instruction of Engineer-in-

Charge irrespective of availibility of grant.

E "This estimate has been prepared on the new SOR wich is exclusive of GST hence GST additional will be paid to the

agency as per existing guidelines."

(Signature of the Contractor)

Note 1 Please strike out whichever is not applicable.

2 In the case of tendered amount being quoted incorrectly the quoted pered percentage Below/Above will be considered