Providing and Installation / fitting / Fixing of Automotive battery charger, Battery and powder coated aluminium partition required for Snow Clearance Control Room Kreeri of Mech. and Hospital Sub Division 1st Baramulla.

Providing, Installation and Testing of 12A/12-48V Heavy-duty Automotive/ Industrial Battery charger operating on single phase AC supply for a range of 160- 230v/50hz, having double winded pure copper wire transformer, full wave bridge rectifier including all other accessories fitted with on/off Switch, overload protector (MCB), indicators, rotary switches, current and voltage meter, terminals and copper connecting wires/leads 2meter each length (1 set) and also good quality copper alloy battery clamps.

Providing and fitting of 12V 180Ah one number Standby pre charged Heavy-duty Lead-acid Automotive Battery having minimum Cold Cranking Amperage of 830 ampares at -18-degree celcius as per IEC and also having minimum dimensions of 521mm x 278mm x 270mm with Min. replacement warranty of 12 months.

Providing and fixing of Powder coated aluminium work (minimum thickness of powder coated 50 microns) for partition of size 5′ × 10′ with extruded built up standard tubular sections/appropriate Z sections and other sections of approved make conforming to IS: 733 and IS: 1285, fixing with dash fastener of required dia. and size including necessary filling up of gaps at junctions i.e, at top, bottom and sides with required EPDM rubber / neoprene gasket felt etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminium snap beading for glazing /panelling, C.P. brass / stainless steel screws, all complete as per the directions of Engineer-in-Charge.

Providing and fixing of Powder coated aluminium work (minimum thickness of powder coated 50 microns) for Door of size 2.5′ × 6′ with extruded built up standard tubular sections/appropriate Z sections and other sections of approved make conforming to IS: 733 and IS: 1285, fixing with dash fastener of required dia. and size including providing and fixing of hinges / pivots and making provision for fixing of fittings wherever required including the cost of EPDM rubber / neoprene gasket required. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminium snap beading for glazing /panelling, C.P. brass / stainless steel screws, all complete as per the directions of Engineer-in-Charge.

Providing and fixing 12 mm thick prelaminated particle board with decorative lamination on both sides flat pressed three layer or graded wood particle board (conforming to IS: 12823 GradeI type-II) in panelling fixed in aluminium doors, windows shutters and partition frames with C.P. brass / stainless steel screws etc. complete as per directions of engineer-in-charge.

Providing and fixing glazing with float glass panes of 5.0 mm thickness (weight not less than 12.50 kg / sqm) in aluminium door, window, ventilator shutters and partitions etc. with EPDM rubber / neoprene gasket etc. complete as and the directions of engineer-in-charge.

Providing and fixing double action hydraulic floor spring With Stainless Steel cover plate minimum 1.25 mm thickness of approved brand and manufacture conforming to IS : 6315 marked, having brandlogo embossed on the body/plate with double spring mechanism and door weight upto 125 kg for doors including cost of cutting floors, embedding in floors as required and making good the same matching to the existing floor finishing and cover plates with brass pivot and single piece M.S. sheet outer box with slide plate etc. complete as per the direction of Engineer-incharge.

Providing and fitting of Heavy Duty insulated 35sqmm Copper Battery Leads +ve =01 No and -ve =01 No 6 ft long each (1 set) along with good quality Thimbles/clamps on both ends.