PROVISION OF ROOF COVERING SHED HARDSTANDING IN SHOPPING COMPLEX AREA AT CG COMPLEX VISAKHAPATNAM

Amount

Excavation in post holes or similar holes nexc 0.5 cum each in soft/ loose soil , getting out returning filling in and ramming with earth or broken rubble around in layers not exc 25 cm watering etc and removing surplus soil to 50 m distance and making good surface complete all as specified and as directed.

M&L for PCC lean concrete 1:4:8 type D-2 (using 40 mm graded aggregate) as in foundations, filling and mass concrete complete all as specified and as directed.

M &L for Mild steel TMT bars 10 mm dia and over, cut length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips complete all as specified and as directed.

M & L for Mild steel TMT bars but 5mm dia and over upto and including 10 mm dia in stirrups, spacers and binders etc. complete all as specified and as directed.

Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; rough finished surfaces of concrete flat complete all as specified and as directed.

M&L for RCC (design mix) M-25 (using 20 mm graded aggregate) as in foundations, including rafts, footings, foundation beams; plinth beams; post hole, bases for columns, etc.; basement slabs, under-reamed piles and mass concrete complete all as specified and as directed.

M & L for Steel work in tubular trusses incl special shaped washer etc. complete using ERW or induction butt welded tubes conforming to IS 1161 1979 grade ST-240 complete all as specified and as directed.

S& F Pre-painted galvalume aluminum zinc coating trapizoidal profile sheet of 0.50 mm thick [TCT] of any having tensile strength of 550 Mpa as in roof covering / cladding to wall, fixed with self tapping screws complete all as specified and as directed. Make: M/s TATA BLUE SCOPE, M/s LLOYD INSULATIONS INDIA LTD, M/s BUILD TECH / M/s. Jindal

M&L for painting to new steel surfaces of any dedcription over 10 cm in with or girth,not otherwise describe and applying two coats of synthetic enamel paints over a coat of red oxide primer complete all as specified and as directed.

M&L for fly ash brickwork with fly ash bricks, straight or curved on plan exc 6 m mean radius, built in CM 1:6 complete all as specified and as directed.

M & L for brick work in half brick thick walls using Flyash bricks straight or curved on plan to any radius built in Cement Mortar 1:4 including 2 Nos of 8 mm dia bars at every fourth course of brick work complete all as specified and as directed.

M&L for 25 mm thick damp proof course to horizontal or vertical surfaces incl necessary form work in cement concrete 1:2:4, type B-0 complete all as specified and as directed.

M & L for rendering to brick / concrete surfaces, 15 mm thick in Cement Mortar 1:4, surfaces finished even and smooth without using extra cement including mixing of water proofing compound of approved make as per manufacturers instructions complete all as specified and as directed. NOTE:- water proofing compound will be measured and paid separately

M&L for rendering 10mm thick on fair faces of brick work or concrete surfaces in cement mortar 1:6 and finished fair and even without using extra cement complete all as specified and as directed.

Supply only integral water proofing compound.

M&L for preparing newly plastered surfaces of walls and applying three coats of white wash complete all as specified andas directed.

Excavation in trenches n exc 1.5 m wide and n exc 1.5 m deep in soft/ loose soil for foundation etc or for shaft, wells, manholes etc n exc 10 Sqm on plan and not exc 1.5 m in depth and getting out. complete all as specified and directed.

M&L for PCC 1:2:4 type B1 (using 20mm graded aggregate ) as in surface channels and drains complete all as specified and as directed.

Extra for forming fair finishing to drain or channel 30 cm inner girth in cement concrete using extra cement including forms, mitred/ stopped ends, etc. complete all as specified and as directed.

Returning & filling of the excavated earth including spreading, levelling, watering and well ramming in layers not exceeding 25 cm thick with soils complete all as specified and as directed.

Removing excavated material (soils) exc 250 m but not exc 500 m and depositing where directed at a level not exc 1.5 m above the starting point complete all as specified and as directed.

Surface excavation in soft/loose soil n exc 30 cm deep and averaging 15 cm deep and getting out complete all as specified and as directed.

M&L for hard core of gauge n exc 63 mm, deposited, spread and levelled in layers n exc 15cm thick, watered and rammed to a true surface complete all as specified and as directed.

M&L for 100 mm thick Cement concrete type D2, 1:4:8 (using 40 mm graded granite stone aggregate) in sub base of flooring/ hard standing complete all as specified and as directed.

Sand filling under floors or in foundations including watering and consolidation complete all as specified and as directed.

M&L for 60 mm thick Machine pressed precast concrete interlocking paver blocks of any shape and size confirming to IS 15658 - 2006 of , M-35 grade with grey cement and no pigment complete all as specified and as directed. Make : Ultra tiles Pvt. Ltd/Terra firma/Ecco Scope/ Mehtab tiles/ Bharat Tiles & Marble Pvt Ltd / National Tiles & Industries Pvt Ltd / Nitco Tiles Pvt Ltd / Nimco Tiles / Metro Tiles Bombay / Vitco Tiles Bombay / Anjali tiles

M&L for providing cement concrete 1:2:4 type B-1 (using 20 mm graded aggregate) in copings/benching complete all as specified and as directed.

M&L for PCC 1:3:6 type C1 (using 20 mm graded aggregate) in flooring etc., complete all as specified and as directed.

M&L for Glass dividing strips, 3 mm thick and inserted in as per design complete all as specified and as directed.

Material and Labour for Couloured chequered tiles 300mm x 300mm x 22 /25mm thick, machine pressed; set jointed and pointed in neat cement slurry in floors, and cut and polished, including provision of secreed bed in cement mortar 1:4, 15 mm thick, complete all as specified and as directed . Make : Eurocon/ Duracrete/ Ultra & Mehtab

N E R CONSTRUCTIONS

VIJAY VINAYAKA INFRA

SWATHI CONSTRUCTIONS

SRI VENKATA SAI MANIKANTA CONSTRUCTIONS

SN POWER TECH