Specification No.23/2024-25

Amount

Dismantling and clearing away from site to the designated place as directed by the engineer at site including labour, lead and lift etc., complete.

Floor finish in cement mortar

Earthwork excavation &depositing on bank with initial lead of 10m & initial lift of 2m in sand, silt or other loose soil, wet sand not under water and ordinary soil including cost of all labour, lead,lift,etc.,complete. (SS 20B)

Supply and filling with Msand for foundation including watering, consolidation etc.,complete.

PCC 1:4:8 using 40mm HB stone for foundation including cost of al materials and labour etc., complete.

PCC 1:2:4 using 12mm TO 20 MM HB stone for foundation without form work (Below Ground Level) including cost of all materials , labour, lead and lift etc., complete

PCC 1:2:4 using 12 to 20mm HB stone for foundation with form work(Above Ground Level) including cost of all materials and labour etc., complete

Supply and fabricating of MS angles / flats of required sizes for fixing of chain link wires as per standard drawing and as directed by the field engineer at site including all materials, consumables, two coats of painting ,labour , lead and lift etc., complete.

Supplying and fixing Galvalume sheet roofing with 0.5mm thick of approved quality by drilling holes (and not by punching) with necessary ‘J’ / ‘U’ bolts and nuts etc., complete complying with standard specification and as directed by the departmetal officers

Labour charges for aligning and erection fencing posts i.e corner posts, intermediate posts and strut poste including all labour, lead, lift and aligning in position as directed by the Engineer at site etc., complete.

Supply, laying , tensioning and tieing in position of chain link 2" x 2" using 10 Gauge galvanised iron wire including cost of materials , labour charges and all lead,lift etc., complete.

Flooring with good quality ceramic tiles/Non slippery tiles of size 305 mmx 305 mmx 6mm laid over 20mm thick CM 1:3 of approved quality and colour including cost of all materials lead,lift etc complete.

Fabricating Supplying and fixing in position of Aluminium anodised of natural colour matt finish 1/2 fixed glazing 1/2 prelaminated board of Aluminium partition of size 1.20m x2.10 m with required rubber beading etc, including necessary dismantling holes in RCC column, masonry wherever in necessary as directed by the departmental officers. All the aluminium sections should be anodised not less than 15 microns etc., complete.

Fabricating Supplying and fixing in position of Aluminium anodised (powder coated) single leaf door with half panelled with 12mm thick both side laminated particle board at bottom and half glazed using 5.50mm thick Plain glass at top.The outer frame shall be with aluminium box section and necessary accessories such as aluminium clips, rubber beading, PVC felt, handle for a length of shutter (both sides), locking arrangements, furniture fittings average anatic film thickness of 15 microns etc., complete. (With automatic door closure and hinges).

Wiring with 2 x 1.5 sq.mm. (22 / 0.3 ) PVC insulated single core unsheathed copper conductor cable of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories and with TW switch box and 5A FT switch with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire for open PVC light point / fan point (for electronic regulator) ( SD16 )

Wiring with 2 x 1.5 sq.mm (22 / 0.3) PVC insulated SC unsheathed copper conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with 150 x 100 x 113mm TW switch box for 5A 3 pin non inter locking Wall socket with 5A flush type switch with painting of suitable colour with continuous earth wire connection of 14 SWG TC wire for open PVC plug point ( SD36 )

Supply and fixing of 3 Nos. 5A (3 pin and 2 pin) combined flush type wall socket with control switches concealed in suitable TW box covered with hylem sheet in flush with wall with earth connection (for computer plug socket)

Supply and fixing of 18W 4 feet LED fitting complete with TW round blocks on wall or ceiling with LED and PVC unsheathed copper leads from terminals to the fitting.

Supply and fixing of 1200mm (48”) sweep AC ceiling fan (High Speed) of reputed make complete with stepped electronic 100W regulator, with 1 meter down rod with fan clamp with side plates and cross arm of size 450 mm(18”).

Supply and fixing of European Water Closet with "P" or "S" Trap with Double Flapped Seat and Seat Cover with Brass Hinges and 12.5 litre capacity PVC Low Level Flusing Tank with all internal fittings including cost of Stainless steel health faucet and all other material, labour, lead, lift, etc, complete.

Supplying and fixing of wash hand basin of size 550mm x 400mm with all accessories such as brackets, waste coupling, waste pipe, etc., including cost of all materials, labour lead, lift, etc., complete.

Supply and fixing of PVC / Fibre Glass Framed 5.5mm thick Mirror, Shelf Type with Hard Board Backing size of 600mm x 450mm including cost of all materials, labour lead, lift, etc., complete.

Supplying and fixining of Brass Chromium Plated rail 60 cm long and 20 cm brackets including cost of all materials lead, lift, labour etc., complete.

Supplying and fixing 100x75mm floor trap with SS grating in bath room including cost of all etc., complete.

Supplying, fixing and laying of UPVC pipe ( schedule40) for water supply arrangement including cost of all materials, labour, lead, lift etc complete.

25mm dia UPVC pipe

20mm dia UPVC pipe

Supplying and laying PVC pipe 110 mm outer dia 6kg / cm2 ISI make for laying the Sewer line including cost of pvc pipe coupling labour for cutting laying fixing tighting etc complete.,

Supplying and fixining of Brass Chromium Plated Pillar Tap (Heavy Type) - 15 / 12mm dia including cost of all materials lead, lift, labour etc., complete.

Special type of plastering with 15mm thick by using special bonding agent and repair material including cost of materials,curing, labour, lead,lift etc., complete.

White washing two coats using white cement including cost of all materials, labour, brushes, lead, lift,scaffolding charges, etc., complete.

Interior painting with two coats with approved emulsion paint first quality on application of one coat of primer including cost of all materials,lead,lift etc complete.

Exterior painting with two coats of approved exterior emulsion over one coat of primer for wall including cost of all materials, labour, lead, lift, etc., complete.

Painting two coats with Ready mixed Synthetic Enamel Paint paint over old Grill work for the existing window including cleaning preparing the surfaces, cost of all labour, lead, lift etc., complete.