WBIW/SE/CE(S)/NIT-06e/2025-26, SL 03

Cutting uprooting and clearing jungles including shrubs, water weeds,bushes, trees, plants, upto 30 cm. girth including removing as directed by Engineer-in-charge.

Earthwork from borrow pits over existing embankment or for repairs to embankment, closing breaches etc. within an initial lead of 30 metre and lift of 1.50 metre including breaking clods and depositing the same in layers not exceeding 25 cm. and rough dressing etc. complete as per profile.

Extra rate over Item Nos.2.00 above for all kinds of soil for every additional lead of 30 metres or part thereof beyond the initial lead of 30 metres. A) 6(Six) nos lead.

Earthwork in excavation in all kinds of soil for making embankments, repairs to the embankment, closing breaches etc. as per profile including supply and transporting the earth by truck or tractor or any other mechanical means on land , including loading, transporting, unloading and stacking with all lifts bothways and head load where necessary and depositing the same on embankments, clannels, filling depressions in requisite profile, levelling as per direction of the Engineer-in-charge within a lead of, A) Beyond 4.00 km and upto 5.00 km. NB: Measurement to be taken on the basis of stack measurement / prepost work section measurement after deduction of void as per norms. No extra payment will be made for stacking Note: For compensation for earth for land ownwd and arranged by contractor add Rs. 25.00 per cum extra over rate of E/W for land owned/arranged by the Department Royalty Charges on earth @29.00 per cum & cesses charges @ Rs. 5.30 per cum (i.e, Rs. 15.00 per 100 cft), as per Govt. notification, which will be paid on production of necessary documents in support of payment made towards the royalties and cesses.

Earth work in excavation of foundation of structures as per drawing and technical specification, including setting out, removing, spreading or stacking of spoils within a lead of 150 m. as directed and including trimming the sides of the trenches, leveling, dressing and ramming the bottom, and backfilling with approved aterial complete as per direction of the Engineer-in-Charge. A) In all sorts of soil excluding marshy soil & rocks(soft or hard) by manual means; i) Upto 3 m depth, a) With pumping out water including shoring as required.

Ordinary cement concrete (mix 1:1.5:3) with graded stone chips (20 mm. nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. A) Pakur variety. [Cement : PSC / PPC/OPC 33]

Ordinary cement concrete (mix 1:2:4) with graded stone chips (20 mm. nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. A) pakur variety. [Cement : PSC / PPC/OPC 33]

Supplying, fitting and placing HYSD bar reinforcement in Sub-structure including initial straightening, straightening of coils bars, removal of loose rust (if any), cutting to requisite length bending, binding with annealed wire not less than 1mm in size and conforming to IS 280 at every intersection hooked and bent to correct shape and placed on forms etc. including cost of black annealed wire and cost of loading, unloading,carriage of all steel materials complete as per drawing and technical specifications and direction of Engineer-in-charge. A) Steel materials Tor Steel rods / HYSD bars / TMT bars. (JSW/JSPL / Shyam / SRMB/SSL/ BMASL / Electrosteel) (Fe 415 /Fe 500 /Fe 500D, conforms to lS: 1786)

Hire and labour charges for shuttering with centering and necessary staging upto 4m using approved stout props and thick hardwood planks of approved thickness with required bracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and striking out after completion of works (upto roof of ground floor). A) 25 mm to 30 mm thick shuttering without staging in foundation.

Making filter with well graded 40 mm down ballasts and laying uniformly behind weep holes, below pitching on bed, side slopes including supply and carriage of all materials to site including preparing bed with earthwork up to 30 cm depth, where necessary and compacting with wooden malllet after laying to achieve designed section as per direction of the Engineer- in - Charge (measurements will be on finished work / in stack after deducting necessary void). A) 1st class brick ballast.

Providing and laying pre-cast brick block pitching of required size (53 Cm. x 53 Cm, x 25 Cm. or as directed by the Engineer-in-charge ) with 1st class kiln burnt bricks in cement mortar including flush pointing on all faces except exposed face which to be plastered with 19 m.m. thick cement plaster , curing, dressing, ramming & preparing subgrade in slopes & bed complete with necessary earth work not exceeding 300 mm in depth with all leads & lifts including cost of all materials/ blocks up to site by all means of transport. The gap between adjacent blocks will not be more than 10 m.m. (Sand, cement mortar mix for making blocks, pointing & plastering is1:4)

Making sausages circular in section (any length) made with 1st class kiln burnt / 1st class picked jhama full bricks rolled inside wire net caging made of 10 S.W.G. galvanised iron wire square pattern (internal dimension of mesh will be 100 mm. x 100 mm. square) galvanised wirenet caging with proper lapping of minimum 150 mm and sewing with 12 SWG. galvanised iron wire including cost of all materials, carriage up to site, placing and laying the same after preparing the bed/trench to proper slope etc. complete as per direction of the Engineer-in-charge. (cost is excluding the cost of end pieces .) A) 1.00 metre diameter.

Supplying, fitting, fixing end pieces for rectangular / square / circular sausages at the ends, with 10 SWG / 8 SWG G I wire net of different mesh sizes tying & sewing the same maintaning a lap langth of 150 mm all around with 12 SWG G I wire complete, including the cost of supply of wire netting,fitting etc, complete as per direction of the Engineer- in - charge. A) Mesh size 100 mm x 100 mm with 10 SWG wire.

Supplying Jhaw / Eucalyptus bullah piles at work site, including dressing and making one end pointed. Note: Diameter of pile to be measured at a distance of 1.5m from the thicker end. 15 cm av. Diameter.

Labour for driving Jhaw / Eucalyptus bullah piles by monkey in all sorts of soil including hoisting and placing piles in position, protecting the pile head with iron ring and cutting and shaping heads before and after driving and including hire and labour for necessary driving appliances and all tackles. Note: Payment to be made on the length driven into the ground. Diameter to be measured at 1.5m. from the thicker end. 15 cm av. diameter.

Coal tarring with 5% pitch including cost of material and labour complete as per direction of the Engineer-in-charge A) Two Coat.

Supply of Different materials as per approved specification Bricks / Jhama / Bats Sorted & stacked at site. A) Brick bats.

Labour charge for dumping / laying of Laterite / Stone Boulders 25 kg & above / Shingles / Brick Bats, from stack of worksite with all leads and lifts in water or spreading the same on the slope of the bank of River/Sea or the slope of the embankment or in the River/ Sea bed to an uniform thickness as per direction of the Engineer-in-charge including cost of all accessories and other incidental charges. A) Brick Bats.

Supplying and laying polythene sheet (150gm/Sqm) over damp proof coarse or below flooring or roof terracing or in foundation or in foundation trenches

Please Enable Macros to View BoQ information