Providing Decorative Lights on Central verge from ESI Hospital, jagadhri via Aggarsain Chowk, Buria Chungi Chowk to Samrat Mihir Bhoj Chowk (Trikoni Chowk, Jagadhri) under MC limit (7.04 KM) in Distt. Yamuna Nagar.

Amount

COPPER WIRING IN EXISTING PVC/MS CONDUIT PIPE SURFACE/RECESSED FOR ELECTRICAL POINTS Wiring main and sub mains in two single core for phase and neutral wire and one single core for earth wire PVC insulated Copper conductor cable 1100 Volts grade in existing MS/PVC Conduit etc as required. 2 run of Size 1.50 Sqmm(1/1.40mm) HSR No. 23.5.6.6

MCCB ,DISTRIBUTION BOARDS, MCB's, RCCB's, CHANGE OVER etc. Supply and erection of Modular case circuit breaker single pole/4 pole on existing wall/pedestal/Panel including bounding to earth and making necessary connections required to complete the job in all respect up to the entire satisfaction of the Engineer-in-charge of the work. 4 pole MCCB 125 to 160 amp, 25 KA HSR No. 23.22.1.10

Supply and erection of double door sheet steel enclosure distribution board suitable for MCBS and ELCBS etc. recessed in wall including bonding to earth with all labour and material required to complete the job in all respect up to to the entire satisfaction of the Engineer-in-Charge of the work. TPN DB Horizontal type Double Door 4 way ( 8 incoming and 3phase*4 outgoing) HSR No. 23.22.4.5

Supply and election of Godrej Almirah type M.S. pedestal made of 50 mm *50 mm * 6 mm angle Iron frame with 3.00 mm thick M.S. sheet covering including shutters with suitable hinges and looking arrangement with the Godrich type handle including round bars. The to covering should have a downward overhang of 75 mm on all sides of pedestal, having two sets of water proof ventilation holes of suitable size on the sides, at top and bottom, each set containing four No’s. holes to discharge the heat produced by suitable size to make it water proof . The pedestal duly painted both inside and outside with two coats of approved paint and primary coat and its legs are embedded upto the entire depth in 1:2:4 cement concrete block, projected 75 mm all around the pedestal and 200 mm above the ground level including the cost of all labour and material required to complete the job in all respect upto the entire satisfaction of the Engineer-in charge of the work. M.S. pedestal of size 750 mm wide, 1200 mm high, 300 mm deep and bottom totally open , duly embedded in cement concrete block of size 900 mm*450 mm*200 mm above ground level , having a base of size 1050 mm* 600 mm* 250 mm below ground level. HSR No. 23.27.3

EARTHING AND LIGHTENING ARRESTOR Earthing with GL earth pipe 4.5 m long and 40 mm dia with masonry enclosures on the top etc. (but without charcoalor coke and salt) as required. HSR No. 24.1.1

Extra for using salt and char coal/coke for pipe earth electrode as required. HSR No. 24.1.2

Providing and laying earth connections from earth electrode with 4.00 mm dia G.I. wire in 15 mm dia G.I. pipe from earth electrode as required. HSR No. 24.1.11

Providing and fixing 4.00 mm dia G1. Wire on surface or in recess for loop carthing as required. HSR No. 24.1.13

LT CABLE Supply and erection of suitable compression type brass cable glands for underground Cable :- 25 sqmm to 50 sqmm Cable 2 to 4 Core HSR No. 24.2.7.3

MISCELLANEOUS ITEMS S/E mark double walled corrugated (DWC) HDPE, pipe 10 Kg/Cm2 ,laid 0.75 Mtr below ground level including diging and refilling of earth including cost of suitable size socket/cuppler for HDPE pipe including the cost of labour and material required to complete the job in all respect up to the entire satisfaction of Engineer in charge of the work. DWC/HDPE pipe 63/50 mm outer dia/inner dia HSR No. 24.5.2.3

DWC/HDPE pipe 90/75 mm outer dia/inner dia HSR No. 24.5.2.4

MCB SP MCB 6-32 A EL115

FP MCB 40 A EL125

Supply and erection of Decorative GI Pole total Height 8 mtr, total weight of pole 240 KG, single piece cast iron base 750mm height and weight of cast iron base 55 KG, size of base plate is 450mmx20mm, lower part of the GI pole is heaving 165mm dia with 4.8mm Thickness, height 5mtr two branches connected with this pole having dia 60mm with thickness of 3.3mm length of these two brances is 3 mtr aesthetic look as per the drawing, upper part of the pole is having cast iron/ aluminium ambalishment, elliptical shape service window having loop in loop our 4 way connector 40 amp suitable for 10 Sqmm wire with 6amp to 32amp single pole MCB, pole and cast iron parts are PU panted in three layers coating in which 1st layer with ETCH primer, 2nd layer with EPOXY primor and 3rd final layer with PU Paint, and accessories required to complete the job in all respect including erection, fixing including connection of the same upto the entire satisfaction of Engineer in Charge of the work. (Make as per approved make list) NS-1

Supply and erection of 120 watt LED minimum 110/120 lumens per watt 4000°K Decorative Ornamental Street Light fitting made of die cast aluminium housing with power LED'S mounted directly on MCPCB . A UV stablized single piece injection moulded PC Diffuser having Thichness of min 3mm is provided for glare free lighting, Phillips Xitanium driver used. Complete fixure should be BIS Certified and LM 79, and accessories required to complete the job in all respect including erection on existing ornamental pole for fixing including connection of the same upto the entire satisfaction of Engineer in Charge of the work. (Make as per approved make list) NS-2

Supply and erection of Decorative High Mast Fixure total height of the GI pole is 9mtr Lower part of the pole is having 140mm dia with 4.3mm thichness height 3mtr. dia cast base plate having 348 dia x 10mm thick elliptical shape service window having loop in loop our 4 way connector 40 amp suitable for 10Sqmm wire with 6amp single pole MCB, middel part of the pole having 114mm dia with 4mm thickness height 3mtr. Upper part of the pole having 900mm dia with 3.6mm thickness and height is 3mtr.pole & decorative casting parts are PU panted in three layers coating in which 1st layer with ETCH primor, 2nd layer with EPOXY primor and 3rd final layer with PU Paint, light fixure is made of cast aluminium housing having width of 700mm and height of the fixture is 270mm. light fixture is suitable for 350W LED is mounted on MCPCB with single peice lens on 12 LED. T2 lens is used for wide distribution of light fixure is IP65. and accessories required to complete the job in all respect including erection on existing ornamental pole for fixing including connection of the same upto the entire satisfaction of Engineer in Charge of the work. (Make as per approved make list) NS-3

Supply and erection of 63 amp. 3 Pole/230V Astronomical automatic time switch fo Indo Asian make Cat No. TL065ASO & other equivilent make alongwith contractor of required capacity movement controlled by precisaty quartz osciliation operation on main supply of continue to run on built in rechageable nickel cadium cell for 150 hours in the evnt of power failure including cost of contractor complete in all respect upto the entire satisfaction of Engineer-in-charge of the work. (Make as per approved make list). NS-4

Const. of R.C.C Foundation for DECORATIVE POLE / Decorative High Mast including with digging riffling and road cutting etc for Decorative Poles (Cast Iron) 1:1.5:3 for foundation, size 0.7M x 0.7M x 1.8M with minimum of 8 nos 12 mm dia longitudinal MS reinforcement rods with rings of 8mm dia not more than 200mm C.C for fixing the pole with all labour & material required to complete the job in all respect upto the entire satisfaction of Engineer in Charge of work. NS-5

Supply and erection of CT operated electronic energy meter with CTs of required ratio duly erected wired tested from UHBVN laboratory including necessary testing fees and petty material installed in MS box of 16G complete in all respect all items of make specification and size as approved by UHBVN. NS-6

Supply and erection of under ground cable ,loose in existing pipe or trenches complete with necessary connections . 25 Sq. mm 4 Core Cable . (Make as per approved make list). NS-7

Supply and erection of under ground cable ,loose in existing pipe or trenches complete with necessary connections . 50 Sq. mm 3.5 Core Cable . (Make as per approved make list). NS-8

Note: - The Design and drawings for decorative poles and fittings shall be got approved from Engineer-in-charge of work before execution.

M/s JSB Enterprises