PROVN OF DI PIPE LINE FROM SEWAGE WELL NO 1 TO SEWAGE WELL NO 3 AND SPL REP OF PERIMETER SECURITY LIGHTS ALONG RAILWAY LINE IN AD AND RKT REGT UNDER GE UTILITY AMBALA CANTT.

Amount

Job No. PH &HP(I) SA/W-17/LB/2023-24

Supply , Laying and Testing Ductile iron pipe of 150 mm bore, S/S,Class K-9 , suitable for rubber gasket (tyton) joints ISI marked complete all as specified and directed by Engineer-in-Charge.

Supply and fix cast iron sluice valve PN-1.6 with flanged ends 150 mm nominal bore ISI marked complete with gun metal or stainless steel spindle and cast iron cap including rubber /fiber boared gasket nuts, washers etc complete all as specified and as directed by Engineer-in-Charge.

Supply and fixing in replacement cast iron air release Valves with flanged ends 150 mm nominal bore ISI marked complete all as specified and as directed by Engineer-in-Charge.

Supply and fix in replacement Non Return Valve with flanged ends of size 150mm dia complete including rubber/fiber board gasket, uts washer etc complete all as specified and directed by Engr-in-Charge

Material and labour for rubber gasket(Tyton) joints suitable for 150 mm bore DI pipe and fittings including jointing material complete all as specified and directed by Engr-in-Charge

Supply and fix in ductile iron fittings for spigot and socket /fanged pipe such as bends (any type radius and angle) tapers any type (straight, bends, increasing, decreasing or double socket etc) Tee pieces single branch, 'Y' junction, double branch , cross collers , caps and plugs upto 150 mm bore complete all as directed by Engineer-in-Charge

M&L for Brick masonry valve pit of size 120 x 120 x 120 cm (internal dimensions of chamber) built in CM 1:6 including 10mm thick plastering internally with cement mortar 1:6 and flush pointing externally as the work proceeds in same mortar complete with 3.15mm thick MS sheet cover with angle iron 40 x 40 x 6mm frame, handle, locking arrangement including provisioning of 2 foot steps made out of MS 16mm round bars and painting steel surface (cover inside and outside with frame) with two coats of synthetic enamel paint over a coat of red oxide primer complete based on drawing no. STD -1258 Sheet 1/1.

Job No. 19/SPL/STN CELL/2023-24

Excavation in trenches not exc 1.50 metre wide and not exc 1.50 metre in depth for foundation, shafts, man holes, for under ground cable / erection of poles, stays, locating fault of LT cable and stay assembly etc not exceeding 10 square metre on plan and getting out in any type of soil including dressing / trimming of sides and leveling, grading and ramming of bottom of excavation complete all as specified and directed.

Returning, filling in,in soil, including spreading, leveling, watering and well ramming in layers not exc 25 cm thick each layer complete all as specified and directed.

Removing excavated material / soil to a distance not exceeding 50 mtrs and disposting where directed at a level not exceeding 1.5 mtrs above the starting point complete all as specified and directed.

Material and labour for sand cushioning to cable with a layer of sand 8 cm deep before laying the cable and 15 cms deep after laying the cable (punned down to 18 cms depth after laying and stretching of cable) complete all as specified and as directed. Note: Punned thickness 18 cm shall be measured and paid.

Supply and lay bricks, common burnt clay, sub class "B', old size, laid in vertical direction to cable as cable protection complete all as specified and as directed.

Supply and fixing in replacement of fabrication of Kiosk box made out of fibre material complete with TPN ,aluminium bus bar and suitable for one number MCB (SP) including one No MCB (SP) 6 Amps 240 volts with glands for incoming & out going cable including fixing of flat iron clamps of size 20x4mm on PCC/Steel tubular pole complete all as specified and as directed by Engr-in-Charge.

Supply & fixing in replacement of LED street light fitting 70 watts made up of pressure die cast aluminium housing with high efficiency LEDs as lighting source and lens embedded PC cover/ toughened glass having TOP Opening seperate driver compartment with IP 66 protection and impact resistance of IK07 consisting of suitable number of LEDs with sealed toughened glass cover, 5700K, LED efficiency >110 lm/Watt and system efficiency 110 lm/W , 240 Volts AC, 50 Hz, CRI>70% operating voltage range 140 V-270 V, Power factor> 0.95,mains current 0.270A, working temperature range -10ºC to 50ºC,built in surge protection of more than 10 kV, better optics for uniform distrubution with multiple LEDs not less than 2 watt each and having optical grade polycarbonate lens with all accessories , suitable for side entry, pole mounting with bracket arm OD 40 mm, recommended mounting height with suitable inground reinforcement is 8 mtrs, Confirm the safety test as per IS 15885 part-2 from auth labs : LM79 & LM 80, incl proper fixing and testing of street lights on 9/11 mtr long steel tubular pole incl make proper connection of new and existing light fittings complete with cutting , welding , drilling holes, nut bolts, washer complete all as specified and directed by Engineer-in-charge. Note :-PVC heavy duty conduit pipe along with 3/1 run of 1.5/2.5 sqmm PVC insulated unsheathed/sheathed copper multistranded conductor from MCB box to street shall be measured and paid for separately.

Repairing of existing unserviceable PCC coping of LT/HT pole by breaking completely and providing with using PCC 1:2:4 type B-1 using 20mm graded crushed stone aggregate of size 600x600x300 mm including necessary formwork and applying 3 coats of white wash complete all as specified and directed.

Supply and laying, conecting and testing XPLE underground PVC cable insulated, and overall sheathed with aluminium conductor heavy duty 1100 volts grade 25 sqmm 3.5 core laid in trenches/ on pole / road crossing or passing through existing / new pipe under road crossing clamping on wall etc, Note:(i) earth work, sand cushioning , brick protection, aluminium thimbles /lugs shall be paid separately (ii)Cost of laying electrical cable through new/existing pipe under road, buildings, railway tracks,highways are incl in the quoted rates(iii) All equipments , machinery or tool if required for laying electricals cable through new/existing pipes are provided by the contractor without any extra cost

Note:- Amount of credit of Rs 78200.00 for retrieved materials is mentioned in Schedule of Credit attached in tender documents in pdf form which will be deducted offline while acceptance of tender.

M/s badrinath Traders

Gupta Enterprises

KULWANT SINGH