Loading…
Loading…
Tender Value
₹60.8 Cr
EMD Value
₹1.2 Cr
Closing Date
8 Sept 2026, 3:00 pm
Yes (up to 2 members)
No
Two Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
120 days
Expenditure
Capital (Works)
RAIPUR
22 conditions · 11 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N or 'V' whichever is less; where V= Advertised value of the tender in crores of Rupees, N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB of GCC-2022, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
Partnership firm: Clause no. 18 of GCC-2022 with their qualifying criteria will be applicable in case of partnership firm with latest correction slips.
Tenderers have to submit Annexure-VI of GCC 2022.
Tenderers have to submit Annexure-VIB of GCC 2022 for the calculation of bid capacity.
The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i) Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or One similar work each costing not less than the amount equal to 60% of advertised value of the tender. (i) Indoor work involving supply, installation, testing & commissioning of Electronic Interlocking/ RRI/PI (OR)(ii) Both Indoor and Outdoor works involving supply,installation, testing & commissioning Of ElectronicInterlocking/RR1/Pl (OR)(iii) Indoor & Outdoor works for LBS/ ABS/ LC Interlocking/Yard Remodeling work involving installation oralteration to Electronic Interlocking/ RRI/PI.NOTE:- (i) The successful bidder shall submit an undertaking from RDSO approved El OEM, before the supply Of material, to confirm compliance With extant RDSO guidelines and to meet contract specific requirements. NOTE: Work experience certificate from private individual shall not be considered. However, in addition to work experience certificates issued by any Govt. Organization, work experience certificate issued by Public listed company having average annual turnover of Rs 500 crore and above in last 3 financial years excluding the current financial year, listed on National Stock Exchange or Bombay Stock Exchange, incorporated/registered at least 5 years prior to the date of closing of tender, shall also be considered provided the work experience certificate has been issued by a person authorized by the Public listed company to issue such certificates. In case tenderer submits work experience certificate issued by public listed company, the tenderer shall also submit along with work experience certificate, the relevant copy of work order, bill of quantities, bill wise details of payment received duly certified by Chartered Accountant, TDS certificates for all payments received and copy of final/last bill paid by company in support of above work experience certificate.
Tenderers have to submit Tender Form sheet (Annexure-I)
Uploading of Declaration regarding Employment of Retired Engineer/ Retired Railway Officer as per clause no.16 of Part-I of IRSGCC
Details of technical personnel with qualification and experience employed by the firm.
Details of supervisors and skilled and unskilled staff with qualifications and experience for field supervision and execution.
Details of special equipments, tools and plants and machinery, vehicle etc. available with the firm for execution of contract works.
Tenderers have to submit Annexure-V of GCC 2022.
31 conditions
Credentials in support of fulfillment of eligibility criteria. (Without these documents the offer is liable to be rejected.)
Bar Chart/PERT Chart with time schedule for supply of materials and execution of works.
Full and clear postal address including telephone/ fax numbers to be submitted.
SUBMISSION OF BID SECURITY: The Bid Security shall be deposited either in cash through e-payment gateway or submitted as Bank Guarantee bond from a scheduled commercial bank of India. If the contractor submits the BG against Bid Security in prescribed format as per GCC Apr 2022 (Acting through Dy.CSTE/Project/Raipur, S.E.C. Railway, & Beneficiary: FA&CAO/Con/S.E.C. Railway, Bilaspur). The original Bank Guarantee should be delivered in person to Dispatch & Receipt section of the office of Dy.CSTE/Project/Raipur, S.E.C. Railway, DRM office complex, Raipur-492008 (C.G.).
Any communication or submission of The original Bank Guarantee should be delivered in person to Premkunj Kumar, Designation- TCM-I/Proj./R, Mobile No. 7777814180, Email:- [email protected].
The above check list is not exhaustive. The tenderer must go through carefully the entire booklet and submit the tender complying with all conditions/provisions/ instructions mentioned therein irrespective of the fact that they have been highlighted in the checklist or not.
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
Provision of Electronic Interlocking at Risama(RSA), Gundardehi(GDZ),Latabor (LBO), Balod (BXA) and Kusumkasa (KYS) stations including new loop line at Risama (RSA), Latabor (LBO) in Durg-Dallirajhara section of Raipur Division.
11-SNT-Proj-R-Tender-26~SECR
11-SNT-Proj-R-Tender-26
Open
Works - General
24 Months
Bilaspur, Chhattisgarh
₹0
₹1.2 Cr
7 Aug 2026
7 Aug 2026
25 Aug 2026
64 items across 2 schedules · ₹1,44,58,570 total
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| 1 | Design and development of Route Control Chart (RCC) in size B(A3) as per SEM.[SOR- 2021 for S&T works-Sch 'A2' item no. 1(a)] | Sheet | 250.00 | 1,004 | 2,51,000 |
| 2 | Design and development of Front Plate Diagram(FPD) conventional/Dual VDU FPD in size W(A1) as per SEM. [SOR-2021 for S&T works-Sch 'A2' item no. 1(b)] | Station | 5.00 | 5,024 | 25,120 |
| 3 | Design & development of Track bonding plan in size U(A3) as per SEM.[SOR-2021 for S&T works-Sch 'A2' item no. 1(d)(iii)] | Station | 5.00 | 1,256 | 6,280 |
| 4 | Photocopy of various drawing in A3 size paper single side. [SOR-2021 for S&T works- Sch 'A2' item no. 1(k)] | Numbers | 2500.00 | 2 | 5,000 |
| 5 | Miniature diagram in size B(A3).[SOR-2021 for S&T works-Sch 'A2' item no. 1(h)] | Numbers | 5.00 | 1,004 | 5,020 |
| 6 | Design and development of Circuit Diagram/Logic in size B(A3) as per SEM sheet including contact analysis.[SOR- 2021 for S&T works-Sch 'A2' item no. 1(e)] | Sheet | 1100.00 | 1,004 | 11,04,400 |
| 7 | Other Signalling Drawing in size U(A3) as per SEM sheet (wiring in location box).[SOR-2021 for S&T works-Sch 'A2' item no. 1(f)] | Sheet | 1060.00 | 1,004 | 10,64,240 |
| 8 | Maintenance Register as per Requirement. [SOR-2021 for S&T works- Sch 'A2' item no. 1(g)] | Numbers | 100.00 | 125 | 12,500 |
| 9 | Design, Preparation & checking of documents and Circuit diagram and drawings Design and development of Station working rule Diagram (SWRD) based on SIP of station in size U(A3) as per SEM. [SOR-2021 for S&T works-Sch 'A2' item no. 1(c)] | Station | 5.00 | 5,024 | 25,120 |
| 10 | Design, Preparation & checking of documents and Circuit diagram and drawings Design & development of cable corage plan in size U(A3) as per SEM. [SOR-2021 for S&T works- Sch 'A2' item no. 1(d)] | Station | 5.00 | 2,511 | 12,555 |
| 11 | Design, Preparation & checking of documents and Circuit diagram and drawings Design & development of cable route plan in size U(A3) as per SEM. [SOR-2021 for S&T works-Sch 'A2' item no. 1(d) (ii)] | Station | 5.00 | 1,256 | 6,280 |
| 12 | Design, Preparation & checking of documents and Circuit diagram and drawings Development of SIP based on ESP on size W(A1) [SOR-2021 for S&T works-Sch 'A2' item no. 1(j)] | Numbers | 5.00 | 5,024 | 25,120 |
| Schedule total | ₹25,42,635 | ||||
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
LBOESPLOOPLINEWORK.pdf
ATTACHMENT
RSAESPLOOPLINEWORK.pdf
ATTACHMENT
RSAW.NO.LMSDAC_compressed.pdf
ATTACHMENT
GUNDERDEHISIP.pdf
ATTACHMENT
KYSshiftingofLCDD-59_compressed.pdf
ATTACHMENT
LOB25.05.26_compressed.pdf
ATTACHMENT
BALODW.NO.UMSDAC_compressed.pdf
ATTACHMENT
STC2026sign_1.pdf
ATTACHMENT
ScopeofworkSign.pdf
ATTACHMENT
GCC_April-2022.pdf
ATTACHMENT
SOR-202118.01.2021.pdf
ATTACHMENT
SECRGuidelineforinstallationofstandbyAxlecounter.pdf Guideline for installation of MSDAC
ATTACHMENT
IPSTypical69_2020.pdf
ATTACHMENT
EIKavachReady.pdf
ATTACHMENT
AnnexuresNewSign_1.pdf
ATTACHMENT
GCCACSNo.1-11_compressed.pdf
ATTACHMENT
SECRGuidelineforinstallationofstandbyAxlecounter.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at [email protected].