Loading
Loading…
Loading…
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹37.5 LAccepted-AOC PMC 24 528 GROUND FLOOR NEAR PAYYANUR SERVICE CO OP BANK KOTTY BRANCH PAYANNUR KANNUR KERALA 670307 | PAYYANUR | KANNUR | KERALA | 670307 | L1 | Accepted-AOC Awarded contract being lowest | |
| 2 | L2₹39.9 L+₹2.1 L (5.43%)Rejected-AOC DOOR NO 3 79 CHENNNADGRAMAPANCHAYAT PERUMBALA KASARAGOD 681317 | PERUMBALA | KASARAGOD | KERALA | 681317 | L2 | Rejected-AOC Not being lowest | |
| 3 | L3₹48.9 L+₹11.1 L (29.2%)Rejected-AOC THEKKEKOTTARAM RAMANTHALI PO KANNUR DIST KERALA 670 308 | RAMANTHALI | KANNUR | KERALA | 670308 | L3 | Rejected-AOC Not being lowest |
| Sl No | Description | Qty | Unit | KDR CONSTRUCTION L2 | Palace constructions L3 | Gates Infra Construction Co L1 |
|---|---|---|---|---|---|---|
| 1.00Notes: (i) The contractor or his representative shall collect daily list of complaints from MES complaint cell or from concern JE and shall attend all the complaints in the same day irrespective of number of complaints received. Contractor shall employ sufficient tradesmen accordingly as per requirement. However minimum one plumber and carpenter shall be made available throughout working hours to attend emergency complaints. The rates quoted by the contractor shall be deemed inclusive of cost against supervisor, all tradesmen / labours employed, conveyance required for collecting complaints and attending at site for all items of BOQ. (ii) Contractor shall employ skilled / experienced tradesmen and workers for execution of work. (iii) Contractor or his representative shall submit compliance report of complaints on the same day with receipt / job card duly signed by the users to concern JE. Contractor may use separate register for each category of complaints and obtain signature from users after repair / rectification of complaints received and submit the same during preparation of RARs to concern JE. (iv) All critical complaints related to water supply and complaints which posses safety hazards to occupants have to be rectified within 24 hours after receipt of complaints. In case of complaints are not rectified on same day, the contractor shall submit in writing to Engineer-in-charge with valid reasons / justifications for delay and however the same shall be rectified with in 2 working days. Otherwise a recovery of Rs 500 per complaint per day shall recovered from the contractor. (v) All unserviceable materials, debris, waste material scrap etc. obtained during repair work other than such of credit materials issued to the contractor shall be removed immediately from site and disposed off at dumping locations earmarked with in the INA premises at no additional cost to the Govt. The cost of labour, transportation etc. shall be deemed included in the rates quoted by the contractor against respective BOQ items and nothing extra shall be paid. | ||||||
| 2.00 | Taking down chowkats or frames of any description (wooden / aluminium / steel etc.) not exceeding 1.5 Sqm each with shutters (without taking off shutters from the frames) including making good of disturbed portions of cills / jambs complete all as specified and directed. | 15 | Each | 250 ₹3,750 | 500 ₹7,500 | 150 ₹2,250 Lowest |
| 3.00 | Taking down chowkats or frames of any description (wooden / aluminium / steel etc.) exceeding 1.5 Sqm but not exceeding 4 Sqm each woth shutters (without taking off shutters from the frames) ncluding making good of disturbed portions of cills / jambs complete all as specified and directed. | 15 | Each | 275 ₹4,125 | 500 ₹7,500 | 150 ₹2,250 Lowest |
| 4.00 | Taking down shutter of any description (wooden / Aluminium / steel etc.) not exceeding 1 Sqm each complete all as specified and as directed. | 35 | Per Leaf | 60 ₹2,100 Lowest | 100 ₹3,500 | 150 ₹5,250 |
| 5.00 | Taking down shutter of any description (wooden / Aluminium / steel etc.) exceeding 1 Sqm and not exceeding 2 sqm each complete all as specified and as directed. | 40 | Per Leaf | 75 ₹3,000 Lowest | 150 ₹6,000 | 150 ₹6,000 |
| 6.00 | Supply and fixing of powder coated aluminium frame for doors, windows, ventilators, partitions, kitchen cupboards etc. (minimum thickness of powder coating not less than 50 micron) with one or more rebates / any profile including joining cleat for fixing etc. complete all as specified and directed. | 350 | Kg | 695 ₹2,43,250 | 750 ₹2,62,500 | 600 ₹2,10,000 Lowest |
| 7.00 | Supply and fixing Powder coated aluminium door shutters, of any colour (Thickness or powder coating not less than 50 micron), .aluminium section weighing 0.55 kg/m including necessary joining cleats, glazing clips, ruber neoprene packing, handles 2 Nos in each door, hinges, anodised aluminum snap beading screws etc. complete all as specified and directed. | 80 | Sqm | 1,950 ₹1,56,000 Lowest | 3,800 ₹3,04,000 | 2,800 ₹2,24,000 |
| 8.00 | Supply and fixing Powder coated aluminium window and ventilator shutters fixed or sliding type without sash bar, aluminium section weighing 0.55 kg/m incl necessary joining cleats rubber packing anodised aluminium snap beading screws, lockig arrangement etc. complete all as specified and directed. | 30 | Sqm | 1,950 ₹58,500 Lowest | 3,800 ₹1,14,000 | 2,800 ₹84,000 |
| 9.00 | Supply and fixing of Aluminium alloy wire cloth 0.45 mm nominal dia of wire and average width of aperture 1.40mm and fixed with aluminium staples or beading complete all as specified and directed. | 30 | Sqm | 833 ₹24,990 | 700 ₹21,000 Lowest | 800 ₹24,000 |
| 10.00 | Supply and fixing in repair aluminium alloy wire cloth, 0.45 mm nominal dia of wire and average width of aperture 1.40mm and fixed with aluminium staples or beading complete. | 60 | Sqm | 855 ₹51,300 | 700 ₹42,000 Lowest | 800 ₹48,000 |
Tender Value
₹42 L
EMD Value
₹84,000
Closing Date
4 Jun 2026, 10:00 amClosed
GE(MAINT)EZHIMALA
GARRISON ENGINEER (MAINT) MILITARY ENGINEER SERVICES INDIAN NAVAL ACADEMY POST KANNUR DIST KERALA 670 310
AS PER BOQ AND TENDER DOCUMENTS
2026_MES_764988_1
GE MAINT EZHIMALA 8862
Open Tender
Civil Works
Item Rate
330 days
Ezhimala
AS PER TENDER DOCUMENTS
8 documents required · 8 mandatory
₹500
GE MAINT EZHIMALA
₹84,000
Yes
1 Jul 2026
13 May 2026
10 Jun 2026
13 May 2026
4 Jun 2026
28 May 2026
13 May 2026 - 20 May 2026
| Sl No | Description | Qty | Unit | Est. Rate | Est. Amount |
|---|---|---|---|---|---|
| 2 | Taking down chowkats or frames of any description (wooden / aluminium / steel etc.) not exceeding 1.5 Sqm each with shutters (without taking off shutters from the frames) including making good of disturbed portions of cills / jambs complete all as specified and directed. | 15 | Each | - | - |
| 3 | Taking down chowkats or frames of any description (wooden / aluminium / steel etc.) exceeding 1.5 Sqm but not exceeding 4 Sqm each woth shutters (without taking off shutters from the frames) ncluding making good of disturbed portions of cills / jambs complete all as specified and directed. | 15 | Each | - | - |
| 4 | Taking down shutter of any description (wooden / Aluminium / steel etc.) not exceeding 1 Sqm each complete all as specified and as directed. | 35 | Per Leaf | - | - |
| 5 | Taking down shutter of any description (wooden / Aluminium / steel etc.) exceeding 1 Sqm and not exceeding 2 sqm each complete all as specified and as directed. | 40 | Per Leaf | - | - |
| 6 | Supply and fixing of powder coated aluminium frame for doors, windows, ventilators, partitions, kitchen cupboards etc. (minimum thickness of powder coating not less than 50 micron) with one or more rebates / any profile including joining cleat for fixing etc. complete all as specified and directed. | 350 | Kg | - | - |
| 7 | Supply and fixing Powder coated aluminium door shutters, of any colour (Thickness or powder coating not less than 50 micron), .aluminium section weighing 0.55 kg/m including necessary joining cleats, glazing clips, ruber neoprene packing, handles 2 Nos in each door, hinges, anodised aluminum snap beading screws etc. complete all as specified and directed. | 80 | Sqm | - | - |
| 8 | Supply and fixing Powder coated aluminium window and ventilator shutters fixed or sliding type without sash bar, aluminium section weighing 0.55 kg/m incl necessary joining cleats rubber packing anodised aluminium snap beading screws, lockig arrangement etc. complete all as specified and directed. | 30 | Sqm | - | - |
| 9 | Supply and fixing of Aluminium alloy wire cloth 0.45 mm nominal dia of wire and average width of aperture 1.40mm and fixed with aluminium staples or beading complete all as specified and directed. | 30 | Sqm | - | - |
| 10 | Supply and fixing in repair aluminium alloy wire cloth, 0.45 mm nominal dia of wire and average width of aperture 1.40mm and fixed with aluminium staples or beading complete. | 60 | Sqm | - | - |
| 11 | Hacking out old broken glass (any thickness, size, quality or description) form metal frame including punching or drilling out old glazing pins/spring clips and providing and fixing new ones complete all as specified. | 140 | Sqm | - | - |
stage.html
html • 0.05 MB
tech_bid_open.pdf
tech_eval.pdf
fin_bid_open.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
aoc.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Tendernotice_1.pdf
PDF • 4.81 MB
BOQ_856802.xls
BOQ • 0.94 MB
Tender.pdf
Tender Documents • 1.37 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .