Loading
Loading…
Loading…
Tender Value
₹55.4 L
EMD Value
₹1.1 L
Closing Date
31 Dec 2025, 12:30 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
SRDEEG/SEE
16 conditions · 5 needing a document upload
Contractor should have to be registered with Employee Provident Fund Organization (EPFO). It is mandatory for contractor to submit PF code provided by EPFO with their tender offer. Also each contractor has to submit "UAN" of their worker with their offer and have to mention in tender document. It is mandatory. Otherwise offer will not be considered for further action and your offer will summarily be rejected.
Financial Eligibility Criteria: The tenderer must have minimum average annual contractual turnover of 'V/N' or 'V' whichever is less; where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
As per CE/Works/HJP's letter no. ECR-HQ0ENGG(CONT)/0009/2025, dated 18.11.2025 "The balance sheet and all other financial documents attested/certified by the Chartered Accountant (CA) to substantiate fulfillment of Financial Eligibility Criteria should be with UDIN, failing which the offer shall be considered as incomplete and will be summarily rejected without any further reference."
The tenderer shall posses the valid Electrical Contractor's license and Supervisory License issued by any State/Central Govt. licensing board for the required voltage level or above with their tender paper. Tenders without valid electrical contractor's license & Supervisory license will summarily be rejected.
"ELIGIBILITY CRITERIA:- Document required to be submitted in support of Technical Eligibility Criteria: Tenderer should have completed at least one similar single work. The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or One similar work costing not less than the amount equal to 60% of advertised value of the tender. Similar nature of works (as defined and approved by competent authority) for " Improvement of pumping installation in SEE Divn. (SEE, HJP, MFP, BJU, GHZ, BGS, KGG, NNA)." is (1). Installation and commissioning of various types of water pumping installation of capacity 10,000 GPH and above. OR (2). Supply, installation and commissioning of water pumping installation of capacity 10,000 GPH and above.
25 conditions · 4 needing a document upload
The tenderers whether sole proprietor , a limited company or a partnership firm he/they should submit authentic proof in terms of partnership deed, proprietorship documents etc. along with the tender. If he/they want to act through agent or individual partners should submit a power of attorney duly stamped and authenticated by Notary Public or by Magistrate in favour of specific person whether he/she/they are partners of the firm or any other person specifically authorizing him/her name to submit the tender, sign the agreement , receive money, witness measurements, sign measurement books , compromise, settie, relinquish any claims, preferred by firm and also sign No Claim Certificate and refer all or any disputes arbitration.
Contractor should have to be registered with Employee Provident Fund Organization (EPFO). It is mandatory for contractor to submit PF code provided by EPFO with their tender offer. Also each contractor have to submit "UAN" of their worker with their offer and have to mention in tender document. It is mandatory. Otherwise offer will not be considered for further action and your offer will be summerisely rejected. You are also instructed to submit monthly payment challan to the person/labour engaged for execution of the work having valid UAN no with bill. This is to be followed strictly as per GCC & as per instruction of labour enforcement officer under Govt of India.
Inclusion of 'Letter of Credit' as Mode of Payment in Works Tenders or Service Tenders as per Railway Board's letter no. 2018/CE-I/CT/9 dated 04.06.2016 remarks from Tenderer required.
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
Rates are inclusive of all taxes/GST, license fee, royalty charges etc. legally leviable by State, Central Govt. and/or any other local authority.
Eligibility criteria for works tender in respect of partnership firms:-
in case the tenderer is a partnership firm s , the experience, solvency and turn over shall be in the name and style of the firm only.
If the tenderer is a partnership firm, all the partners shall be jointly and severally liable for successful completion of the work 2.1.1 and no request for change on the certification of the firm shall be entertained.
During the currency of the contract, no partner of the firm shall be permitted to withdraw from partnership business and in such 2.1.2 and event it shall be treated as breach of trust and abandonment of the contract.
Improvement of pumping installation in SEE Divn. (SEE, HJP, MFP, BJU, GHZ, BGS, KGG, NNA).
L-Open-25-26-18Dt09-12-25~ECR
L-Open-25-26-18Dt09-12-25
Open
Works - General
180 Days
Saran, Bihar
₹0
₹1.1 L
31 Dec 2025
9 Dec 2025
17 Dec 2025
27 items across 1 schedule
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| — | — | — | 55,39,588.6 | ||
| — | 17.00 | — | — | ||
| Supply & delivery of Submersible pumping set of 1520 LPM/20000GPH capacity at 46 mtrs. head complete with wet winding type 3 phase,2980RPM, 415 volt 50 Hz., 25 HP squirrel cage induction motor, with 18 mtrs. Class 'C' type (Heavy gauge) 5.4mm thick raising main pipe (column pipe with flange type) 150mm dia with nuts & bolts , one No. pressure gauge complete with cocks etc., airline complete with depth gauge and other fittings, water level guard complete 01 No., 45-50 mtrs. flexible 2x3 cores 6Sq.mm copper conductor flat cable, cable clips 125mm 12 Nos., supporting clamp 125mm 2 pairs, reflux/non return valve 01 No., Sluice valve - 01 No., and for water level guard 01 set complete with all spares and accessories etc as required as per CEE's specification No. CEE/Submersible pump/48/Rev.-V of Aug.'2001. Make:-KSB/Crompton Greave/Kirloskar Brothers Ltd./WPI. | — | — | — | 18,95,877.74 | |
| — | 17.00 | — | — | ||
| Installation, testing & commissioning of submersible pumping (25HP)set with control panel of 1520 LPM capacity complete with supply & fixing of necessary fixing arrangement including connection earthing the control panel etc. as required as per instruction of site in-charge. | — | — | — | 1,84,212 | |
| — | 17.00 | — | — | ||
| Supply & installation of Submersible Pump Controller(up to 30 HP) in sheet enclosure for motor protection & pump management system complete with CTs, earth fault, Voltmeter, Ammeter, selector switches, indication lamps etc. of L&T Cat No.CS96008 MU-G-30 fully automatic stat delta starter with salient features and benefits of sub-mersible pump controller. Conforms to IS/IEC 60947-4-1 & IEC 60947-4-1., Protections Offered - Overload, Single phasing, Phase reversal, Phase imbalance., Auto Restart Feature., Vibration proof enclosure with IP54 protection class., Indications offered - ON/OFF, Voltage and Ampere. & Compatible with M-POWER. Make:- Minilec/L&T/Siemens/BCH/ABB. | — | — | — | 3,86,742.86 | |
| — | 10.00 | — | — | ||
| Supply of 5 star energy efficient submersible pump 1333 LPM against52/54 mtr. Head complete with bowl assembly & motor 20HP suitable to work on AC three phase supply, water column PVC flat cable (3x10Sq.mm. 80meters) etc. motor along with 30meters heavy duty black steel pipe in 3 mtrs. places 4" dia. with welded flanged ( Six hole ) 02 nos. clamp sluice valve - 1 nos , NRV - 1 nos. , pressure gauges, CI bend 90 degree 4 '' dia 01 no. Distance piece 1 metre long one side thread other side welded Flange (six hole ) MS nut Bolt complete in all respect . Made of submersible Pump : KSB , snac, Falcon, Lic, CRL Pipe , Make of cable Havels, Plazza, Finolex, Polycab, Make of Black steel Pipe , Tata , Jindal, Bansal inspection by consignee. | — | — | — | 15,10,080 | |
| — | 10.00 | — | — | ||
| Supply/Fixing, testing, and commissioning of LT panel board of size 4 'x 3' 16 SWG MS sheet suitable to operate Submersible pump consisting of MCCB 4 pole of 100 Amp. capacity with enclosure 01 no. fully automatic star Delta Starter ML 2- 01 no. Single phase preventer - 01 Nos. , Voltmeter - 0-500 volt 01 W, Ammeter 0-6 Amp - 01 Nos. , Indicator LED bases 04 nos. make of MCCB Siemens , Havels , L& T Make of starter , L& T Siemens , Make of changeover switch ; L& T Siemens. | — | — | — | 1,98,440 | |
| — | 10.00 | — | — | ||
| Installation, erection, testing and commissioning of submersible pump set (20HP) 1140 LMP capacity complete with all accessories including electrical connection and supply of all suitable/required material in connection with installation of pump. | — | — | — | 47,200 | |
| — | 8.00 | — | — | ||
| Supply of submersible pump motor set discharge capacity 50000 LPH at 49 mtrs. head with motor rating 12.5/15 HP suitable for 415 volt,3 phase 50 Hz, complete with all accessories spares and tool (such as chain wrench pipe wrench allein keys double ended spanners of taparia make required for subject pump) make:- KSB (model no:- BPOB302/6 + uma 11509/22) or other similar make kirloskar brothers ltd , jyoti .inspection by consignee will be done before supply of pump. | — | — | — | 4,25,920 | |
| — | 8.00 | — | — | ||
| Installation, testing, commissioning and supply of 12.5/15 HP automatic star delta submersible pump controller three phase max. operating current 135% (A) 25.31A, OLR (A) : 13.2A- 20A, contractor:20A including all accessories as per site requirement. | — | — | — | 99,048 | |
| — | 10.00 | — | — | ||
| Installation, erection, testing, commissioning and supply of 02 HP submersible Pump Set complete, no. of stage:6, outlet size(mm):65, Head range(m): 10-30, Discharge range(LPM): 420- 100 with all accessories as per site requirement including required material in connection with installation of pump. Similar to Crompton rating 4W6BR2D (I)-65. Make Crompton, KSB, Kriloskar. | — | — | — | 2,85,560 | |
| — | 10.00 | — | — | ||
| Installation testing commissioning and supply of 2 HP submersible pump controller single phase overload relay (A): 13.2A-20A, contractor 20A including all accessories as per site requirement. | — | — | — | 55,180 | |
| — | 1340.00 | — | — | ||
| Supply of flat 3 core PVC insulated & PVC sheathed industrial copper cable for Sub- mersible Pump Motors 3 core 10 sq.mm 1100 volt grade confirming to IS:694. Make - Crystal, Polycab, M.P. Cab, Anchor, Havells. | — | — | — | 3,63,140 | |
| — | 44.00 | — | — | ||
| Earthing with perforated G.I. earth pipe 4.5 mtrs. Longx40mm dia with minimum 3.25mm thick including accessories and providing masonry enclosure on top with cover plate having locking arrangement and watering pipe including supply & using salt and charcoal for pipe earth electrode complete as per Genl. Spec. of elect. Work & drawing etc. as required. so that the earth resistance value should be within 2 Ohms. Make of GI pipe TATA/Jindal or equivalent superior make. | — | — | — | 77,748 | |
| — | 870.00 | — | — | ||
| Supply & laying of 6SWG G.I. wire at 0.5 mtrs. below ground level for conductor earth electrode including soldering/fastening with G.I. nuts & bolt complete etc. as required. | — | — | — | 10,440 |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .