Pro.No. 347 2023-24 Solid waste management project at Govt Ayurveda hospital in Kodakara GP

Amount

Solid waste management

2.8.1:Earth work in excavation by mechanical means (Hydraulic excavator) /manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m.All kinds of soil

4.1.8:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:4:8 (1 cement : 4 coarse sand : 8 graded stone aggregate 40 nominal size)

4.1.3:Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level:1:2:4 (cement : 2 coarse sand (zone-III) : 4 graded stone aggregate 20 mm nominal size)

5.9.1:Centering and shuttering including strutting, etc. and removal of form for:Foundations, footings, bases of columns, etc for mass concrete

50.6.1.4:Solid block masonry using pre cast solid blocks (Factory made) of size 30x20x20cm or nearest available size confirming to IS 2185 part I of 1979 for foundation and plinth with thickness 20cm and above in: CM 1:6 ( 1 cement : 6 coarse sand ) etc complete

50.10.1:Steel work in built up G I tubular ( round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting,fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete

50.10.2:Steel work for purlin/single section with G I pipes including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete

OD374741/2023-2024:Providing and fixing precoated galvanised iron profile sheets (size,shape and pitch of corrugation as approved by Engineer -in -charge)0.35 mm (+0.05%),total coated thickness with zinc coating 120grams per sqm as per IS:277 ,IN 240 mpa steel grade ,5-7 microns epoxy primer on both side.of the sheet and polyester top coat 15-18 microns.sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length up to 12m or as desired by Engineer - in -charge.The sheet shall be fixed using self drilling /self tapping screws of size (5.5x55mm) with EPDM seal complete up to any pitch in horizontal/vertical or curved surfaces,excluding the cost of purlind,rafters and trusses and including cutting to size and shape wherever required.

JIJUVP

Bidder Name

JIJUVP

SIJON NELLIPPILLY