Repair and Maintenance work in Quarter Type-IV/B-1 alloted to Dr. Sindhu Poudhyal

14.20 Dismantling tile work in floors and roofs laid in cement mortar including stacking material within 50 metres lead. 15.20.1 For thickness of tiles 10 mm to 25 mm

17.30 Chipping of unsound/weak concrete material from slabs, beams, columns etc. with manual Chisel and/ or by standard power driven percussion type or of approved make including tapering of all edges, making square shoulders of cavities including cleaning the exposed concrete surface and reinforcement with wire brushes etc. and disposal of debris for all lead and lifts all complete as per direction of Engineer-In-Charge17.30.3 25 mm average thickness

10.42 Providing and laying 1st class quality vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to IS: 15622- 2017, of approved make, in all colours and shades, laid over 20mm thick cement mortar 1:4 (1 cement : 4 fine sand), jointing with grey cement slurry @ 3.3 kg/ sqm including grouting the joints with white cement and matching pigments etc. all complete as per direction of the Engineer-in-charge. 10.42.1 Soluble Salt Stainfree vitrified tiles (Glossy) 10.42.1.1 Size of tile 600 mm x 600 mm

10.40 Providing and fixing 1st class quality ceramic glazed wall tiles conforming to IS : 15622- 2017 (thickness to be specified by the manufacturer) of approved make in all colours, shades of any size as approved by Engineer-in charge in skirting, risers of steps and dados, laid over 12 mm thick bed of cement mortar 1 : 3 (1 cement : 3 fine sand) jointed with ordinary cement slurry including pointing with white cement mixed with pigment of matching shade etc. all complete as per direction of the Engineer in-charge.10.40.2 600 mm X 300 mm in all shades and design

12.35 Distempering with 1st quality acrylic distemper (ready mixed) having VOC content less than 50 grams/ litre, of approved brand and manufacture to give an even shade [Payment shall be made after submission of Test Certificate issued by the Manufacturer] : 12.35.1 New work ( two or more coats) over and including water thinnable priming coat with cement primer.

19.53 Providing and fixing C.P. brass angle valve for basin mixer and geyser points of approved quality conforming to IS:8931 19.53.1 15 mm nominal bore

19.52 Providing and fixing C.P. brass stop cock (concealed) of standard design and of approved make conforming to IS:8931. 19.52.1 15 mm nominal bore.

DISMANTLING CUBOARD AND RACKS NAD DISPOSAL

PROVIDING AND FIXING COMMODE COVER

Providing and fixing 600x450 mm bevelled edge mirror of superior glass (of approved quality) complete with 6 mmthick hard board ground fixed to wooden cleats with C.P. brass screws and washers complete.