Loading
Loading…
Loading…
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹5.3 LAccepted-AOC VILL JARL P O JUGAHAN TEHSIL SUNDERNAGAR DISTT MANDI H P | L1 | Accepted-AOC AOC | |
| 2 | L2₹5.5 L+₹20,352 (3.81%)Rejected-Finance | L2 | Rejected-Finance Reject | |
| 3 | L3₹7.0 L+₹1.7 L (30.9%)Rejected-Finance VILL JADAINEE HATHNI KI DHATO P O BYCHARI VIA TOTU TEHSIL DISTT SHIMLA HP | SHIMLA | HIMACHAL PRADESH | 171001 | L3 | Rejected-Finance Reject | |
| 4 | L4₹8.1 L+₹2.7 L (51.5%)Rejected-Finance CHAUHAN BUILDING LOWER PANTHAGHATTI SHIMLA | L4 | Rejected-Finance Reject | |
| 5 | Not Admitted-Fee/PreQual/Technical R O VILLAGE KHERI CHANGAN PO KANGTA FELOG TEHSIL DADAHU ST DISTT SIRMOUR HP | - | Not Admitted-Fee/PreQual/Technical Not Complied with technical specification |
Tender Value
₹10.8 L
EMD Value
₹21,580
Closing Date
22 Mar 2024, 11:00 amClosed
Executive Engineer Jal Shakti Division Nahan
Executive Engineer Jal Shakti Division Nahan
Laying, jointing and testing of HDPE pipes of 110 mm dia in distribution system) Job No. 2 under NABARD
2024_HPIPH_88388_4
NHN-SMROO-722- 17501-560 dt 12-03-24
Open Tender
Pipe Laying Works
Item Rate
180 days
Nahan
Please refer Tender documents.
9 documents required · 9 mandatory
₹400
Executive Engineer Jal Shakti Division Nahan
₹21,580
Yes
6 Sept 2024
13 Mar 2024
22 Mar 2024
13 Mar 2024
22 Mar 2024
17 Mar 2024
Amount
Excavation in drain and channels etc in earth work for pipes up to all classification of earthwork such as pick work,jumper work, saturated soil including bailing or pumping out water, blasting soft/hard rock or chiselling soft/hard rock where blasting is prohibited in all lifts including jungle clearance wherever required, trimming & dressing of sides, levelling of beds to correct grade including shoring/struting, planking, timbering & dewatering wherever required stacking the useable /unuseable material/soil seperately & after laying, jointing & testing of pipes, returning the useable soil in trenches in 15 CM layers including consolidating of such deposited layer by ramming & water & then disposing of all surplus excavated soil/unuseable material as directed with in all leads & lift including restoration of un-metalled surfaces to its original condition & including cost of diversion for traffic, night singles, fixing caution boards, crossing over trenches for access to houses, fencing etc. complete in all respects with in all leads & lifts as per directions of the Engineer in Charge.
Laying ,jointing in trenches High Density Polythene Pipes for use for buried watermain line and services and and for water supply /irrigation above ground, both inside and out side building duly ISI marked (IS:4984 -1995 ) as ammended up to date) in the following grade of materials, pressure rating and nominal dia. complete with fitting (Earth work to be measured and paid for separetely )
HDPE Pipe 110 MM Dia. PE 63.PN - 2.50
HDPE Pipe 110 MM Dia. PE 63.PN - 4
HDPE Pipe 110 MM Dia. PE 63.PN - 6
HDPE Pipe 110 MM Dia. PE 63.PN - 8
Providing and Laying ,jointing High Density Polythene Tee's Approved ISI Marked of following dia including all leads,lifts and carriage of material at site and as directed byt the Engineer in Charge.
HDPE Pipe 110 MM Dia. PE 63.PN - 2.50
HDPE Pipe 110 MM Dia. PE 63.PN - 4
HDPE Pipe 110 MM Dia. PE 63.PN - 6
HDPE Pipe 110 MM Dia. PE 63.PN - 8
Providing and Laying ,jointing High Density Polythene Elbow's Approved ISI Marked of following dia including all leads,lifts and carriage of material at site and as directed byt the Engineer in Charge.
HDPE Pipe 110 MM Dia. PE 63.PN - 2.50
HDPE Pipe 110 MM Dia. PE 63.PN - 4
HDPE Pipe 110 MM Dia. PE 63.PN - 6
HDPE Pipe 110 MM Dia. PE 63.PN - 8
Providing and Laying ,jointing High Density Polythene Plug/ Cap's Approved ISI Marked of following dia including all leads,lifts and carriage of material at site and as directed byt the Engineer in Charge.
HDPE Pipe 110 MM Dia. PE 63.PN - 2.50
HDPE Pipe 110 MM Dia. PE 63.PN - 4
HDPE Pipe 110 MM Dia. PE 63.PN - 6
HDPE Pipe 110 MM Dia. PE 63.PN - 8
Providing and Laying ,jointing High Density Polythene Union Approved ISI Marked of following dia including all leads,lifts and carriage of material at site and as directed byt the Engineer in Charge.
HDPE Pipe 110 MM Dia. PE 63.PN - 2.50
HDPE Pipe 110 MM Dia. PE 63.PN - 4
HDPE Pipe 110 MM Dia. PE 63.PN - 6
HDPE Pipe 110 MM Dia. PE 63.PN - 8
tanushree trader
Parmod Kumar Thakur
Dalip Singh
stage.html
html • 0.05 MB
tech_bid_open.pdf
tech_eval.pdf
fin_bid_open.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
aoc.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.04 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .