Loading…
Loading…
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹1.2 LAccepted-Finance | L1 | Accepted-Finance L1 BIdder | |
| 2 | L2₹1.2 L+₹1,437.01 (1.23%)Rejected-Finance | L2 | Rejected-Finance Higher rate than L1 BIdder | |
| 3 | L3₹1.2 L+₹2,605.31 (2.23%)Rejected-Finance 31 BABULBONA ROAD P O P S BERHAMPORE DIST MURSHIDABAD | KOLKATA | WEST BENGAL | 700023 | L3 | Rejected-Finance Higher rate than L1 BIdder |
Tender Value
₹1.2 L
EMD Value
₹2,337
Closing Date
5 Mar 2026, 6:00 pmClosed
Executive Officer, Gayeshpur Municipality
Kataganj, Nadia
Upgradation of ICDS Center at Ward No -15 , Near Pump House within Gayeshpur Municipality Under the Scheme of AMADER PARA AMADER SAMADHAN -Booth No -263, Scheme Id -APAS/01/092/263/0010
2026_MAD_1014753_23
WBMAD/GM/PW/NIT-27/2025-26 Dated 24/02/2026
Open Tender
CIVIL WORKS
Percentage
30 days
Gayeshpur
Please refer Tender documents.
4 documents required · 4 mandatory
₹250
₹2,337
14 Mar 2026
27 Feb 2026
7 Mar 2026
27 Feb 2026
5 Mar 2026
27 Feb 2026
Cleaning and removing stains as far as possible from pedestals and below starues of marble or artificial cast white stone including plasters and ornamental cap and moulding and flowes with No.1No.2 and No.3 stone as necessary.PWD Building Works schedule, Page- 232, Item - 4
Removing loose scales, blisters etc. from old painted surface and thoroughly smoothening the surface to make the same suitable for receiving fresh coat of paint.PWD Building Works schedule, Page- 203, Item - 1
OrdinaryCement concrete (mix 1:2:4) with graded stone chips (20mm nominal size)excludingshutteringandreinforcement,ifany, ingroundfloor as per relevant IS codes, a) Pakur Variety PWD Building Works schedule, Page -24 , Item no- 4
Plaster (to wall, floor, ceiling etc.) with sand and cement mortar including rounding off or chamfering corners as directed and raking out joints including throating, nosing and drip course, scaffolding/staging where necessary (Ground floor).[Excluding cost of chipping over concrete surface]PWD Building Works schedule, Page -189 , Item no- 1 (ii)b With 1:4 cement mortar, (b) 15 mm thick plaster, Rate Analysis Page 3 out 11
Neat cement punning about 15mm thick in wall, dado, window sill, floor etc. NOTE:Cement 0.152 cu.m per100 sq.m. PWD Building Works schedule, Page -192 , Item no- 15
Applying Interior grade Acrylic Primer of approved quality and brand on plastered or cencrete surface old or new surface to receive Distemper/ Acrylic emulsion paint including scraping and preparing the surface throughly, complete as per manufacturer's specification and as per direction of the EIC. (In Ground Floor). PWD Building Works schedule, Page- 195, Item - 7 b(i)Water based interior grade Acrylic Primer
Acrylic Distemper to interior wall, ceiling with a coat of solvent based interior grade acrylic primer (as per manufacturer's specification) including cleaning and smoothning of surface. Two Coats, PWD Building Works schedule, Page- 196, Item - 10, Item - 1, Vol-I w.e.f. 1.11.2017
Wood work in door and window frame fitted and fixed in position complete including a protective coat of painting at the contact surface of the frame exluding cost of concrete, Iron Butt Hinges and M.S clamps. (The quantum should be correted upto three decimals). (d) Sal : Local. PWD Building Works schedule, P- 114,Item No. 1
Panel shutters of door and window, as per design (each panel consisting of single plank without joint), including fitting and fixing the same in position but excluding the cost of hinge and other fittings.In ground floor. (In case of non-supply of single plank, penal rate of reduction of 20% will be made) (iii) 35mm thick shutters with 19mm thick panel of size 30 to 45 cm (b) Sishu, Gamar, Champ,Badam,Bhola, Mogra, Hallak. In Groung Floor Building P- 117. Item No.-1
Supplying fitting and fixing P.V.C. door shutter of approved quality & shade in position, the style & rail of the P.V.C. door shutter will be made of rigid P.V.C. multicavity hollow chamber of suitable size and section with 2.0 mm (+/-0.2 mm) wall thickness, the section will have 2nos. built in beads, horizontal & vertical section shall be fixed to each other by self tapping screws and 2 nos. of solid plastic or M.S. tubular galvanised brackets of length 200mmx80mm and other100mmx100mm both 1.20 mm in each corner of the shutter frame for placing hinges. Polymer based multicavity hollow section of 105 mm x37mm with 2.0 mm (+/- 0.2 mm) wall thickness will be fitted in the middle as lock rail reinforced by solid polymer bar of 200 mm long at both ends abd screws from both sides. The section frame will then be fitted in by PVC panels of size 100 mmx20 mm with wall thickness of 1.2 mm (+/- 0.2 mm) and 2 nos. of 6 mm dia and screws from both sides 6mm dia bright rod will be inserted horizontally with both side check and nut system and and stretches where fixing of hinges / hasp bolt / tower bolt / door ring are required to be strong enough to with stand wear and tear. The rate is inclusive of cost of all materials, labour, and hire of tools and plants and appliencies. Carriage of all materials taxes and all other incidental charges complete.The rate is exclusive of cost of hinges, hasp bolt, tower bolt,door ring etc. In ground floor. Building P -134,It No.- 26
stage.html
html • 0.04 MB
tech_bid_open.pdf
tech_eval.pdf
fin_bid_open.pdf
boq_comp_chart.xlsx
xlsx
fin_eval.pdf
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
html • 0.03 MB
Tendernotice_1.pdf
PDF • 1.59 MB
BOQ_2493231.xls
BOQ • 0.30 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .