Construction of fitness center

CONSTRUCTION OF BUILDING

50.6.1.4:Solid block masonry using pre cast solid blocks (Factory made) of size 30x20x20cm or nearest available size confirming to IS 2185 part I of 1979 for foundation and plinth with thickness 20cm and above in: CM 1:6 ( 1 cement : 6 coarse sand ) etc complete

10.16.1:Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.Hot finished welded type tubes

10.1:Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

OD113754/2025-2026:Proviing and fixing precoated galvanisediron profile sheets (size, shape and pitch corrugation as approved by Engineer - in - charge ) 0.35 mm (+0.05%), total coated thickness with zinc coating120 grams as per IS 277,in 240 mpa steel grade 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer - in -charge. The sheet shall be fixed using self drilling/ self tapping screws of size (5.5 x55 mm) with EPDM seal, complete up to any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and includingcutting of size and shape wherever required.

OD113834/2025-2026:supplying and fixing 150mm inner PVC square cut section with brackets at the end of sheet or tiled roof for rain water