Thanthoni Block - MLACDS-2024-25-Construction of Communitty hall at Karunaliyagounder H/O Jegathabi Panchayat

Amount

Earth work excavation for foundation in all clauses of soils and sub soils to full depth as may be directed except in hard rock requiring blasting but inclusive of shoring strutting and boiling out water whenever necessary et complete complying with stand

Supplying and filling in foundation and basement with filling excavated earth in larges of not more than 15 cm thick well rammed watered and compacted including & conveyance and all labour charges etc.,

Cement concrete 1:4:8 mix ( one cement four sand and eight aggregate)using 40mm gauge hand broken granite tone jelly for foundation including dewatering if found ecessary and laid in layers of not more than 15 cm thick and compacted,etc., complete comply

Brick work in cm 1:5 mix(one cement and five sand )using country bricks ground maded of size 23 x 11 x 7 cm including curing,finishing and cost & Conveyance of all materials etc., complete.

Supplying and erecting centering for sides Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X and B.G 10 stiffened with M.S angles of size 25mm X 25mm X

Supplying fabricating and placing in position of ribbed steel rods for reinforcement to all RCC works as per the design given including cost of steel and binding wire also in all floors etc., complete

RCC 1: 1/2 :3 mix using 20 mm ISS HBG metal for RCC items of work excluding items of works excluding centering,shuttering, and ost of reinforcement grill ,out including curing etc complete and also including fixing fan clamps and ixtures in rcc works wh

Supplying and painting the walls with two coats of wall putty as instructed by the 8 departmental officers including preparation of surface curing, etc., complete in all floors complying with standard specifications (The wall putty shall be got

Plastering with cm 1:5 mix(one cement and five sand) to 12 mm thick including cost and conveyance of all materials in all floors etc. as directed by departmental officers etc, complete complying with standard specifications.

Paving the floor with best quality Vertified Tiles of size 600 x 600 x 8mm of approved colour, shade and quality laid in cement mortar 1.3 (one cement and three crushed stone M.Sand) 20mm thick in all floors and the top pointed with the white cement mixed same colour pigments etc., complete complying with standard specification. (The make and brand of the tiles should be got approved by Executive Engineer before use on works)

Providing weathering course with best quality of brick Jelly 20mm gauge in 11 pure slaked lime (no sand to be added) over roof slab, the proportion of brick jelly to lime being '32 to 12.5 well beated with wooden beaters for giving required

Finishing top roof mix one course machine pressed tiles of size 20 cm x 20 cm x 2 cm approved qty with, CM. 1:3 12 mm thick mixed with WPC at 2% by weight of cement used and top pointed with the same mortar etc

Distembering including cost & conveyance to size and all labour charges etc., complete. bering two coats of oil bound distember using one coat of primer coat

Painting two coats with ready mixed Exterior Emulsion paint of approved 14 qualityand colour over a priming coat, including through scrapping, clean removel of dirt etc complete

Painting two coats of new iron work with best quality synthetic enamel paint of approved quality and colour with priming coat including the cost all materials etc.,complete, in all floors.

Manufacturing supplying and fixing of steel door with the following specification MS angels of size 40x40x6mm are used for the outer frames and M.S. angles of size 35x35x5mm for the shutter frames stiffeners with 32 x 6mm M.S flat is provided at required intervals in the shutter frame. 18-gauge C.R. sheet laid as panel in the shutter and welded intact. M.S. flat 18x5mm is welded over the 32 x 6mm M.S. flat

Fabricating Supply and fixing and position of MS Shutter with single leave. The door outer frame will be 40x40x6mm MS angle, the shutter frame will be 35x35x6 mm, MS angle intermediate stiffner will be 35x35x6 mm with cross stiffner 25x 25x5 mm flats covere

Wiringwith2x1.5sq.mm.PVCinsulatedSCunsheathed FRLScopperconductor of1100Vgradeinsuitable PVCrigidpipeonwallandcellingwithPVCaccessoriesa ndwith TWswitchboxand5AFTswitchwith paintingofsuitablecolourfor open PVC light point/fan point (for electronic regulator) (4 points per coil) SD 17

Wiringwith2x1.5sq.mmPVCinsulatedSCunsheathed FRLScopperconductoro. 1100Vgradeinsuitable PVCrigidpipeonwallandceilingwithPVCaccessorieswi th150x100x113mmTWswitchboxfor5A3pinnoninterlocking Wallsocketwith5A flushtypeswitchwithpaintingofsuitablecolourwithcontinuousearthwireconn ectionof1.5sq.mm copper wire for open PVC plug point SD 36

Supplyandfixingof1200mm(48") ACceilingfancompletewithsteppedelectroni 20 c300Wregulatorwith1meterdownrod on the existing clamp SD 107

Supplyandfixingofsingleboxtype4'36Wfluorescentfittingcompletewithelectr 21 onicballastwith TWroundblocksonwall or ceiling with flu tube with PVC unsheathed FRLS Copper leads from terminals to the fitting

Supply and Run of 2 of 10 sq.mm PVC insulated SC unsheathed FRLS 22 copper conductor of 1100 V grade on 7/20 Gi wire for service connection mains SD 364 service connection mains SD 364

GST Amount for providing Service to Government Contract Works for the above ConstructionWorks. GST Amount is the Total GST Amount for overall quoted amount above this row in column "BB" for all works in this package} (Refer Clause 13.2 & 13.3 of Section 2 of Instruction to Bidders (ITB) of SBD)

P THANNASI (BID ID -1433871)