CONS. OF STORM WATER DRAIN IN WARD 03

CONSTRUCTION OF STROM WATER DRAIN FROM RAJIB GHOSH'S HOUSE TO AMIT TOPADAR'S HOUSE IN WARD NO 03

Earth work on excavation of foundation tranches or drains , in all aorts of soil (including mixed soil but excluding laterite or sandstone) including remocing , spreading or stacking the spolis within a lead of 75 m. as directed. the item including necessary trimming the sides of trenches , levelling , dressing and ramming the bottom , bailing out water as required complete. (a) Depth of excavation not exceesing 1,500 mm. P-1 , It-2(a)

Earth work in filling in foundation trenches or plinth with good earth , in layers not exceeding 150 mm. including watering and ramming etc. layer by layer complete. (Payment to be made on the basis of measurement of finished quantity of work). (a) With earth obtained from excavation of foundation. P-1 , It-3(a)

Single brick flat soling of picked jhama bricks including ramming and dressing bed P-14 , It-1 100M*0.80M

Ordinary cement concrete with graded stone ballast (40 mm size) excld. Shuttering (a)1:3:6 proportion P-34 , It-22 (a)

Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes. (i) Pakur Variety Rate Analysis Enclosed In Ground Floor

Hire and labour charges for shuttering with centreing and necessary staging upto 4 m. using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams, columns, lintels curved or straight including fitting, fixing and striking out after completion of works. (upto roof of ground floor). (When the height of a particular floor is more than 4 m. the equivalent floor ht. shall be taken as 4 m. and extra for works beyond the initial 4 m. ht. shall be allowed under 12(e) for every 4 m. or part thereof.) SOR, PWD, P-42, I-36 P-42 , It-36(a)

Reinforcements for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc. including supply of rods, initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16G black annealed wire at every inter-section, complete as per drawing and direction. III) Other manufacture Rate Analysis Enclosed P-44 , It-40(a)